冷压法

以冷压法研制基材表面覆盖竹片，背面配置普通旋切木质单板的竹材复合板。

By use of cold press method , in which the surface of basic board is covered by bamboo flake and the back is covered by common turning wooden veneer , bamboo composite board is developed .

并与冷压法进行了对比。

The process was also compared with the cold moulding method .

竹胶合板冷压法的探讨

Study on the cold pressing & a making process of bamboo veneers

冷压法粉煤灰水泥刨花板工艺研究

The Study on the Technology of Fly-ash Cement Particleboard by Cold - pressing

龙岩无烟煤冷压法炼制型焦的研究

Study of making formed coke with coal briquetting process

应用冷压球团法处理锰粉矿

An Application in the Way of Cold-Pressing Balls to Manage Mn-ore Powder

采用冷压成型法，研究了无烟粉煤炼制优质型焦的技术。

The paper introduces the technology of producing formed coke with high quality using fine anthracite with cold briquetting process .

给出了热压挤片法、热压切片法、冷压烧结法、毛细管封装法和树脂粘合法等热释光探测器的制备工艺，以及它们的适用范围。

The techniques of constructing thermoluminescence detector , such as hot-pressing extrusion molding method , hot-pressing section cutting method , cold-pressing sintering method , capillary sealing method and resin adhesion method , and their applications are given .

不采用热压法，用传统的冷压-烧结法也能获高性能B4C烧结品。

An advanced performace B_4C article could also be obtained by traditional cold pressing-sintering method other than hot-pressing .

介绍了用冷压烧结成型法加工超高分子量聚乙烯（UHMWPE）彩色多孔薄板的技术。

It introduced the processing technology of cold-press sintering moulding used for processing UHMWPE colorful and porous thin plate .

冷压、烧结法制造碳纤维增强铜基复合材料

Fabricating carbon fiber reinforced copper matrix composites by cold pressing - sintering

为此，以一种塑铜合金塑料（聚四氟乙烯加青铜粉）为材料，利用冷压烧结成型法，研制出了塑铜合金水泵轴承。

Therefore bearing for water pump made from plastic - bronze ( polytetrafluoroethylene - bronze ) was developed using cold - pressing sintering method .

分别采用热压和冷压烧结法制备出LiCoO2靶材，其中热压法使用了不同材质的模具，冷压烧结法以环氧树脂为粘结剂，确定了粘接剂的最佳添加量为1.0%。

LiCoO_2 targets were prepared by hot pressing and cold pressing with sintering method s. Different moulds were used in hot pressing method ; in cold pressing with sintering method , epoxy resin was added as binder and the best ratio ( 1.0 % ) was found .