烧结机

烧结机机尾收尘系统的改造

Modification of Dust Collection System at Sinter Machine Discharge and its Results

提高360m~2烧结机料层厚度生产实践

Practice of Increasing the Bed Depth in 360 m ~ 2 Sinter Machine

24平米环式烧结机的PLC控制系统

PLC control system for 24m ~ 2 ring sintering machine

基于VC带式烧结机新型星轮CAD系统开发

The Exploitation of New-type Sinter Chain Sprocket CAD System Based on VC

新一代SD型烧结机

Sd-type sintering machine of new generation

利用Falex试验机建立了评价烧结机润滑脂密封性能的试验方法。

A test method is set up to evaluate seal ability of sintering machine grease with Falex tester .

为了使400m2烧结机生产水平尽快达到一个新的台阶，邯钢就优化400m2烧结机工艺参数进行了实验室研究。

The process parameter of 400 m 2 sinter machine was optimized at Handan Steel .

吉林建龙钢铁公司新建90m~2烧结机装备先进，通过不断调整操作参数摸索出适合其原料条件的技术操作制度，利用系数短时间内达到1.97t/m2·h，作业率达到94.04%。

By continuous adjusting operation parameters of the new-built advanced 90 m2 sintering machine , the technical operation system to fit its raw material conditions is worked out . As the consequence the utilization ratio reaches 1.97t / m2 . h and working ratio 94.04 % in a short time .

邯钢400m~2烧结机系统单辊破碎机BFT柔性传动装置结构分析

Analyzing the structure of BFT flexible gearing of 400 m ~ 2 sintering machine in Handan Iron & Steel Company

GDS-I型电火花烧结机研制

The development of gds-i type spark sintering machine

在实验室条件下，探讨了烧结机扩容对烧结矿中FeO含量及烧结矿的转鼓强度的影响。

Laboratory experiments are carried out in a sintering pot to simulate sintering machine , so that the influence of capacity expansion of sintering machine on the FeO content and drum index of sinter is studied .

韶钢Q345B连铸工艺的优化韶钢105m~2烧结机过程控制系统的设计与应用

Design and application of process control system for 105 m ~ 2 sintering machine in Shaoguan Iron and Steel Co

本文首先对爆炸烧结机制作了简要的分析。然后利用叠加原理建立了对多元粉末激波参数的计算方法，计算了W-Ti二元粉末的激波参数。

In this paper , the mechanism of explosive sintering is studied , and the shock wave parameters of the W-Ti powder compound by the superimposition principle are computed .

研究了涟钢40m2带式烧结机上试生产的酸性球团矿的矿物组成和结构。

Synopsis This paper studies the mineral composition and microstructure of acid pellet produced with a 40 ? m 2 sinter strand at Lianyuan Steel .

介绍了韶钢105m2烧结机过程控制系统的构成及主要控制方式。

Constitution and main control modes of process control system for 105 m ~ 2 sintering machine in Shaoguan Iron & Steel Group Co Ltd are presented .

对酒钢3号烧结机，在酸性小球团烧结矿生产实践过程中所暴露出的烧结负压过高、利用系数低及成品烧结矿中小粒级（5～10mm）含量高等问题进行了分析。

The problems of too higher sintering suction , lower productivity and higher content of small size fractions ( 5 ~ 10mm ) in product sinters , that reflected during Jiu Quan I & S Co. ,№ 3 sinter plant operations for acid MPS production , were analyzed .

本系统已在济钢第二炼铁厂320平方米烧结机上投入了实际运行，使烧结机利用系数提高了0.3t／m2h，终点波动由7%降到3%。年创效益1400多万元。

This system was already put into use in 320 sinter machine of Jinan Iron and Steel Corporation . The system can increase 0.3t/m2h in use coefficient and make BTP fluctuation decrease from 7 percent to 3 percent and bring 14 million RMB new benefits every year .

90m~2烧结机机冷工艺及生产实践

90m ~ 2 sinter machine cooling process and its operation practice

烧结机自动化系统设计及旧系统改造

The sintering machine automatic system design and the old system transform

热煤气在铅烧结机点火炉上的应用

Application of hot gas for lighting-up furnace in lead sintering machine

本钢360m~2烧结机的生产实践

Operating Practice of 360m ~ 2 Sintering Plant in BENXI STEEL

7035烧结机滑道密封润滑脂的研制

Development of Slide - way Sealing Grease 7035 for Sintering Machine

邢钢180m~2烧结机小球烧结工艺技术

Small pellet sintering process with 180 m ~ 2 sintering machine

烧结机边缘效应探讨

Exploration and solution to the edge effect of the sinter strand

400m~2烧结机风箱支管风量控制装置的改造

Modification of Wind Volume Controlling Device of Wind Box Branch Pipe

马钢三铁厂24m~2烧结机取消热筛工艺的设计和实践

24m ~ 2 sinter plant without hot screen design and Practice

烧结机用重锤摆动板式密封装置

Plate seal assembly with heavy swinging hammer in the sinter machine

张店24m~2烧结机高炉煤气点火的应用

Igniting with full BF gas on 24m ~ 2 sintering machine

偶数齿带式烧结机的研究

Research on a Sintering Machine with Even - number Teeth Sprocket

承钢150m~2烧结机布料系统的改进

Improvement on feeding system of Chenggang 150m ~ 2 sintering machine