烧结机

shāo jié jī
  • sinter machine;agglomerating machine
烧结机烧结机
  1. 烧结机机尾收尘系统的改造

    Modification of Dust Collection System at Sinter Machine Discharge and its Results

  2. 提高360m~2烧结机料层厚度生产实践

    Practice of Increasing the Bed Depth in 360 m ~ 2 Sinter Machine

  3. 24平米环式烧结机的PLC控制系统

    PLC control system for 24m ~ 2 ring sintering machine

  4. 基于VC带式烧结机新型星轮CAD系统开发

    The Exploitation of New-type Sinter Chain Sprocket CAD System Based on VC

  5. 新一代SD型烧结机

    Sd-type sintering machine of new generation

  6. 利用Falex试验机建立了评价烧结机润滑脂密封性能的试验方法。

    A test method is set up to evaluate seal ability of sintering machine grease with Falex tester .

  7. 为了使400m2烧结机生产水平尽快达到一个新的台阶,邯钢就优化400m2烧结机工艺参数进行了实验室研究。

    The process parameter of 400 m 2 sinter machine was optimized at Handan Steel .

  8. 吉林建龙钢铁公司新建90m~2烧结机装备先进,通过不断调整操作参数摸索出适合其原料条件的技术操作制度,利用系数短时间内达到1.97t/m2·h,作业率达到94.04%。

    By continuous adjusting operation parameters of the new-built advanced 90 m2 sintering machine , the technical operation system to fit its raw material conditions is worked out . As the consequence the utilization ratio reaches 1.97t / m2 . h and working ratio 94.04 % in a short time .

  9. 邯钢400m~2烧结机系统单辊破碎机BFT柔性传动装置结构分析

    Analyzing the structure of BFT flexible gearing of 400 m ~ 2 sintering machine in Handan Iron & Steel Company

  10. GDS-I型电火花烧结机研制

    The development of gds-i type spark sintering machine

  11. 在实验室条件下,探讨了烧结机扩容对烧结矿中FeO含量及烧结矿的转鼓强度的影响。

    Laboratory experiments are carried out in a sintering pot to simulate sintering machine , so that the influence of capacity expansion of sintering machine on the FeO content and drum index of sinter is studied .

  12. 韶钢Q345B连铸工艺的优化韶钢105m~2烧结机过程控制系统的设计与应用

    Design and application of process control system for 105 m ~ 2 sintering machine in Shaoguan Iron and Steel Co

  13. 本文首先对爆炸烧结机制作了简要的分析。然后利用叠加原理建立了对多元粉末激波参数的计算方法,计算了W-Ti二元粉末的激波参数。

    In this paper , the mechanism of explosive sintering is studied , and the shock wave parameters of the W-Ti powder compound by the superimposition principle are computed .

  14. 研究了涟钢40m2带式烧结机上试生产的酸性球团矿的矿物组成和结构。

    Synopsis This paper studies the mineral composition and microstructure of acid pellet produced with a 40 ? m 2 sinter strand at Lianyuan Steel .

  15. 介绍了韶钢105m2烧结机过程控制系统的构成及主要控制方式。

    Constitution and main control modes of process control system for 105 m ~ 2 sintering machine in Shaoguan Iron & Steel Group Co Ltd are presented .

  16. 对酒钢3号烧结机,在酸性小球团烧结矿生产实践过程中所暴露出的烧结负压过高、利用系数低及成品烧结矿中小粒级(5~10mm)含量高等问题进行了分析。

    The problems of too higher sintering suction , lower productivity and higher content of small size fractions ( 5 ~ 10mm ) in product sinters , that reflected during Jiu Quan I & S Co. ,№ 3 sinter plant operations for acid MPS production , were analyzed .

  17. 本系统已在济钢第二炼铁厂320平方米烧结机上投入了实际运行,使烧结机利用系数提高了0.3t/m2h,终点波动由7%降到3%。年创效益1400多万元。

    This system was already put into use in 320 sinter machine of Jinan Iron and Steel Corporation . The system can increase 0.3t/m2h in use coefficient and make BTP fluctuation decrease from 7 percent to 3 percent and bring 14 million RMB new benefits every year .

  18. 90m~2烧结机机冷工艺及生产实践

    90m ~ 2 sinter machine cooling process and its operation practice

  19. 烧结机自动化系统设计及旧系统改造

    The sintering machine automatic system design and the old system transform

  20. 热煤气在铅烧结机点火炉上的应用

    Application of hot gas for lighting-up furnace in lead sintering machine

  21. 本钢360m~2烧结机的生产实践

    Operating Practice of 360m ~ 2 Sintering Plant in BENXI STEEL

  22. 7035烧结机滑道密封润滑脂的研制

    Development of Slide - way Sealing Grease 7035 for Sintering Machine

  23. 邢钢180m~2烧结机小球烧结工艺技术

    Small pellet sintering process with 180 m ~ 2 sintering machine

  24. 烧结机边缘效应探讨

    Exploration and solution to the edge effect of the sinter strand

  25. 400m~2烧结机风箱支管风量控制装置的改造

    Modification of Wind Volume Controlling Device of Wind Box Branch Pipe

  26. 马钢三铁厂24m~2烧结机取消热筛工艺的设计和实践

    24m ~ 2 sinter plant without hot screen design and Practice

  27. 烧结机用重锤摆动板式密封装置

    Plate seal assembly with heavy swinging hammer in the sinter machine

  28. 张店24m~2烧结机高炉煤气点火的应用

    Igniting with full BF gas on 24m ~ 2 sintering machine

  29. 偶数齿带式烧结机的研究

    Research on a Sintering Machine with Even - number Teeth Sprocket

  30. 承钢150m~2烧结机布料系统的改进

    Improvement on feeding system of Chenggang 150m ~ 2 sintering machine