压缩变形特性

  • 网络Compression deformation characteristics;compression deflection characteristic
压缩变形特性压缩变形特性
  1. 原位合成TiB2/6351复合材料热压缩变形特性

    Characteristics of Hot Compression Deformation for In-situ TiB_2 / 6351 Composites

  2. 本文对半固态Al-Si-Cu-Mg合金的压缩变形特性进行实验研究。

    The Compression Deformation Behavior of semi-solid alloy Al-Si-Cu-Mg was investigated for its wide application in this work .

  3. 液相线铸造铝合金半固态压缩变形特性

    Compression Deformation Behavior of Liquidus Cast Aluminum Alloy in Semisolid State

  4. 2618铝合金半固态压缩变形特性

    Compression behavior of 2618 aluminum alloy in semi solid state

  5. 控制结晶法制备半固态铝合金的压缩变形特性

    Compression Deformation Behavior of Semi-solid Al-Si Alloy Prepared by Crystallization-controlling

  6. 碱渣压缩变形特性

    The Soda Residue Properties of the Compressibility and Deformation

  7. 饱和膨润土及其与砂混合物的压缩变形特性

    Compression deformation characteristics of saturated bentonite and sand-bentonite mixtures

  8. 某新型粉末高温合金热压缩变形特性的研究

    Study on the Hot Compressive Deformation of a New P / M Superalloy Powder Coating

  9. 聚苯乙烯轻质混合土的压缩变形特性试验研究

    Test study on compression and deformation behavior of light heterogeneous soil mixed with expanded polystyrene

  10. 鉴于黄土具有特殊的工程性质,本文通过大量室内试验系统研究了黄土的击实特性、压缩变形特性及湿陷变形特性;

    Considering the specific engineering attributes of loess , this paper studies the attributes of compaction , compression deformation and collapse deformation by a large number of indoor test researches .

  11. 笔者试图用剪切应变表示施工扰动程度,研究了经受不同剪切应变土体的压缩变形特性,从而确定施工扰动对土体压缩变形的影响。

    An attempt is made to express the degree of construction disturbance by the shear strain on the basis of the study of compression characteristics of soils influenced by different shear strains .

  12. 通过模型试验表明:在竖向附加力作用下,研制的可缩性接头具有良好的压缩变形特性,抗侧压能力大,防水性能好,并应用于工程实际。

    Model test indicate : at effect of vertical additive force , reducible joint has good characteristic of compressing distortion and resists greater side pressure and has good capability of waterproof , and it has been applied to practice project .

  13. 研究了国产新型冷作模具钢LD钢(7Cr7Mo3V2Si)在超塑性条件下压缩变形的力学特性,得出了其最佳超塑压缩变形的工艺参数。

    The mechanic property of compression deformation of LD steel ( 7Cr7Mo3V2Si ), which is a kind of late-model cold-working die steel of home manufacture , has been studied under superplastic condition , and the optimum technological parameters of LD steel compression deformation acquired in this paper .

  14. 非饱和白垩压缩变形依时特性的研究

    A study on time - dependent behavior of the North Sea unsaturated chalk

  15. 利用非线性有限元法分析了密封条的压缩受力变形特性,根据结构力学原理对密封条横截面形状进行了优化。

    Using nonlinear finite element method , the compression load deflection of the seal was analyzed and cross sectional shape of the seal was optimized .

  16. 大理岩常规三轴压缩下强度和变形特性的试验研究

    Experimental investigation on strength and deformation properties of marble under conventional triaxial compression

  17. 设计的离心模型试验边界对群桩基础桩身受力大小与分布影响不大,而对承台沉降和桩端土体整体压缩变形比等变形特性影响较大。

    The influence of boundaries of centrifuge model was small on the distribution and magnitude of the axial forces of pile group , but large on the deformation characteristics .

  18. 本文以实验为主,与理论分析和数值模拟相结合,系统研究了泡沫铝材料在高应变率下的压缩力学行为及变形特性。

    In this paper the mechanical behavior and deformation characters of aluminum alloy foams under high strain rate compression are studied systematically with SHPB device , combined with theoretical analysis and numerical modeling method .

  19. 依据单向固结压缩试验,分析了不同配比条件混合土的压缩变形特性,得到压缩屈服应力和压缩模量,可为工程应用提供参考依据。

    And according to one-dimensional consolidation compression tests , yield stresses and compressive modulus under different conditions of mixture ratios are obtained so as to provide reference for the application in engineering .