复合缺陷

  • 网络complex;defect complex
复合缺陷复合缺陷
  1. Si中B-空位复合缺陷的电子结构

    Electronic structure of BORON-VACANCY complex in silicon

  2. 为解释转折点以后的变化,引入了复合缺陷(Ba空位与La杂质离子形成的复合体)模型,并得到复合缺陷是不能捕获正电子的结果。

    To explain the results a complex defect ( Ba vacancy + La ion complex ) model was proposed . The experimental results show that this complex defect does not trap positrons .

  3. 着重分析讨论了引入受主杂质Mn对材料的半导化的影响,并采用复合缺陷模型自洽地解释了实验现象。

    A complex-defect model was adopted to explain the explain the experimental results well .

  4. 对ncSiSiO2薄膜中纳米硅(ncSi)、Er3+和非辐射复合缺陷三者间的关系作了研究。

    Correlation between nc Si , Er 3 + and nonradiative defects in Er doped nc Si / SiO 2 films is studied .

  5. 单晶硅中铒点缺陷及Er-O复合缺陷电子结构的EHMO计算

    Calculation of Electronic Structures of Er Point Defects and Er O Complex Defects in Crystal Silicon with EHMO

  6. 在快速退火过程中可形成反位缺陷GaAs(Ev+200meV)以及复合缺陷IGa-VAs。

    In the process of the rapid annealing , antisite defects Ga As ( E v + 200 meV ) and complex defects I Ga - V As are formed , where I is impurities .

  7. 掺铒nc-Si/SiO2薄膜中nc-Si和Er~(3+)与非辐射复合缺陷间相互作用对薄膜发光特性的影响

    Influence of coupling between Er ~ ( 3 + ) , nc-Si and nonradiative centers on photoluminescence from Er ~ ( 3 + ) - doped nc-Si / SiO_2 films

  8. 含复合缺陷的一维光子晶体的非线性传输特性的研究

    The Nonlinear Transmission Property for One-dimensional Photonic Crystals Containing Composite Defects

  9. 钛酸锶铋介电陶瓷中复合缺陷的正电子湮没研究

    Positron Annihilation Study of Complex-Defect in Sr-Bi-Ti-O Dielectric Ceramics

  10. 同时要继续排除其他类型以及有复合缺陷的可能。

    Meanwhile the continued exclusion of other types and may have complex defects .

  11. 这些复合缺陷的出现对石墨烯纳米带的电子结构和光学性能产生了影响。

    These complex defects affect the electronic and optical properties of the graphene nanoribbons .

  12. 复合缺陷对钛酸锶铋材料介电特性的影响

    Influence of the complex defect on dielectric properties of strontium titanate solid solution containing bismuth

  13. 对于半导体型(8,0)碳管,这种复合缺陷总体上对输运起到增强的作用。

    For semiconducting ( 8 , 0 ) nanotube , the complex defects enhance the transport properties of the system as a whole .

  14. 对于邻近石墨烯纳米带边缘的硼(氮)空位复合缺陷结构对石墨烯纳米带的几何结构和能带结构有较大影响。

    The boron ( nitrogen ) - vacancy complex defects near the edge of the graphene nanoribbon affect the geometry and electronic structures of the graphene nanoribbon distinctly .

  15. 结果表明,镧含量低时,材料中存在复合缺陷,且材料的介电常数随镧含量增加呈现峰值;

    The results show that the complex-defect exists in the material . When the content of La is low and the dielectric permittivity increases with the content of La ;

  16. 用复合缺陷模型解释了电导率、晶粒尺寸随施主含量变化等重要实验现象。

    With the help of the complex defect model , some important experimental phenomena , e.g. the dependence of conductivity and grain size etc. on donor content , have been interpreted .

  17. 对于硼(氮)空位复合缺陷位于边缘的锯齿型石墨烯纳米带,这些复合缺陷很明显地改变了石墨烯纳米带的电子学和光学性能。

    When the boron ( nitrogen ) - vacancy complex defects locate on the edge of the zigzag graphene nanoribbon , these complex defects have changed the electronic and optical properties of the graphene nanoribbons distinctly .

  18. 本文在线性压电理论的框架下,对压电介质、双相压电介质以及直角域压电介质中含圆孔、裂纹、夹杂或复合缺陷的反平面动力学问题进行了研究,得到了一些有价值的结论。

    Dynamic antiplane problems of the piezoelectric medium , piezoelectric bimaterials and quarter-infinite piezoelectric medium which contain circular cavity , crack , inclusion and composite defects are investigated in this article using the linear piezoelectric theory .

  19. 基于MATLAB编程的木质复合材料缺陷信号小波分析

    Wavelet analysis on defect signals of wood composite materials based on MATLAB programming

  20. 石油钻杆摩擦焊焊接接头冲击韧性低的原因是焊后热处理金相组织不理想和焊缝区存在灰斑及FeS·MnS复合夹杂物缺陷。

    The reasons for the low impact toughness of the friction welded joint of drill pipe is that the metallurgical microstructure of the joint heat-treated after welding is not ideal and there are grey spots and FeS · MnS inclusions in the weld zone .

  21. 火燃复合产品缺陷分析及其设备改进

    Analysis of Defects in Burn-combined Products and Improvement of Their Equipment

  22. 典型复合材料缺陷/损伤实时成像检测图谱的解释

    Interpretation of X-ray Real Time Image of Composite Material Defect / Damage

  23. 用相移干涉计量技术检测复合材料缺陷

    The Inspection of Composite Materials by Phase - shift Method

  24. 基于能量比较法的金属基复合材料缺陷信号特征提取

    Extraction of Defect Features of Metal Matrix Composite Based on " Energy-comparison "

  25. 碱熔釜镍复合层缺陷的修复

    Repairing of nickel clad defect in alkali-melting vessel

  26. 碳纤维混凝土复合材料缺陷的红外热像检测

    Inspections on Carbon Fiber-reinforced Concrete Compound Materials for Defects with the Method of Infrared Thermograph

  27. 简单介绍了微波无损检测技术的基本原理和方法,利用反射法对复合材料缺陷进行检测。

    In this paper , the rationale and methods of microwave NDT technique are introduced .

  28. 丙酮酸脱氢酶复合物缺陷与疾病

    Disorders of pyruvate dehydrogenase complex deficiency

  29. 复合材料缺陷修补工艺研究

    Study of composite fault repairing process

  30. 实验结果为进一步研究红外检测复合材料缺陷提供了理论与实验依据。

    This result provides some theoretical and experimental proofs for further studies on methods of inspecting composite material for defects .