残余变形

结果表明Gr／Al的应力应变曲线可分为两个部分：非线性弹脆性变形以及材料失稳后的残余变形。

The experimental results show that complete stress strain curves of the material can be divided into two parts : the elastical brittle deformation and residual deformation .

在大量试验数据分析的基础上，探讨了主应力比Kc在残余变形产生及发展过程中的作用；

Based on the analysis of test data , the influence of the principle stress ratio on the occurrence and development of dynamic residual deformation is discussed .

对于不同降解度的城市固体废弃物，分别利用改进后的适合MSW的残余变形模型对模型参数进行整理，比较了固结比、降解度、动应力等各种因素对残余变形参数的影响。

Compared the consolidation ratio , degradation degree , the dynamic stress and other factors on the influence in residual deformation parameters .

岩体现场缩尺拉拔模型试验发现，锚碇后锚面上，围岩位移呈马鞍形分布，残余变形率呈V形分布；

Several facts are found through the in-situ pull model test . The total displacement and the rate of residual displacement on the back anchor face show saddle and V-shaped distribution , respectively .

利用MISES屈服准则，可以判定在水冷阶段筒体部分区域进入塑性，产生周期性的塑性残余变形。

MISES yield rule was used to determine the region which had yielded during the process of temperature rising and dropping .

外侧下压（40mm），三棱针残余变形最小。

Under Lateral downward loading ( 40mm ), the remnant deformation of triangular needle was smallest .

最后结合一个简单数例，将理论计算结果与MonteCarlo法的计算结果进行了比较。比较结果表明，本方法可用来估算结构残余变形的统计量。

Comparing the theoretical results with those calculated by Monte Carlo method , it is shown that the method presented in this paper can estimate the statistic value of the residual displacement with satisfactory accuracy in engineering practice .

该节点的主要优点是（1）拥有自定心（self-centering）的能力从而大大减小了在地震后的残余变形；

The advantages of this connection are : ( 1 ) the connection is self-centering , there is little residual deformation after earthquake .

该方法成功地应用于微电子系统结构在去除SiO2牺牲层后的残余变形测量。

The FIB moir é method is successfully used to measure the residual deformation in a micro electro mechanical system ( MEMS ) structure after removing the SiO 2 sacrificial layer with a 5000 lines / mm grating .

由于侧梁非严格对称，且外部4条主焊缝环绕在纵向中性轴（X轴）的四个角点；焊缝金属收缩是形成焊接残余变形的主要因素。

Because the side beam is asymmetric , and the external four longitudinal weld locate four corner of longitudinal neutral axis ( X axis ) of the side beam . For the groove weldment , the shrinkage of weld metal is the main factor making residual welding deformation .

测量了圆柱壳体的周向应变及残余变形，其残余变形形貌与Lindberg发表的实验结果相似。

Circumferential strain and permanent deformation are recorded , which are close to the experimental results reported by Lindberg .

研究表明，随纤维掺量的增加，HFRC材料的循环应变发展起始阈值和疲劳前的残余变形均可提高。

Study shows that both initial value of circulation strain development and residual deformation before fatigue of HFRC can enhance with increment of fibre adding .

实验研究发现，在大于100gTNT当量的爆炸下扁平绕带式压力容器产生明显的残余变形，主要集中在爆心附近且最大值在爆心横截面上。

The experimental results show that the pressure vessels with flat-wound ribbons have residual deformation subjected to inner central blast loading when the quantity of explosive is more than 100g TNT . And the deformations are mainly concentrated near the center section of blasting .

矿渣掺量为40%时，28d抗压强度和静弹性模量低于基准混凝土，最大变形和残余变形均明显大于基准混凝土的变形。

The compressive strength and the static modulus of elasticity at 28 days is obviously less than that of the control concrete , the maximum deformation and the residual deformation are obviously greater than that of the control concrete when the slag replacement is 40 % .

GB13042-1998包装容器气雾罐罐体容积残余变形率

Packaging containers & aerosol cans residual expansion rate of tank volume

内河船舶板格残余变形的统计分析

Statistical Analysis for Residual Deformation of Plate Panel of Riverboat

刚塑性结构在冲击载荷作用下最大残余变形的近似解

Approximate solutions of residual deformations for impulsively loaded rigid-plastic structures

曲轴滚压加工残余变形的有限元分析

Finite Element Analysis of Residual Deforming of Crankshaft Rolling Process

钢筋混凝土梁屈服后残余变形特性研究

Study on Remnant Deflection Performance of Reinforced Concrete Beams after Rebar Yielded

老采空区上方地基稳定性及残余变形规律研究

Research on Stability of Foundation over Mined Gob and Residual Deformation Rule

地震爆炸震源模拟爆炸复合材料中的残余变形

The simulation of seismic explosive source Residual Deformation in Explosion Cladded Material

行车荷载作用下湿软路基残余变形的研究

On Residual Deformation of Saturated Clay Subgrade under Vehicle Load

采动场地残余变形特征及预测模型研究

Study on Character and Forecast Model of Residual Deformation in Mining Site

粗粒土动残余变形特性的试验研究

Study on residual deformation characteristics of coarse - grained soils

砂质混合粘土的孔隙水压力和残余变形特性研究

Research on pore water pressure and residual shear strain characteristics of sand clay

八角垫残余变形计算分析

Calculative analysis of residual deformation for ring joint gasket

大型焊接结构残余变形分析

Analysis of Residual Deformations on Large - size Weldment

利用金属塑性变形后产生残余变形的原理对需校正工件主动加载可实现工业构件的塑变校正。

It is realizable to adjust plastic distortion of workpieces by loading actively .

强震区高混凝土面板堆石坝地震残余变形与动力稳定分析

Study on earthquake-induced permanent deformation and dynamic stability of high concrete-faced rockfill dam

螺栓微量残余变形的测量

Measurement of Micro - residual - deformation of Bolts