摩尔比

Ba/Ti摩尔比对B位钙掺杂钛酸钡性能的影响

The Influence of Ba / Ti Mole Ratio on the Properties of Ca Doped in Barium Titanate B-sites

石灰沉砷效果受温度、pH和Ca/As摩尔比的影响十分显著。

Arsenic precipitation with lime was greatly influenced by temperature , pH and Ca / As mole ratio .

聚合条件（Al／Ni摩尔比和温度）对反应活性和所得产物有很大的影响。

Reaction condition ( Al / Ni molar ratio and temperature ) greatly influenced the activity and products .

掺杂物为Bi（No）3；Mn：Bi的摩尔比为6～10。

Dopant was Bi ( NO ) 3 ;

通过湿法沉积工艺实验室合成了Ca／P摩尔比为1.67的磷酸钙粉料，其物相纯正，结晶良好。

By wet-precipitation method , pure calcium phosphate powder with Ca / P P molar ratio of 1.67 and good Crystallization is synthesized in lab.

用双晶X射线衍射法对单苯甲酸和混合摩尔比为60%制作的光波导进行X射线衍射。

The optical waveguides fabricated by using single benzoic acid and 60 % ratio dilution were analyzed by double crystal X-ray diffraction .

考察了Mo、V的摩尔比、载体在催化剂中所占的重量对催化剂性能的影响。

Effects of molar ratio of Mo to V and weight ratio of support on catalyst properties were also investigated .

通过模拟废水实验，考察了pH值、氨氮、磷酸盐与镁盐之间的摩尔比等因素对水样中氮、磷回收效果的影响。

The effects of pH value and the molar ratio of ammonia nitrogen , phosphate and magnesium on nitrogen and phosphorus recovery were studied with simulated wastewater .

PU／PA混杂乳液中PA含量以及NCO与OH摩尔比将影响混杂乳液的粒径。

PA content and NCO / OH mole ratios in PU / PA hybrid latexes affected their particle size .

混合气化剂，在石油焦气化制取CO气过程中脱硫研究表明：当脱硫剂与石油焦中硫摩尔比为4：l时，脱硫率可达41.2%。

The result showed that when the mole ratio of desulfuration agent to sulfur in petroleum coke reached 4 , the proportion of desulfuration reached 41.2 % .

当H2O2与苯甲酸的摩尔比为30∶1时，·OH可与苯甲酸完全反应；

· OH may react on benzoic acid completely when molar ratio of H 2O 2 and benzoic acid is 30 ∶ 1 ;

本文还报道了这些包结化合物的IR，粉末XRD的表征，用~HNMR谱测定了它们的分子摩尔比。

These inclusion compounds were confirmed by means of IR and powder XRD , and their host-guest molar ratio was determined by 1H NMR .

以S萘普生为模板，N乙烯基吡咯烷酮为功能单体，二乙烯基苯为交联剂分别按照摩尔比1/4/10、1/4/20和1/4/30合成了分子印迹聚合物（MIP）。

Molecularly imprinted polymers were prepared using S-naproxen as a template molecule , N-vinylpyrrolidone as a functional monomer and divinylbenzene as a crosslinker .

PASC在水体中的残留铝含量随着AlSi摩尔比的降低和B值的升高而下降。

The residual aluminum of PASC in the treated water decreases with decrease of Al / Si molar ratio and increasing of B value .

不同摩尔比的底物反应6h都有单酯和双酯生成。烯醛摩尔比6.7。

Mono and diesters were formed after 6h reaction with different molar ratio of the substrates .

结果表明：增强效果主要决定于MQ硅树脂的结构，包括M／Q（摩尔比）和硅羟基的质量分数。

The reinforcement effectiveness mainly depended upon the structure of MQ silicone resin including M / Q ratio and the content of hydroxyl groups .

本文对复合密胶树脂型高效混凝土减水剂的合成条件反应摩尔比、pH及温度等进行了较详细地讨论，便于此产品的推广利用。

The synthetic conditions of the melamine resin high-power concrete water reducer such as the molar ration , pH and temperature ect , was introduced in order to make use of the product .

间歇溶气气浮试验结果表明：影响改进型复合碱式氯化铝除油性能的主要因素是碱化度B，其次是铁铝摩尔比和投量。

Experiment of batch dissolved air floatation shows that the key factors which influences the oil removing capacity of BCAC are the alkalinity and the mol ratio of Fe / Al and the dosage of the chemical .

通过固定无机纳米氧化物掺杂总量为24wt%，调整纳米SiO2与Al2O3的摩尔比，进而制得一系列三层杂化复合薄膜。

A sequence of three-layer composite polyimide film was prepared by fixing the inorganic content and regulating the molar ratio of nano-SiO2 and nano-Al2O3 .

固定Li2O与TiO2的摩尔比为0.5：1，研究了助烧剂用量对陶瓷相组成、微观形貌以及介电性能的影响。

We studed the effect of content of sintering aids on phase composition , microstructure and dielectric properties .

配合物为中性配合物，配体与Pd（II）的摩尔比为1∶1.配体和配合物均为热致型液晶。

The molar ratio of the ligand to Pd ( II ) is 1 ∶ 1.The liquid crystalline properties of the ligand and the complex were determined by polarizing microscopic observation .

粉体的Ba与Ti摩尔比为（1000±0005），杂质含量小于电子工业行业标准；

The Ba / Ti mole ratio was ( 1 000 ± 0 005 ) confirmed by chemical analysis . The content of impurity was below the industry standard .

研究了EDTA的用量、AgNO3浓度、反应温度和AgNO3用量对铜银双金属粉抗氧化性能的影响，结果表明：EDTA用量以EDTA与AgNO3摩尔比在1~1·25∶1的范围内为宜；

The influences of EDTA dosage , AgNO_3 concentration , reaction temperature and AgNO_3 dosage on oxidation-resistant properties of Cu-Ag bimetallic powder are studied .

本文研究了耐高温聚酰胺酰亚胺树漆（PAI）的合成，并探讨了TMA/MDI摩尔比、催化剂A以及稳定剂B对（PAI）预聚物合成的影响。

The preparation of best-resisting polyamideimide enamels is studied and the influence factor-TMA / MDI molar ratio , catalyst A and addition agent B , is discussed .

采用sol-gel法在Pt/Ti/SiO2/Si衬底上制备了c轴择优取向优良、电阻率高和化学计量比好的掺Li+（Li/Zn摩尔比分别为0、0.05、0.10、0.15、0.20）ZnO压电薄膜。

The piezoelectric ZnO ∶ Li films possessing preferential c-axis orientation , high resistivity and good stoichiometry were achieved on substrate of Pt / Ti / SiO_2 / Si by the sol-gel method .

讨论了多元醇与环氧丙烷（PO）及环氧乙烷（EO）共聚物的支链数、支链的分子量、PO与EO的摩尔比、分子间的交联对COM燃料流动性的影响。

Effects of number , molecular weight , molar ratio of PO and EO , crosslink density of branched chain on fluidity are discussed .

当添加2%～5%的胶粘剂时，可提高低摩尔比的UF树脂对木材的胶合性能。

Addition of 2 % - 5 % ( mass ratio ) crosslinking agent improved wood adhesion of UF resin of low molar ratio .

氧气与毗啶的摩尔比a是决定NOx生成量的重要因素，a大于6.0开始，随着氧气量的增加，NOx的生成量急剧增加；

The quantity of NOx emission increased with the increase of oxygen when a is greater than 6.The parameter a means the mole proportion between oxygen and pyridine .

Al-TiO2-B2O3反应体系中B2O3/TiO2摩尔比对热扩散反应合成铝基复合材料磨损性能的影响

Effect of B_2O_3 / TiO_2 Mole Ratios in Al-TiO_2-B_2O_3 Reaction System on the Wear Resistance of in-situ Exothermic-Dispersion Reaction Synthetic Al-Based Composites

pH、污水中各组份的离子浓度及其摩尔比是结晶形成的最主要影响因素，除磷效率与水中氨氮浓度及Mg与P的摩尔比呈正相关。

The pH and each component ion concentration in the wastewater and their molar ratio are mainly influence factors for crystallization . The efficiency of phosphorus removal was positive correlativity with ammonium concentration and molar ratio of Mg : P.