浸镀

而以微孔硅阵列作为模板，利用浸镀法得到了新颖的硅基银纳米结构，其拉曼增强活性和均匀性都比较好。

Moreover , millipore silicon arrays were also used as templates for silver nanostructures , and novel silicon-based silver nanostructures were obtained through immersion plating method , and the enhancement ability and uniformity of the novel SERS substrates were both good .

浸镀法制备SERS活性金衬底研究

Study on SERS-active Au substrate Prepared by Immersion Plating

热浸镀PC钢丝扭转脆性断裂分析

Fracture Analysis of Torsional Brittleness of Hot-dipped PC Steel Wire

采用该合金助镀剂进行ZnAl合金热浸镀的样品，表面质量得到进一步改善。

Surface quality of hot dip plating Zn-Al alloy were further improved .

硅镇静钢热浸镀Zn－Ni合金

Hot Dipping Zn-Ni Alloy for Si-Killed Low Carbon steel

热浸镀Zn及其合金在世界各国得到广泛的应用。

Hot-dip zinc and alloy are widely used in all over the world .

热浸镀渗铝钢TEM制样技术

Technique of hot-dipped aluminum steel sample preparation for TEM

稀土对热浸镀铝钢Al2O3／渗铝层界面空洞生长的影响

Effects of Rare Earth on Growth of Voids along Interface between A1_2 O_3 and Aluminizing Layer

通过高温氧化试验研究了热浸镀铝钢合金层硬度的变化规律，借助电子探针和X－射线衍射仪对合金层的成分、形貌和氧化产物进行了分析。

The principle of alloy layer hardness of hot dip aluminized steels have studied with high temperature oxidation test .

La对热浸镀渗铝层厚度及耐蚀性的影响

Influence of La on the Corrosion Resistance and Thickness of Hot - dipped Aluminizing Layer

研究了热浸镀55%AlZn合金镀层钢的室温拉伸性能和耐蚀性能。

The tensile properties and corrosion resistance of hot dip 55 % Al Zn alloy coating steel are investigated .

研究了冷却速度对用于热浸镀Zn的Zn0.24Ni合金共晶组织的影响。

Effects of cooling rate on eutectic microstructure of Zn - ( 0.24Ni ) alloy for hot dip galvanization were investigated .

对A3钢热浸镀铝和铝－稀土的两种镀层在人造海水中的电化学腐蚀行为进行了研究。

The corrosion electrochemical behavior of aluminum hot dipped coating was studied in simulated sea water .

TiAl合金热浸镀铝及热扩散处理后的镀层结构

Effect of Thermal Diffusion Treatment on the Composition and Properties of Hot-Dip Aluminizing Coating on TiAl Alloy

螺栓热浸镀Zn-Ni合金工艺

Research on Galvanizing Bolt by Dipping Zinc Nickel Alloy Process

用金相显微镜及X射线衍射仪对形变含稀土低碳钢热浸镀铝的镀层微观组织进行了分析，并探讨了其形成机制。

The microstructure of hot-dip aluminum coat of deformed low-carbon steel containing RE has been analyzed by metallography microscopy and XRD , and the forming mechanism has also been discussed .

钢铁件直接浸镀Cu-Sn合金

Direct Immersion Plating Process of Golden Cu-Sn Alloy on Iron and Steel

对A3钢表面热浸镀扩散渗铝复合渗硼进行了初步的探讨。

In this paper , the research on the Hot Dip Aluminum and complex Boronized surface of A3 steel was discussed .

本文作者用浸镀法制备SnO＿2：TiO＿2气敏光学薄膜，薄膜质量有所提高。

In this paper we introduce that the SnO_2 : TiO_2 gas-sensing film is made by using immersion-plating method .

在Q235钢表面热浸镀铝后再进行微弧氧化获得一陶瓷层。

Ceramic coating was prepared by microarc oxidation on hot dip aluminized surface of steel Q235 .

热浸镀Zn-55%Al-1.6%Si合金镀层钢丝耐蚀性能在合金相（Al-Si-Fe三元金属间化合物）为最佳；

The optimal anti-corrosion layer of Zn-55 % Al-1.6 % Si was intermetallic layer ( Al-Si-Fe );

众所周知，热浸镀Zn-Ni合金技术是解决活性钢热镀锌问题的有效方法。

As we know , the technique of hot-dip Zn-Ni alloy coating is an effective method for solving the reactive steel problem in hot-dip galvanizing .

系统主要采用SIEMENTSS7-300系列CPU、总线网络、分布式I/O的控制方案来实现热浸镀模拟试验机的浸镀过程控制。

The control system adopts SIEMENTS S7-300 CPU , network and distributed I / O to perform hot-dip process control of hot-dip galvanizing simulator .

热浸镀Al-Si-RE涂层的抗高温氧化性能

High temperature oxidation resistance of coating with hot-dipped Al-Si-RE

热浸镀Al-Zn合金镀层已广泛应用于钢铁制品的一种防腐保护。

Due to the fairly good corrosion resistance , Al-Zn alloy coatings by hot-dip process have been widely used as the protective material on steel products .

采用浸镀金属锌对预处理后的硬铝LY11合金加以表面改性；

The surface of pretreated aluminium alloy ( LY11 ) was modified by zinc immerseplating .

通过CO2和H2S腐蚀试验，采用SEM和EDS研究了20钢经热浸镀稀土（镧）铝和扩散处理后的渗层组织和耐蚀性能。

CO_2 corrosion tests and H_2S corrosion tests , together with SEM and EDS , were used to study the microstructure and corrosion resistance of the coating on 20 steel treated by hot-dip aluminizing and diffusing with rare earth La .

高温氧化腐蚀对热浸镀Al-Si-RE涂层表面形貌的影响

Research on the Surface Transformations of Heat Resistant Martensitic Steel Hot-dipped Al-Si-RE During High Temperature Oxidation Corrosion

对Q195普通低碳钢分别进行热浸镀铝加共渗处理和渗碳处理，并对两种处理件进行耐磨性试验。

Wear resistance of Q195 after Al hot dipping and post diffusion was studied and compared with that of carbonized Q195 .

为提高直升飞机压气机叶片的高温使用寿命，采用热浸镀工艺对其材料表面进行Al-Si-RE强化处理。

In order to improve the usage temperature of a helicopter vane , Al-Si-RE coating was hot-dipped on its surface .