静态工作点

合理的设置偏置电路，使Doherty功率放大器具有合适的静态工作点。

Set reasonable Doherty power amplifier bias circuit to ensure a suitable quiescent point .

放大电路中静态工作点与动态参数的关系

Relation between Quiescent Point and Dynamics Parameter in Amplifier

引用晶体管静态工作点与h参数的关系曲线，分析了静态参量IC、VCE对振荡电路频率稳定、起振、振荡频率的影响。

The relation curve of static working point and parameter h is introduced in this paper .

MOSFET放大电路静态工作点的分析及参数选择

Analysis of the quiescent operating point and selection of the parameters in the MOSFET amplifier circuits

晶体三极管变频器的静态工作点

The Best Static Working - Point of the Transistor Transducer

放大器最大动态范围静态工作点的确定

Determination of Amplifiers Quiescent Point Providing Maximum Dynamic Range

射极偏置电路静态工作点的计算

The Calculation for Quiescent Point of Emitter Bias Circuit

圆锥电磁轴承静态工作点的规划与可行域分析

Planning and feasible region analysis of static operation points of conical magnetic bearings

单管放大器静态工作点对输入信号的影响

The Effect of Static Operating Point For Basic Transistor Amplifier on Input Signals

对放大电路静态工作点测量的分析

Analysis of measuring static work point of enlarged circuits

根据静态工作点的作用，以几种类型的放大电路为例，利用近似估算法和图解法对放大电路静态工作点进行定量分析，方法简单，易于掌握。

Analyse the effect of the static working point in the amplifier circuit .

静态工作点的简便算法

The Effect and Computation of the Static Working Point

关于电压放大电路静态工作点稳定性的定量分析

Quantitative Analysis with Quiescent Point Stabilization of Voltage Amplifier

分析并纠正了放大器静态工作点测量中存在的问题。

A question about the measurement for DC operating point of amplifier is analysed and corrected .

基于静态工作点前馈补偿的负载口独立控制系统

Feedforward Compensation Controlling Based on Static Operation Points in the System with Separate Control of Actuator Ports

对电光晶体器件设计、静态工作点控制、光束整形系统等关键技术进行了深入的研究。

The key technologies which conclude the designation of electro-optic crystal cell , confirmation of quiescent opera .

我们选用了对应于静态工作点高、低电压的两个不同的脉冲幅度。

Two different pulse amplitudes corresponding to the high and low voltages about the quiescent point were chosen .

温度对三极管的性能影响较大，使得电路中的静态工作点出现不稳定现象。

The temperature had great effect to the triodes performance and made the quiescent operation point in circuitry unstable .

负载口独立控制系统静态工作点选取原则及仿真分析

Principles for choosing static operation points and simulation analysis of fluid power system based on separate control of actuator ports

对磁力轴承的几个基本特性进行了分析，包括静态工作点、最大承载力、功率损耗等；

Basic characters of magnetic bearings are analyzed , including static working point , the largest magnetic force and power losses etc.

第三级功率级采用简单的单端功率放大的形式，根据所要达到的设计目标，确定合适静态工作点，保证放大器的输出功率。

Through to achieve the design goal , determine the appropriate static working point , ensuring the output power of the amplifier .

支撑刚度参数的识别值在静态工作点附近具有较高的精度，说明该电磁支撑可以实现机械系统变刚度支撑。

The electromagnetic support stiffness and additional damping parameters of the cantilever beam system with parallel electromagnetic and mechanical support were identified .

临界工作段控制部分研究了如何将临界工作线上的状态点推向静态工作点；

In the part of critical work controlling , the paper study how to push the state point to static work point ;

该文通过变量替换对圆锥电磁轴承静态工作点计算的非线性模型作线性化处理；

Firstly , the nonlinear model by which the static operation points are calculated is linearized by using variable replacement in this paper .

由非齐次线性方程组解的结构给出静态工作点的基础解；

Then , the basic solution set of conical magnetic bearing static operation points is given based on the solution structure of linear equation group .

磁浮列车的悬浮静态工作点与承载重量有关，因此对悬浮控制器的设计提出了更高的要求。

The operating point of the maglev train is concerned with its load , and so the design of the maglev controller has to meet this requirement .

本文通过对外部环境参量的检测和内部状态变量的反馈来确定其能量最优的静态工作点以及相应的最优控制算法。

This paper figures out the optimum static state work point and optimum control algorithm , through detecting the external environment parameter and internal state variable feedback .

仿真发现，由于分布参数的作用，功率器件内部各单元的静态工作点分散较大，工作状态很不均匀，导致其各种性能的恶化。

Simulation found that , because of the parasitic elements , the Quasi-static work points of different unites within power device spread greatly , resulting in the deterioration of its performance .

由于轴承轴、径向的耦合及磁力的非线性，对于圆锥电磁轴承静态工作点的非线性计算一直缺少普遍适用的方法。

Because of the coupling effects between axial and radial directions and the nonlinear characteristics of the magnetic force , there , are no general methods to calculate the static operation points up to now .

最后给出了恒功率负载和光伏阵列模拟装置的不同静态工作点和动态响应的输出波形，证明了本文所阐述的模拟装置的设计方法是可行的。

In the end , output waveforms of constant power load and photovoltaic array simulation in different quiescent point and dynamic response experiment was showed . Experimental result validates the feasible of design methed in this thesis .