喷水量
- working water jet capacity
-
检测CO含量、控制合适的喷水量以提高除尘效率成为关键问题。
In order to improve the efficiency of dust removing , measure CO content and control suitable water spray amount have become the key problem .
-
模型可对增湿活化装置内烟温、吸收剂粒度、喷水量、〔Ca/S〕比、风速等因素对脱硫效率的影响进行研究。
The effect of flue gas temperature , particle size , water injection , Ca / S molar ratio and gas velocity on desulfurization efficiency in CaO activation reactor can be studied using this model .
-
试验同时研究了钙硫比、脱硫灰循环率、饱和温距、喷水量和SO2浓度等对脱硫率的影响。
At the same time , the effects of Ca / S ratio , desulfurization residues recycling use , saturation temperature interval , water spray quantity and SO_2 concentration on desulfurization rate were studied .
-
微喷带单孔喷水量分布的基本特征研究
Characteristics and indexes of water distribution of punched thin-soft tape for spray
-
湿式空冷器的喷水量控制
Spray water volume control for the wet type air coolers
-
再热器事故喷水量过大的原因分析与运行控制
Reason Analysis and Operation Control on Excessive Spraying Water Caused by Reheater ′ s Fault
-
此最佳表面喷水量随板材密度和厚度的增加及热压温度的提高而增大。
The optimum sprinkling amount increases when the density or thickness of panels or hot-pressing temperature increases .
-
系统地介绍了其工作原理、结构特点和喷水量实验方案;
The operating principle , the structure characteristics and the experiment schemes of water spray quantity are explained in detail .
-
为防止白锈产生,启用水冷装置时严格控制喷水量。
To control water spary quantity strictly when using water cooling equipment so as to protect producing " white rust " .
-
在人工气候室内模拟了不同喷水量对绝缘子串覆冰的影响。
The different water quantities and theirs influences on icing on the insulator strings had been simulated in an artificial climate chamber .
-
二次冷却喷水量的控制直接影响连铸机的生产率和板坯质量;
The quantity control of spray water in secondary cooling process has a connection with production rate of CC machine and slab quality .
-
实验表明,该喷嘴具有喷水量大、防堵、高效、节能等特点。
The results show that it has the characteristics of more water spray quantity , block preventing , high efficiency and energy saving .
-
因此要选择适当的喷水量,否则会引起柴油机动力不足和排放的恶化。
Therefore , appropriate amount of water injection is very important , otherwise the power performance and emission of engine would be deteriorated .
-
通过工业试验,研究了钙硫比、喷水量等参数对系统脱硫效率的影响。
Through industrial tests studied was the impact of calcium / sulfur ratio and water spray rate on the efficiency of the system desulfurization .
-
但是锅炉普遍存在再热器喷水量偏大的问题,影响了机组运行经济性。
One of the main problems is that the reheater water injection amount is too large , and this affects the economical performance of the unit greatly .
-
在能量转换过程中,“水针”所具有的动能,可通过对喷射速度、喷水量的分析来进行计算。
In the course of energy conversion , the kinetic energy of " water needles " may be counted through the analysis of spray speed and spray amount .
-
结果表明,换热系数随着喷水量的增加而增大;随表面温度的升高呈先增后减的趋势。
The results showed that heat transfer coefficient is increased with the augment of watering quantity , and earlier increased and then reduced with increase of surface temperature .
-
在土壤入渗速度和允许喷灌强度协调的情况下,每次喷水量越大,则产量越高。
If the soil permeable speed and allowable sprinkling irrigation strength can coordinate each other , every time the more spraying water is , the higher the output is .
-
空冷单元内加装喷雾增湿装置能很好的降低机组背压,本文对空冷机组空冷单元喷雾增湿系统喷水量与经济性进行了计算。
Humidifying spray device can obviously decrease the back pressure . In this paper the calculation of economic water amount for air cooling spray humidification system was carried out .
-
农田蒸发能力变化与喷水量和日最高温度成正比,与日最低相对湿度和风速成反比。
Decrease of field evaporation potential is positively related to spraying water quantity and the maximum daily temperature , and negatively related to the minimum relative humidity and wind speed .
-
利用该模型计算得到了主蒸汽温度、主蒸汽压力、真空、再热汽温度、过热器喷水量和再热器喷水量发生扰动时,对机组效率和标准煤耗的定量影响。
Comparative analysis between practical data from main steam temperature control system of a600 MW power unit and the data obtained by this method proves reliability and validity of the method .
-
基于对连铸坯成形过程温度场的数值模拟,确定了满足优化模型的喷水量与拉速定量关系及相应的计算机控制模型。
Moreover , based on the optimum model , a quantitative relation between amount of the spray water and pulling velocity of billet is determined and a computer control model is established .
-
重点研究了钙硫比、烟气温度、喷水量、加湿喷嘴位置对烟气脱硫效果的影响。
The influences of Ca / S ratio , the temperature of flue gas , the amount of injection water and the direction of the nozzle on the efficiencies of flue gas desulfurization were studied .
-
结果表明:(1)喷嘴直径一定时,总喷水量越大,2124铝合金末端淬火后的硬度越高。
The obtained the results were described as follows . ( 1 ) When the diameter of the nozzle was fixed , the hardness increased with the increasing of total flow quantity of the spraying water .
-
在此基础上讨论了系统总体控制、能量质量平衡、减温器喷水量和锅筒产汽量等的算法。
Based on this model , the numerical methods were discussed which included collectivity , initialization , mass / energy balance , water quantities sprayed by the de-heater , and steam quantities produced by the drum .
-
电热连续结晶机的各段喷水量是影响槽内温度梯度的重要因素,而温度梯度保持在一定的范围又是保证产品质量的前提和关键。
Continuous crystalline electric machine of the paragraphs tank water volume is an important factor in the temperature gradient , the temperature gradient maintained in a certain range is to ensure the quality of products and key .
-
通过本文所建立的数学计算模型和相关计算结果,可确定煤价和除盐水价格分别变化时各工况条件下的最佳喷水量和最大净收益。
On the basis of the mathematical model and the calculated result related , the maximum net income and the most appropriate water injection in each condition can be calculated when the price of desalting water and coal changes .
-
水槽试验表明,吸、喷水量为水槽中总流量的15%~2%时,回流长度将减小70%~80%。
The results of flume tests show that a suitable sucking spouting discharge ( 1 5 % - 2 % of the whole discharge ) can cut the length of the circumfluence down to 20 % - 30 % .
-
如果单纯的依靠工人的现场经验来调节喷水量势必导致自动化水平低下,生产效率不高,而且会造成能源消耗的增加。
If you simply rely on the experience of workers on-site to adjust the water spray will inevitably lead to the low level of automation , production efficiency is not high , but will also cause the increase in energy consumption .
-
结果表明进气温度越高,水蚀量变小;喷水量和水滴直径越大,水蚀量也越大;第一级动叶吸力面前缘水蚀量最大。
The results showed that the higher the intake air temperature , blade erosion small ; water mass and droplet diameter is more and more the amount of blade erosion ; the first stage blade suction has the largest erosion . 4 .