铁合金

论述了加入WTO后铁合金行业面临的机遇和挑战。

The article describes that the ferroalloy trade faced opportunity and challenge .

铁合金矿热炉CO泄漏点的自控检测及报警系统

Automatic Monitor and Alarm System for Carbon Monoxide Leaking from Ferroalloy Furnace

X射线荧光分析铁合金试样的制备方法

Method of analyzing ferro-alloy test piece by fluorescent X-ray

Fe含量对快凝铝铁合金凝固过程的影响

Effect of Fe contents on solidification process of melt spun Al Fe alloys

铁合金矿热电炉PLC简易控制器

Simple PLC controller for ferroalloys submerged arc furnace

铁合金企业实施ERP管理模式的研究与探讨

Research and study about implementing ERP management at ferroalloy enterprises

钛铁合金中Si分析方法的改进

Improvement of Si Analysis Method in Ferrotitanium Alloy

铁合金生产中的灰色GM（1，1）模型

Grey gm ( 1,1 ) model in ferroalloy burdening

三点式PI电极调节器在铁合金炉上的应用

The application of the Three Pot type PI electrode regulators to ferroalloy furnace

ICP-AES测定镝铁合金中的铁含量

Determination of Fe Content in the Dy-Fe Alloy by ICP-AES

IPC在铁合金电炉配料系统中的应用

The application of IPC to burden system in ferroalloy electric furnace

针对中国铁合金行业的现状，根据WTO的贸易规则，提出我国铁合金界入世后应采取的对策。

In view of Chinese ferroalloy industrial situation , according to the trading principle , the countermeasures to be taking after joining WTO are put forward .

铁合金控制系统改造，采用了SiemensS7&400PLC（可编程控制器），改善了控制系统落后的状况，增强了系统功能。

Using the SIEMENS S7 - 400 PLC in ferroalloy system , the control system was improved .

ICP-MS法测定镝铁合金中钨的测量结果的不确定度评定

On the Uncertainty of Tungsten Value in Ds-ferroalloy by ICP-MS

Sc、Zr、Ti复合合金化对过共晶铝铁合金组织及性能的影响

The Effects of Sc , Zr and Ti Combination Alloying on the Microstructure and Mechanical Properties of Hypereutectic Al-Fe Alloy

将钨渣铁合金应用于铸铁中研制出含W、Mn、Nb、Ta的钨渣合金耐磨铸铁。

Ear-resistance cast iron with W , Mn , Nb , Ta has been developed when alloyed by melting sludge of Tungsten .

AOD炉在铁合金冶炼过程中，经常发生喷溅。

The frequent splashes take place in an AOD furnace in the ferroalloy smelting process .

热力学实验模型是在FeC熔液中加入钛铁合金（Ti，Fe）和纯铝块，继续加热到1600℃，熔液经过充分混合、反应后随炉冷却到常温。

The thermodynamics model is established on the fact that pieces of Ti-Fe alloy and pure Al are added into the Fe-C melt and heated up to 1600 ℃, then frozen to room temperature in the furnace after complete mixing and reaction .

着重介绍了西门子MM440变频器、S7-300PLC在攀钢集团特种铁合金公司空压机站改造中的应用情况。

This paper highlights the transform principles and applications of Siemens MM440 transducer , S7-300PLC used in the air-compressor station of Pangang Group Beihai special ferroalloy company .

滴定法在铁合金矿物分析中的应用

The Application of Titration in Analyzing the Ferroalloy and Related Minerals

锰系铁合金现状和发展趋势探讨

Discussion on present situation and development trend of manganese series ferroalloys

浅谈铁合金配料计算软件的开发

Simple description on development in burden calculation software for ferroalloys manufacture

铁合金代用材料开发的热力学分析

Thermodynamic analysis of using metal oxide as a substitute for ferroalloys

晶粒取向镍-铁合金的矩形磁滞回线

The rectangular hysteresis loop of grain oriented nickel - iron alloy

铁合金烟气治理及硅微粉的回收利用

Gas control and recovery and utilization of microspheric silica of ferro-silicon

跳汰法回收铁合金炉渣中合金

Recovery of metal entrained in slag from ferroalloy manufacture by jigging

这对铁合金工业企业很有参考价值。

It is of reference value to domestic ferroalloy industrial enterprises .

浅论铁合金电炉的经济负荷运行

Simply Discussion on economical load operation of the ferroalloy electric furnace

锰系铁合金中锰与铁的联合测定

Combined determination of manganese and iron in a manganese ferroalloy

铁合金炉上料微机控制系统

A microcomputer system of raw-material control on a ferro-alloy furnace