热电偶传感器
- 网络thermocouple sensor
-
液体火箭发动机试验热电偶传感器测量工艺
Measurement technology of thermocouple sensor in the liquid rocket engine test
-
热电偶传感器的教学探讨
Probe into Teaching of Thermocouple Sensor
-
N型热电偶传感器及其应用
The Thermo-element Sensor of type N and its Applications
-
采用敏感的微型K热电偶传感器,准确快捷测量焊咀温度。
Adopted sensitive micro-K thermocouple detector provides quick and accurate temperature measurement of a tip .
-
热电偶传感器测温系统的设计应用
The design and application of thermo-couple sensor temperature measuring system
-
基于模型参考的薄膜热电偶传感器动态误差补偿算法
A Algorithm of the Thin-film Thermocouple Dynamic Error Compensation Based on Model Reference
-
热电偶传感器在半导体生产中的应用及误差分析
Applied Thermocouple Transmitter to the Production of Semiconductor The Intelligent Thermocouple mV Producing Instrument
-
基于神经网络的热电偶传感器的智能信号处理
Neural Network-based Intelligent Signal Processing for Thermocouple Sensor
-
热电偶传感器的温度测试
Temperature Tested by Thermocouple Temperature Transducer
-
介绍一种支持多种工业热电阻和热电偶传感器的两线制温度变送模块。
A design of two-wire temperature transmit module supported lots of thermocouple and resistance thermometer sensors is presented .
-
介绍了热电偶传感器材料的选择和结构的设计以及传感器的例行实验情况,特别是恢复系数和时间常数实验。
The material selection and structural design of the thermocouple sensor and the routine test conditions , especially the recovery factor and time constant experiment are introduced .
-
在设计中介绍了如何使用热电偶传感器对温度进行测量,如何使用变频器控制电机转速。
Introduced in the design how to uses the thermocouple sensor to carry on the survey for the temperature , and how to uses the frequency changer to control the electrical machinery rotational speed .
-
热电偶温度传感器的研究与发展现状
Research and Developing Status on Temperature Sensor of Thermocouple
-
基于遗传算法的热电偶温度传感器非线性模型辨识
Nonlinear model estimation of thermocouple based on genetic algorithm
-
最后将薄膜热电偶温度传感器用于化爆材料模拟切削试验。
At last , TFT are applied to the chemical explosive material simulation cutting test .
-
最后采用薄膜热电偶温度传感器进行铝合金切削试验。
Finally , aluminum cutting tests are carried out with the thin-film thermocouple temperature sensor .
-
对研制的薄膜热电偶温度传感器进行了静态和动态标定,结果表明传感器在0-600℃测温范围内具有很好的线性和热稳定性,而且响应快,时间常数小于0.8ms。
It is concluded that the temperature sensor has good linearity and thermal stability within the temperature range and can response very fast . Its response time is only 0.8 ms.
-
介绍各种热电偶温度传感器的基本工作原理及其信号特点,提出了几种冷端补偿办法,指出了热电偶温度信号线性化规律。
Basic principle and features of signal of thermocouple temperature sensor are introduced , several methods of cold-junction compensation are provided , and the linearization rule of thermocouple temperature signal is released too .
-
方法采用铜-康铜热电偶温度传感器,利用呼吸气流对传感器温度的改变,将温度变化转换为电压信号,经放大处理,获得呼吸频率曲线。
Methods Using copper-constantan thermocouple as the temperature sensor , the change of the temperature on the respiratory tract vent can be transformed into voltage signals . By means of the treatment of amplifier the breath frequency curve of infant can be recorded .
-
热电偶式风速传感器的非线性动态调校量热式集成传感器的热电模拟及实验研究
Heat-Electricity Analogy and Experimental Investigation of Thermal Integrated Sensors
-
热电偶表面温度传感器
Thermocouple surface temperature sensor recording thermocouple pyrometer
-
它采用热电偶作为温度传感器。
It uses temperature Sensor of thermocouple .
-
以热电偶作温度传感器,检测接地故障试验中的温升,证明此方法可行。
A test in which thermocouple was used to measure the temperature rise proved to be feasible .
-
目前大部分的空气预热器热点检测系统都是采用热电偶或红外传感器作为测温元件,将所测温度值与事先设定的报警阈值相比较,以此来判断是否需要报警。
At present , most of the air preheater hot spot detection systems are based on thermocouples or infrared sensors as a temperature measurement device . Compared temperature value with the pre-set alarm threshold to the value as a way to determine whether the need for alarm .
-
发动机缸盖温度监测仪采用热电偶作为缸盖温度传感器,通过冷端补偿电路,RC滤波电路、放大器电路、A/D转换器,最后驱动LED显示器显示测量结果。
This monitoring device uses electric thermal couple as the head temperature sensor by finally actuating the LED displaying the measured results through cold-juncture compensation circuit , RC filter circuit , amplifier circuit and A / D convert .
-
新型薄膜式热电偶切削温度测量传感器
New Type Thin-film Thermocouple Sensor for Cutting Temperature Measurement
-
化爆材料动态切削温度的薄膜热电偶测量原理及传感器研制
Principle and Development of Thin Film Thermocouple Sensor for Measuring Dynamic Cutting Temperature of Chemical Explosive Material
-
根据红外光源的特性设计了稳压调制电路,通过分析比较各种类型的传感器选用热电偶型的红外传感器,并根据传感器的输出特性设计了信号调理电路。
According to the infrared light character , design voltage-stabilized and modulating circuits . Comparing sorts of detectors , choose the infrared detector of thermocouple and design the signal circuits according to the character of detector signals .
-
作者在综合分析前人的实验工作的基础上,建立了以表面热电偶、薄膜热电偶为传感器的瞬态沸腾实验台。
Experiment , the author set up the experimental apparatus of transient boiling using the surface thermocouple and thin-film thermocouple as sensors .
-
所用的热电偶线的准确性决定热电偶传感器的准确度。
The accuracy of the thermocouple sensor is determined by the accuracy of the wire used .