膜污染
- 名membrane fouling
-
pH对膜污染层EPS污染特征的影响及机理分析
Mechanism analysis and influence of pH on fouling properties of EPS from membrane fouling layer
-
胞外聚合物EPS对MBR膜污染的影响
Effect of extracellular polymeric substances on membrane fouling of membrane bioreactor
-
EPS及其各组分都是膜污染的影响因素。
The EPS and its components are the influencing factors of membrane fouling .
-
泥水预分离MBR膜污染缓减效能研究
Membrane Fouling Alleviation Characteristics of Sludge / Water Pre-separation MBR
-
低温时污泥膨胀对MBR中膜污染的影响
Effect of Sludge Bulking on Membrane Fouling of MBR Under Low Temperature
-
MBR复合工艺膜污染及其清洗特征
Characteristic of Fouling and Cleaning of MBR Hybrid Process
-
但膜污染的存在,制约了MBR的进一步发展。
However , the membrane fouling restricts the further development of the MBR .
-
MBR膜污染阻力及清洗效果研究
Resistance and cleaning effect of MBR membrane fouling
-
在线反冲洗控制MBR膜污染的试验
Experiment on Online Backwashing to Control Membrane Fouling
-
不同混凝剂对RO膜污染影响的研究
Effect of Different Coagulants on RO Membrane Fouling
-
无机粉体改性PVDF超滤膜制备及膜污染机理的研究
The Preparation of PVDF UF Membrane Modifed by Inorganic Powder and Study on Fouling Mechanism
-
研究结果表明:投加PAC的吸附作用减少了由于胞外聚合物(EPS)而引起的膜污染;
Result shows that the adsorption effect of PAC reduces the membrane fouling caused by EPS .
-
丝状菌污泥膨胀对COD去除率影响不大,但对膜污染有严重影响,膜清洗周期缩短到7d。
Sludge filamentous bulking had little effect on COD removal , but great on membrane fouling .
-
MBR膜污染机理及其控制
Membrane Fouling and Control in MBR
-
一体式MBR控制膜污染的最佳曝气强度及影响因素
Optimum aeration strength and its influencing factors for membrane fouling control in an integrated membrane bioreactor
-
但是,膜污染给MBR技术的广泛推广带来了很大的阻碍。
However , the pollution of MBR membrane hinders the spread of the MBR technology greatly .
-
MBR处理生活污水试验中膜污染的清洗
Cleaning of membrane polluted and analysis of pollutants in a test for domestic sewage treatment by MBR
-
扫描电子显微镜(SEM)观察证明MBR系统在三阶段的膜污染层具有不同的水力学结构。
Observation using scanning electron microscope ( SEM ) showed different hydraulic structures for the membrane fouling layers in the three stages .
-
MBR的膜污染十分复杂并受到反应器的设计特点、操作模式和生物学因素的影响。
Fouling in MBRs is complex and influenced by MBR design features , mode of operation and biological factors .
-
在改善出水水质和缓解膜污染方面,PAC要好于硫酸铝。
In the aspect of bettering produced water and relieving transmembrane pollution , coagulant of PAC is better than AS .
-
进水NH3-N容积负荷、温度和pH值冲击对MBR出水水质影响不大,但低温会加速膜污染进程。
Inflow NH_3-N volume loading , temperature and pH value have little influence on MBR effluent , however lower temperature would accelerate membrane fouling .
-
但是,PES的强疏水性使其用于水处理领域时容易引发膜污染。
However , the hydrophobic nature of PES often causes fouling of the pure PES membrane in water treatment .
-
在传统的MBR研究和实践中,膜污染一直是限制其发展的瓶颈。
Membrane fouling is the bottleneck which limits its development in the research and practice of conventional membrane bioreactor ( MBR ) .
-
同时,分析EPS与污泥沉降性能、混合液粘度的关系,进一步研究EPS影响膜污染的途径。
Analyze the relationship between EPS and sludge settling characteristics , EPS and mixture viscosity , and then study how the EPS impact on membrane fouling .
-
膜污染阻力主要由凝胶极化阻力Rp和内部污染阻力Rif构成。
The membrane fouling resistance was mainly caused by polarization layer resistance ( Rp ) and internal fouling resistance ( Rif ) .
-
提高气水比可缓解膜污染。(2)气水比对MBR中EPS含量及其分布的影响研究。
The higher air / water ratio could alleviate membrane fouling . Secondly , EPS content and its distribution under different air / water ratio was studied .
-
根据膜污染的原因,寻求延缓膜污染,快速恢复膜通量的方法,成为推广MBR技术的关键所在。
The key of MBR technology is the methods of delaying membrane fouling , fast recovery method of flux , according to the causes of membrane fouling .
-
PAC-MBR组合工艺中膜污染及清洗方法的研究
Study on Fouling and Cleaning of Membrane in PAC Combined MBR
-
实验研究了pH值、温度和流速等操作条件对氨和酚去除效果的影响,膜污染和清洗方法,以及能源消耗评估等与工业化应用相关的几个实际问题。
Several aspects related to the commercial application were investigated in this study , including the influence of pH , temperature and velocity on the removal efficiency , membrane fouling and washing method , and the evaluation of energy consumption .
-
MBR反应器处理厌氧出水的研究,主要考察了水力停留时间(HRT)对反应器去除效果和膜污染的影响。
Study on the MBR reactor treating anaerobic effluent , and the effectes of hydraulic retention time ( HRT ) on organics removal efficiency and membrane fouling .