刷涂法

再采用刷涂法，并通过对固化温度、时间等工艺参量的控制，分两步合成了聚酰亚胺PI固体薄膜。

And then adopt the law of brushing , pass the control on craft parameters such as solidification temperature , time , etc , have divided two steps and formated the inferior amine PI solid state membrane of acyl of gathering .

本研究由不同的涂层制备方法（刷涂法、浸涂法、气相反应法）在C／C复合材料、石墨基体表面制备了SiC涂层。

In this paper , SiC coating was prepared by different methods ( paste coating , dip coating and vapor reaction coating ) on the surfaces of C / C composites and graphites .

简介了长输管道异型管件及补口防腐的两种方法，即高膜厚PU防腐涂料刷涂法和火焰塑料喷涂方法。

This paper briefly introduced two methods for anticorrosion of special piece and repaired mouth of long transportation pipeline , i. e , flame plastic spraying and high-build PU anticorrosive paint .

以V2O5溶胶凝胶为原料，采用旋涂法、浸涂法、喷涂法和刷涂法在各种衬底上涂制V2O5薄膜。

Employment V_2O_5 sol-gel as material , V_2O_5 films on different substrates were produced by four physical coating technologies .

利用简便的刷涂法在钢基体表面制备了石墨固体润滑涂层。

The simple brush-painting method was utilized to prepare the graphite solid lubrication coatings on the steel substrate .

目前应用较广泛的方法是喷涂和刷涂法等，这些方法普遍存在污染环境、附着力差等缺点；磁控溅射方法能够实现绿色环保生产，而且膜层的附着力较好。

At present , the more wide ways are spray and brush and so on , but these ones have many disadvantages , for example polluting environment , poor adhesion etc. magnetron sputtering is a green one and the adhesion of the film with the substrate is very good .