玻璃基复合材料

  • 网络glass matrix composites
玻璃基复合材料玻璃基复合材料
  1. 玻璃基复合材料基体裂纹行为和分布规律的研究

    Crack Behavior and Distribution in Matrix of the Glass Matrix Composites

  2. SiC纤维补强微晶玻璃基复合材料

    SiC fibre-reinforced glass - ceramic matrix composite

  3. SiC纤维/LCMAS微晶玻璃基复合材料的界面结合和力学性能

    Interfacial Bonding and Mechanical Properties of SiC Fibre / LCMAS Glass-ceramics Composite

  4. 轻质玻璃基复合材料的研制及性能分析

    The preparation and performance analysis of light glass-based composite

  5. 泡沫玻璃基复合材料对微波的损耗主要来自介电损耗,加入金属粉末能够提高泡沫玻璃的介电损耗,改善玻璃基体与空气之间的阻抗匹配,进而提高复合材料的吸波性能。

    Adding metal filler into foam glass could enhance dielectric loss of glass matrix and benefit impendence match between glass matrix and air , therefore microwave absorbing properties of composite was improved .

  6. SiCf/LAS玻璃陶瓷基复合材料的界面

    Interface of sic_f / Las glass-ceramics matrix composite

  7. 微孔挤压技术制备SiCw补强CMAS玻璃陶瓷基复合材料

    Preparation of SiC w reinforced CMAS glass_ceramic matrix composite by micro_ hole extrusion technique

  8. 采用真空热压烧结工艺制备了SiO2短纤维补强增韧的SiO2玻璃陶瓷基复合材料,研究了烧结温度和保温时间对其显微结构和力学性能的影响规律。

    SiO 2 fibre reinforced SiO 2 matrix composites were prepared by vacuum hot-pressing at different temperatures holding time , and their microstructure and mechanical properties were then investigated .

  9. 玻璃铝基复合材料高温压缩变形行为研究

    Hot Compressive Deformation Behavior of Glass / Aluminum Metal Matrix Composites

  10. SiCw/BAS玻璃陶瓷基复合材料的显微结构与力学性能

    Microstructure and mechanical properties of sicw / bas glass-ceramics composite

  11. 从而确定了制备玻璃基废弃物复合材料的较佳工艺条件。

    So the advanced technical conditions in manufacturing glass-based waste composite were gained .

  12. 短纤维玻璃陶瓷基复合材料的静疲劳行为

    Static Fatigue Behavior of Short Fiber Reinforced Glass-Ceramic Composites

  13. 此外,还对玻璃基废弃物复合材料的吸声性能进行检测和分析。

    Sound absorbing performance of glass-based waste composite were also tested and discussed .

  14. 研究了不同介质中单向短纤维增强玻璃陶瓷基复合材料的静疲劳行为。

    The static fatigue behaviors of unidirectional short fiber reinforced glass ceramic matrix composites under different medium were investigated .

  15. 短碳化硅纤维增强玻璃陶瓷基复合材料的弯曲应力-挠度曲线、以及断裂行为具有与长纤维复合材料类似的特征,其断裂方式为非灾难性断裂。

    The bending stress - flexibility , fracture behavior of short fibers composite are same as long fiber composite .

  16. 其中含有铅玻璃或基复合材料,除了在灯泡玻璃,釉火花塞的电气元件。

    Electrical components which contain lead in a glass or matrix compound except glass in bulbs and glaze of spark plugs .

  17. 研究了单向短碳纤维增强玻璃陶瓷基复合材料的氧化行为.结果表明:短碳纤维复合材料氧化随时间的变化符合抛物线规律,基体对短纤维的包裹在一定程度上减缓了后期氧化速率;

    The oxidation behavior of unidirectional chopped carbon fiber reinforced LAS ( Lithium Aluminosilicate ) glass ceramic matrix composite is studied .

  18. 单向短碳化硅纤维增强玻璃陶瓷基复合材料的主要增强机制为纤维脱粘、纤维滑移、纤维桥接、纤维断裂与纤维拔出。

    It is considered that the main strengthen mechanism are un-bonded , slip , bridge , fracture and pull out of fiber .

  19. 论文对几种绝热材料的性能进行比较,分析了绝热型玻璃基废弃物复合材料的性能优点、应用领域、市场前景、机遇和优惠政策。

    By comparison between the product and other insulation material , it was analyzed about its advanced properties , utilization field , market tendency , chance and policy conditions .

  20. 在应变速率为10s-1时,真应力-真应变曲线出现明显的波动,说明尽管玻璃/铝基复合材料的层错能比较高,仍可发生动态再结晶。

    At the strain rate of 10s-1 the true stress-strain curves exhibit oscillations apparently , this indicate that dynamic recrystallization can be happen , though there is the high stacking fault energy for Glass / Aluminium Metal Matrix Composites . 3 .

  21. 废弃玻璃/铝基复合材料的组织和性能

    Microstructure and mechanical properties of waste glass / aluminum metal matrix composites

  22. 基于电化学浸渗技术(ECI)在室温下制备了连续铜纤维、碳纤维和玻璃纤维增强铜基复合材料。

    Continuous-fiber-reinforced Cu matrix composites were fabricated based on the electrochemical infiltration technique ( ECI ) .

  23. 同时用搅拌铸造法制备玻璃/铝基废弃物复合材料更具有成本低、工艺简单的优点。

    Fabricating aluminum-glass composite by stirring cast is simple and low-cost .

  24. 玻璃纤维增强树脂基复合材料弯曲强度时间温度相关性

    Time-temperature dependence of flexural strength of glass fiber reinforced plastics

  25. 短切玻璃毡增强聚碳酸酯基复合材料研究

    Study on chopped glass fiber mat reinforced PC Composites

  26. 低局放玻璃纤维/环氧基复合材料实验研究

    Experimental study of glass fiber / epoxy matrix composites with low sectional electrion

  27. 玻璃纤维/聚合物基复合材料界面粘结强度的实验与理论研究

    Experimental and Theoretical Study on the Interface Bonding Strength of the Glass-Fiber / Polymer Matrix Composites

  28. 研究结果表明,将光固化技术用于制备玻璃纤维增强树脂基复合材料是完全可能的;

    The result showed that it is possible to prepare glass fiber reinforced composites with light-cured technology .

  29. 本文扼要介绍一些国家玻璃纤维及其树脂基复合材料的生产和需求情况。

    This paper illustrates the production and the demand of glass fibre and resin based composite material in some countries .

  30. 介绍了低局放、低介损的玻璃纤维/环氧基复合材料制造方法。

    A method of fabricating glass fiber / epoxy matrix composites with low sectional electrion and dielectric loss has been introduced .