纯铝

  • 网络ALUMINUM;Pure aluminum;aluminium
纯铝纯铝
  1. 制取了具有[110]对称倾斜晶界的纯铝双晶体,获得了18种不同取向差的纯铝双晶试样。

    Aluminium bicrystal rods with [ 110 ] symmetric tilt boundaries were grown .

  2. Cu元素在纯铝基体中的扩散行为研究

    Investigation of diffusion action of Cu element in pure aluminium substrate

  3. 研究了纯铝在3种(A、B和C)不同等径角挤工艺中的显微组织演化。

    The microstructure evolution of pure aluminum in different equal channel angular pressing ( ECAP ) routes was investigated .

  4. 稀土和Cu对工业纯铝性能的影响

    Effect of rare earth and Cu elements on the performance of industrial aluminium

  5. 分析讨论了RE、Cu元素对工业纯铝性能影响的作用机制。

    The effect mechanism of RE and Cu on industrial aluminium was also discussed .

  6. 纯铝薄膜以其低声阻抗特性被广泛应用于声表面波(SAW)器件的制作。

    Al films are widely used in surface acoustic wave ( SAW ) devices because of their low acoustic impedance .

  7. 微量稀土元素Er对高纯铝再结晶行为的影响

    Effect of Trace Rare-earth Element Er on Recrystallization Behavior of High Pure Aluminum

  8. 强度错配双界面约束条件下纯铝层TEM原位拉伸观察

    In-Situ TEM Tension Observation of Pure Al Sheet Constrained by Bi-Interface with Strength Match

  9. ρ-Al2O3微粉在高纯铝镁浇注料中的应用

    Application of ρ - Al_2O_3 Micropowder in High Purity Aluminium and Magnesium Pouring Matericals

  10. 搅拌摩擦加工铸态L2纯铝组织与性能研究

    Microstructure and properties of friction stir processed as-cast pure aluminum L2

  11. 研究纯铝熔体中的稀土Ce对氧化夹杂含量的影响及其反应机理。

    Effect of Ce in pure aluminum melts on oxidation inclusion content have been investigated .

  12. 微量杂质对高纯铝再结晶影响的MonteCarlo模拟

    Monte carlo simulation of the influence of trace impurities on the recrystallization of high purity Al

  13. 细晶铝锭是采用纯铝的电解设备,通过向铝电解槽中添加TiO2,直接电解生产的晶粒细化的铝锭。

    Grain-refining aluminium ingots are produced by electrolysis , through adding TiO2 into electrolyzing cell .

  14. 往复挤压L2纯铝的组织与性能

    Microstructure and mechanical properties of reciprocating extruded pure Al L2

  15. 屈服应力定义对纯铝L2屈服规律的影响

    Effect of definition of the yield stress on yield rule of pure aluminium L2

  16. 纯铝L2的焊接工艺研究

    Welding Craft of Pure Aluminum L2

  17. 低水泥浇注料中纯铝酸钙水泥和SiO2微粉的老化试验

    Aging experiment of pure calcium aluminate cement and silica fume in low cement castables

  18. ECAP纯铝L2的组织与性能研究

    Study on the Microstructures and Properties of Pure Aluminum L2 Processed by ECAP

  19. 累积叠轧焊对L2纯铝力学性能影响的研究

    Study of accumulative roll bonding ( ARB ) process effect on mechanical properties of L2 pure aluminum

  20. 热浸渗层由镀层(表层)和化合物层(内层)两层组成,金相和X射线能谱分析(EDS)结果表明纯铝渗层的化合物层呈厚齿状,由η相(Fe2Al5)组成;

    The hot dip aluminized layer was composed of coating ( surface layer ) and compound ( inner layer ) .

  21. 电火花-直读光谱法测定纯铝薄板中的Fe、Si、Cu、Mn、Mg、Ti、Zn

    Determination of Iron , Silicon , Copper , Manganese , Magnesium , Titanium and Zinc in Pure Aluminum Sheets by Electric Spark Direct Reading Spectrometry

  22. 裂尖三轴应力约束及最大拉应力水平随载荷增加或纯铝层厚度降低而升高,且均随归一化J积分增加沿一特定的路径变化。

    The maximum triaxial constraint and the tensile stress continue to rise with either increasing load or decreasing pure Al thickness .

  23. ECAP条件下纯铝的应变行为模拟研究

    Simulation of Strain / Stress field in ECAP processed pure aluminium

  24. 纯铝(L3)接头的焊接工艺与应用

    Welding technology and application of pure aluminum ( L3 ) joint

  25. 探讨了RE、Cu元素对工业纯铝性能的影响,测试了合金的抗拉强度及导电率。

    The effect of RE and Cu elements on the performance of industrial aluminum was investigated in this paper . The strength and conductivity of the alloys were tested .

  26. 复合材料的延伸率远远低于纯铝,随着SiC颗粒含量的增加,复合材料的延伸率降低。

    The tensile rates of composites are lower than aluminum , along with the increase of SiC particles content , the tensile rates of composites reduce .

  27. 基于纯铝熔体中钠以离子态存在的观点,探讨了Na+在电场作用下的运动状态。

    The action state of Na + has been discussed according to the point of view that sodium in pure aluminium melt exists in ionic state .

  28. 纯铝酸钙水泥作为结合剂用于MgO质浇注料时,浇注料的抗渣渗透性能极差。

    The properties of slag infiltration resistance of MgO based castable became very bad when calcium aluminate cement was used as binder .

  29. ECAP对纯铝拉伸性能和断裂行为影响的研究

    Investigation of Effect of Tensile Property and Fracture Behavior of Pure Aluminum during ECAP

  30. 由此认为,采用FSW法焊接纯铝是常规焊接方法所不能比拟的。

    So fsw method is better than conventional welding methods in welding pure aluminum .