内力

nèi lì
  • internal force;endogenous force
内力内力
内力 [nèi lì]
  • [internal force] 由系统内的一部分对另一部分作用的力

内力[nèi lì]
  1. 得出了H型张弦梁结构在不同地震作用下的内力和位移响应规律,以及在不同预应力和撑杆数目下结构的内力和位移响应变化规律。

    Internal force and displacement response regularity of H-BSS at different earthquake action or different pre-stress and strut numbers were deduced .

  2. 应用有限元理论,借助于Ansys分析软件对此结构进行内力分析,在此基础上对结构进行预应力配筋。

    Using the finite element theories , it makes use of software Ansys doing internal force analyze of this structure .

  3. 基于FLAC~(3D)的土钉内力分析

    Flac ~ ( 3d ) analysis of the internal forces of soil nails

  4. 隧道施工由CRD改为CD工法衬砌结构内力及变位分析

    The analysis of lining stress and strain with working method from CRD to CD method

  5. 空间杆系结构大挠度问题内力分析的UL列式法

    A UL formulation for internal force analysis of spacial frame structures with large displacement

  6. 阐述了作用于PC轨道梁桥结构上的荷载,曲线PC轨道梁的内力计算,预应力计算,应力计算及组合。

    The article have expounded the load acting on PC single track beam , and the calculation of curved PC single track beam including force , prestress and the stress etc.

  7. 本文利用ANSYS对高温下钢筋混凝土框架进行分析,得到其温度场、应力、内力重分布以及承载力的一些计算结果,并将这些计算结果与试验进行对比,取得较为理想的结果。

    In this thesis , reinforced concrete frames at elevated temperature was analyzed with ANSYS , which included calculations of temperature field , deformation , stress , internal force redistribution , post-fire ultimate loading . This calculations were compared with experimental result .

  8. 为了从理论上研究缝纫对复合材料层合板面内力学性能的影响,建立了纤维弯曲模型(FDM),并且分析了缝纫参数和几何参数对层合板等效模量和拉伸强度的影响。

    In this thesis the Fiber Distortion Model ( FDM ) is presented to analyze the effect of stitching and geometry parameters on the equivalent modulus and tensile strength of the stitched composite laminates .

  9. 内力计算包括弯矩、剪力和轴力三部分,它们的值由手工计算和PKPM计算共同进行;

    Endogenic force includes three parts : bending moment , shearing force and axle force , their value extracted by PKPM ;

  10. 第三章通过有限元软件Ansys分析试验模型,并与同尺寸的平板无梁楼盖有限元模型、密肋楼盖有限元模型、交叉梁有限元模型内力、挠度计算结果进行比较。

    In the third chapter , we made finite element analysis on the testing model by the finite element program ansys , and compared the internal force , deflection with the finite element modal of mushroom floor , joist floor and crossing beam system with the same size .

  11. 以500kV同塔双回路直线自立塔为例,研究了设置不同横隔面时结构的模态以及抗风内力与变形。

    Based on the design of a 500 kV double circuit tangent suspension tower , this paper analyzes the modal shapes and internal stresses and deformations of towers with different diaphragm arrangement subjected to wind loads .

  12. 本文将钢筋混凝土压力管道视为非匀质层合圆柱壳,利用经典层合理论和Reissner修正理论,分别得到了轴对称变形下挠度和内力的解析解。

    In this paper , the reinforced concrete pressure pipe is considered as a non-homogeneous laminated cylinder shell by using the lamination theory and Reissner 's reviseed theory respectively the analytical to the deflection and the bending moment under axially symmetric deformation is obtained .

  13. 对于非对称荷载,等效长度可取0.72S(S为半跨拱轴线弧长)、采用拱脚截面内力作为作用力;

    Take 0.72S ( the arc length of the arch axis ) as the equivalent length and the inner forces at the springing section as the acting forces when the arch loads are asymmetrical ;

  14. 拱脚支承条件对拱片内力的影响

    How Arch Footing Bearing Type Affects Internal Force on Arch Leaf

  15. 空心方块码头裂缝成因与内力研究

    A study of crack-forming causes and internal forces of hollow-block wharf

  16. 土层摩阻力对圆形隧道的结构内力分析研究

    Study of Internal Force of Ring Tunnel in Stratum Skin Friction

  17. 变刚度双向板内力的能量法计算

    Calculation of the STIFFNESS-VARYING two-way RC Slabs by using energy method

  18. 内力重分布设计法在躲水楼加固分析中的应用

    Reinforced Design for Avoiding Flood Building Considering Redistribution of Internal Force

  19. 软土地基中城门洞式放水洞的内力计算

    Internal Force Calculation of City-gate Section Channel in Soft Soil Foundation

  20. 获得振动过程中结构的内力、位移等数据。

    The displacement of structure and the internal stress was given .

  21. 曲线形平板的边界刚度、内力与变形

    The Boundary Stiffness , Internal Stresses and Strains of Curved Plates

  22. 斜支承曲线梁桥内力影响因素分析

    Influential Factor Analysis for Internal Forces of Skew Curved Beam Bridges

  23. 环形基础在竖直荷载作用下的内力计算

    Calculation of the Internal Stresses in Ring Foundation under Vertical Load

  24. 斜坡堤空心方块的内力分析

    Analysis of Internal Stress of Hollow Blocks for a Mound Breakwater

  25. 框架剪力墙的内力分析&三转角方程法

    Analysis of Frame Shear Wall Structures by Equations of Three Rotations

  26. 计算公路桥梁最大内力的动态规划法

    Analysis of the Maximum Stress of Highway Bridges by Dynamic Programming

  27. 现浇框架结构梁、柱、板协同工作体系的有限元方法及其内力特征

    Finite Element Method and Internal Forces of Cast-in-Place Girder-Slab-Column System

  28. 带刚域的十字交叉弹性地基梁的内力分析与设计(Ⅰ)

    Analysis and Design for Grillage Foundation with Rigid Area (ⅰ)

  29. 圆形断面隧洞衬砌内力分布的解析计算模型

    An Analytical Solution of Liner Internal Forces of Circle Tunnels

  30. 钢-部分预应力混凝土连续组合梁内力重分布研究

    Study on Moment Redistribution of Steel Partially Prestressed Concrete Composite Continuous Beams