烧瓦

  • 网络Bush-burning
烧瓦烧瓦
  1. 空压机烧瓦原因分析及经验总结

    Cause analysis and experience summary in relation to bush-burning of an air compressor

  2. 本文根据立式水轮发电机水导弹性金属塑料轴瓦在应用中存在的烧瓦问题,设计出分段月牙楔螺旋承重面的水导弹性金属塑料轴瓦结构,通过现场运行试验,验证了设计的可行性

    In this paper , according to the bush-burning problem in the application of elasto-metal plastic water pilot bearing of the vertical hydraulic generator , the construction of the bearing is designed with multiple crescent wedge spiral bearing camber Results of field test show that the design is practicable

  3. B系列柴油机连杆烧瓦故障分析及对策

    B-Series Diesel Engines Connecting Rod Bearing Scuffing Analysises and Its Solutions

  4. N系列康明斯柴油发动机烧瓦后的修复

    Repair of Burned Journal Bearing of N Series Cummins Engine

  5. 东莞某发电厂两台由ManB&W公司制造的18V40/45型柴油机因烧瓦引起曲轴开裂,导致停机。

    Two type of 18V 40 / 45 diesel engines in one of power plant of Dongguan made by MAN B & W company are damaged due to the crack of the crankshaft which is caused by sinter .

  6. 300MW汽轮发电机振动及烧瓦诊断处理

    Diagnosis Treatment of Vibration & Bearing Pad Burnt-out Happened on 300 MW Steam Generator

  7. 600MW机组汽动给水泵烧瓦原因分析及对策

    Reason analysis of bush burning loss fault of steam-driven feed pump in 600 MW unit and countermeasure

  8. 水电厂的推力轴瓦,已往多采用钨金瓦,它在运行中温度偏高,容易发生烧瓦事故。高位偏E型通风采场瓦斯涌出与运移规律研究

    Usually , tungsten bush is used to be the thrust bearing in water power plant , but it is easy burned down since its high temperature during its operation . Study on Gas Emission and Movement in Mining Space with Quasi E-type Ventilation System

  9. Φ3.8m×13m水泥磨主轴承烧瓦问题的处理

    Dealing with Burning Earthenware of Main Bearing of Φ 3.8 m × 13 m Cement 's Mill

  10. 描述了某电厂600MW汽轮机组轴颈损伤与烧瓦的过程,详细分析了造成这一事故的原因,提出并实施了相应的处理办法。

    The damage and scorching process , that occurred to a 600 MW turbine-generator 's journal is being described and the cause analyzed , together with an explanation of relevant countermeasures taken .

  11. 文章介绍了φ5.5×8.5m球磨机主轴承结构,分析了主轴承烧瓦原因,提出解决办法。

    The paper describes the structure of the main shaft bearing of the φ 5.5 × 8.5m ball mill , analyzes the burn of the main shaft bearing bushing and gives the treatment measures .

  12. 通过矿用自卸车在柴油机大修后间隔不到一年的时间内两次烧瓦事故的实例,叙述WD615柴油机润滑系的正确使用。

    Through two accident illustrations of the mining dump truck after major repair during one year , the proper use for the WD615 series of diesel engine ′ s lubricating system is stated .

  13. 福建省电站锅炉磨制福建无烟煤的8台DTM350/600型球磨机投产后,磨煤机端盖长则5-6a,短则Za,均先后发生了不同程度的开裂并逐步发展,以致引起烧瓦。

    There are ' eight DTM 350 / 600 type tube mills installed in the anthracite-fired power plants of Fujian Province . On the end covers of these mills crackings occurred successively and expanded gradually , resulting is bearing burnt-out , thus seriously affecting tile wale production of power plant .

  14. 一次透平压缩机烧瓦事故分析

    Analysis of an Accident of Turbine Compressor Bushes Burning Out

  15. 车用发动机烧瓦抱轴的分析及预防

    Analysis and Prevention of Burning Tile and Clasping Crank of Vehicle Engines

  16. 重复发生发动机烧瓦事故原因的分析

    Analysis of Repeated Emergence of Engine Bearing Insert Burned Out

  17. 锅炉给水泵电机轴瓦烧瓦事故分析

    Accident Analysis about Deterioration of Motor Bearings Bush of Boiler Feed Pump

  18. 铁道电力机车抱轴轴承烧瓦的原因及对策

    Causes and Countermeasure of Bearing Seizure of Axial Suspending Bearing on Electric Locomotive

  19. 浅议水泥磨烧瓦事故原因及对策

    Cause and Countermeasures on Bush Burnt of Cement Mill

  20. 康明斯柴油机烧瓦抱轴故障原因及预防检修

    The Reasons and Preventive Examination and Repair of Burning

  21. 中速柴油机曲轴轴瓦烧瓦原因分析轴瓦的机械镗削

    A Study on the Sinter of the Bearing Shells of Mid-speed Diesel Engine

  22. 两起膨胀机烧瓦事故原因分析及教训

    Cause analysis of two bush - burning accidents of the turboexpander and relative lessons

  23. 钢球磨煤机烧瓦原因剖析与处理

    The cause analysis and treatment of the bearing burning of the steel ball pulverizer

  24. 300型柴油机烧瓦抱轴的原因分析

    Reasons Analysis of the Bearing Burnt and Journal Sticking of 300 Type Diesel Engine

  25. 512循环机烧瓦及机身断裂的修复

    Renovation for Rupture Body of Machinery and Burned Bush of 512 Circulation Gas Compressor

  26. 300型柴油机曲轴烧瓦后的现场修复方法

    Site Repairing Method for Type 300 Diesel Engine after Burning out of Crank shaft Bearing Liner

  27. 机车柴油机主轴承烧瓦故障振动诊断的研究

    Research on Vibration Fault Diagnosis for Fire-loss Bush of the Main Bearing in Locomotive Diesel Engine

  28. 卧式机组弹性柱销联轴器联接引起烧瓦的改造方法

    Transforming on Tile Kilning of the Linking of the Elastic Dowel Pin Shaft Coupling in Horizontal Aircrew

  29. 空压机烧瓦事故分析及防误操作技术方案

    Analysis of the burning accident of bearing liner and its prevention from mistaken operation in air compressor

  30. 应用三维有限元法分析烧瓦对曲轴的影响

    Analysis of the Effect of bearing shell sticking on the Crankshaft by Using Three - Dimensional Finite Element Method