标准样品

  • 网络Standard Sample;reference material;master sample;golden sample;Type Sample
标准样品标准样品
  1. 桑蚕双宫丝特征标准样品(样照)的制作

    Preparation of Standard Sample Photograph for Features of Mulberry Doupion Silk

  2. 铁矿石标准样品稳定性研究

    Standard Sample Stability Research of Ion Ore

  3. X射线荧光光谱-点滴麦勒膜制片法测定金标准样品中金银铜锌

    Determination of Gold , silver , Copper and Zinc in Gold Standard Samples by Mylar Film-XRF

  4. 待测样品和标准样品的缓冲介质与pH值必须保持一致;

    The buffer medium and pH value should be the same for the sample and the standard .

  5. 用于加速器质谱测量的长寿命核素~(182)Hf标准样品的制备

    Standard samples preparation of long-lived nuclide ~ ( 182 ) Hf for AMS

  6. 用于AMS测量~(36)Cl标准样品的研制

    Prepare of ~ ( 36 ) Cl Standards for AMS

  7. 报导了用天然煤制备用于电子顺磁共振(EPR)研究的强度标准样品。

    An EPR intensity standard based on natural coal was reported .

  8. 用标准样品建立工作曲线,采用X射线荧光法测定低品位精钼矿中硅含量的方法及相关条件,并对测量结果精度进行分析。

    In this paper , a method of determining SiO2 in the low-grade fine molybdenum ore concentrates by energy-dispersive X-ray fluorescence spectrometry was studied .

  9. 介绍了国家标准样品SO2标准钢瓶气在荧光SO2分析仪校准中的应用。

    It was introduced that national sample SO_2 cylinder gas was used in fluorescence SO_2 analyzer calibration .

  10. Al-Li合金光谱标准样品制备和定值

    Preparation and Evaluation of Spectral Al-Li Alloy Reference Material

  11. 采用所设计的微型CT系统对有机玻璃标准样品进行了三维重建,结果表明该微型CT系统具有较高的精度,重建相对偏差在0.6%以内。

    The micro-CT system is used to reconstruct a Lucite sample first and the result shows that the system has a high precision , the relative error of reconstruction is under 0.6 % .

  12. 颗粒物标准样品分析的PIXE方法

    A PIXE method for analyzing the standard samples of particulates

  13. 方法测定待测样品及标准样品与镉离子、β-环糊精(-βCD)形成包合物的峰电流。

    Methods : The biggest current of inclusion complexes which were made of pilot sample ( or standard sample ) and cadmium ion with β - cyclodextrin was determined .

  14. 采用折算方式进行X射线荧光光谱测定冶金熔剂,解决了该方法没有标准样品及烧失量大的难题,得到满意的分析结果。

    The conversion mode was used in the determination of metallurgical flux by X-ray fluorescence spectrometry , which solved the difficulties without reference samples and much ablation . The results are satisfactory .

  15. NDA核标准样品研制中质量控制的一些关键技术研究

    Studies on Some Techniques in Quality Control of NDA Working Standards

  16. 简要介绍应用加速器质谱计(AMS)测量41Ca,并与标准样品进行对照。

    Ca is measured by accelerator mass spectormeter ( AMS ), and the result is compared with the standard sample .

  17. 通过分析研究认为,作为COD测试的标准样品,应该是在组成与性质上与实际样品具有最大相似性的物质。

    It was found that standard sample for determination of COD should be the substance with the greatest similarity compared with actual samples in the composition and the nature .

  18. 以染料木素(Genistein)为标准样品,用分光光度法测定了Genistein和大豆苷原(Daidzein)混合标准溶液的异黄酮总浓度。

    Based on genistein as reference standard , the isoflavones content of standard mixture of genistein and daidzein was determined by ultraviolet spectrophotometry .

  19. 通过对仪器的刻度、本底实验、γ点源实验、加入标准样品实验等,确定了该方法的探测下限为每包废物中~(235)U含量0.053g。

    The lower detection limit is settled on 0 . 053 g 235U for each package of waste through a series of tests on scale , background , r-point source and reference samples .

  20. 通过索氏提取气溶胶样品,抽提物经硅胶层析柱分离,使用16种多环芳烃混合标准样品绘制标准曲线,以外标法对PAHs进行定量分析,并根据所得数据浅析了多环芳烃污染来源。

    Coupled with soxhlet extraction and silicagel column chromatographic separation techniques . The method of mixed standard curves were used to quantitatively determine 16 PAHs in aerosol samples .

  21. 试验结果表明:超细HMX和RDX的爆炸分数相比军用标准样品的值有较大幅度下降。

    The result shows that the explosion rate of ultrafine HMX and RDX is much lower than that of the military standard .

  22. 用该法测定合金钢标准样品中的钼,测定结果与标准值相吻合,RSD为0.85%~1.52%。

    The molybdenum in alloy steel standard sample was determined , the result basically agrees with the certified value , RSD is 0.85 % ~ 1.52 % .

  23. 本论文重点对上述NDA核标准样品研制过程中质量控制的一些关键技术进行了研究。

    In this dissertation some pivotal techniques on quality control in developing of NDA nuclear standards above were emphatically studied .

  24. 介绍了一种研制大气SO2(片剂)标准样品的新方法,重点论述了研究过程中对样品进行的均匀性、稳定性检验和定值。

    A new method for developing air SO2 reference material was introduced , with the focus on the examination of homogeneity and stability of the samples as well as the certification of the samples .

  25. 利用磁控溅射方法在表面有SiO2层的Si基片上溅射Ta/NiFe薄膜,采用X射线光电子能谱(XPS)研究了SiO2/Ta界面以及Ta5Si3标准样品,并进行计算机谱图拟合分析。

    Ta / NiFe film is deposited on Si substrate precoated with SiO_2 by magnetron sputtering . SiO_2 / Ta interface and Ta_5Si_3 standard sample are investigated by using X-ray photoelectron spectroscopy ( XPS ) and peak decomposition technique .

  26. 本法w(U)测定下限为003%,RSD优于3%,回收率为95%~105%,与铀矿石标准样品对照分析,误差小于2%。

    The determination limit is 0.03 % , the RSD is better than 3 % , the recovery is 95 ~ 105 % . The error is less than 2 % compared with the standard sample of uranium ore.

  27. 利用单个标准样品比较法质子弹性散射分析(PESA)对一组采集在核孔膜上的气溶胶样品的氢含量进行定量分析。

    Proton elastic scattering analysis ( PESA ) method was employed to measure H concentrations of aerosol samples on nuclear track filter .

  28. 论文工作研究的主要内容包括:1)用于AMS测量的~(99)Tc样品的制备,包括:空白样品、标准样品、环境样品;

    The main aims of this work are as follows : the first is the AMS samples preparation of ~ ( 99 ) Tc , including blank samples 、 standard samples and the unknown environment samples .

  29. 资源包括评价用的照明适当的颜色纹理光泽金属亮度结构形象清晰DOI的标准样品。

    The resources include lighting for evaluation , masters for colour , grain , gloss , metallic brilliance , texture , distinctness of image ( DOI ) .

  30. 含硒化合物在质谱裂解图中有特征分子离子或离子峰簇,其主要峰M:(M-2)约为2:1,完全不使用标准样品,也可以辨别含硒化合物。

    In MS , the Se-containing compounds had the characterized molecular or ion clusters , and the M : ( M-2 ) is about 2:1 in the clusters .