单轴自动车床

凸轮控制单轴自动车床

Cam-controlled single spindle automatic lathe

卧式轴六角自动车床和卧式单轴自动车床的试验条件。

Test conditions for horizontal spindle turret and single spindle automatic lathes .

单轴纵切自动车床主轴部件的参数识别

Parameter identification of spindle unit of single spindle longitudinal automatic lathe

单轴纵切自动车床刀具的安装与调整

Tool Installing and Adjusting on Swiss-type Headstock Sliding Automatic Machine

本文介绍了单轴纵切自动车床主轴部件动态特性方面的实验研究结果。

The results of the experimental research on the dynamic behavior of the spindle unit of the single spindle longitudinal automatic lathe is described in this paper .

对小型回转体类零件的基本形体进行了分析，提出了与其统一的数学模型，并将其用于描述单轴纵切自动车床加工的小型回转体类零件。

Essential shape of the small turning shaft parts is analysed , the united mathematical model is put forward and applied to describing these parts longitudinal automatic single spindle lathe .

本文采用截面状态矢量法和模态参数识别方法识别出CM1107单轴纵切自动车床主轴部件的支承参数和模态参数。

The state vector methd of cross-section and modal analysis methd are used to identify the support and modal parameters of the spindle unit of the single spindle longitudinal automatic lathe Mod .

在单轴六角自动车床上应用成组加工

Application of group technology machining on automatic single spindle turret lathe

本文根据使用单轴六角自动车床进行成组加工的方法，叙述了无编码成组加工的方法、分组方法、编制调整卡片以及设计凸轮时的注意事项。

Based on the experiences obtained in group technology machining used on automatic single spindle turret lathe the article describes the group technology method , grouping of parts , the compilation of operation cards and attention points in layout of earns .