标准工况

  • 网络Standard condition
标准工况标准工况
  1. 在ANSYS中建立了某半高箱的有限元分析模型,并对其进行了标准工况下的强度和刚度计算;

    Finite element analysis model for certain half-height container was established under ANSYS environment , then strength and stiffness for this model under standard operating conditions was calculated .

  2. 计算结果表明,在ARI标准工况下,全新风回热型空调系统的制冷性能系数(COP)高于全新风空调系统2.3倍。

    From the calculation results , it is indicated that at the standard ARI conditions , the heat recovery system has a higher coefficient of performance ( COP ) than the full fresh system by 2.3 times .

  3. 在汽车空调试验台上,测试了标准工况下旋叶式汽车空调压缩机从启动到稳定过程中,吸排气温度、吸排气压力、制冷量及COP等参数随时间的变化关系曲线。

    The experiment is conducted on a test-rig of compressor for automobile air conditioner under standard air condition , and some parameters of the automobile air conditioner are measured during startup , such as suction and discharge temperature , suction and discharge pressure , refrigerating capacity and coefficient of performance .

  4. 房间空调器标准工况下的仿真模拟

    The Simulation of Room Air Conditioner in Standard Freezing Situation

  5. 非标准工况下空分设备增产氩的研究与实践

    Study and practice of increasing argon output from an air separation unit working under non-standard condition

  6. 通过样机设计,并在多功能焓差室标准工况下进行试验,由试验数据反推外螺纹管水冷冷凝器的管外平均冷凝换热系数。

    Through design sample equipment and experiment in multifunctional enthalpy-difference room , then average condensation heat transfer coefficient of external screw tubes water-cooling condenser from experiment data was deduced .

  7. 非标准工况下风机盘管及柜式空调箱选型计算的分析残疾人机会均等标准规则执行情况工作组

    Type Selections and Calculation of Fan Coil System And Chest-type Air-conditioning Case Working Group on the Implementation of the Standard Rules on the Equalization of Opportunities for Persons with Disabilities

  8. 实验结果显示,新气体冷却器的换热性能得到了提升,在标准工况55℃出水时,系统效率达到3.8。

    A series of contrastive experiments showed that the new gas cooler had a enhanced performance , and the system efficiency reached 3.8 when the hot water reached 55 ℃ .

  9. 在近标准工况、地下水源制冷工况和地下水源制热工况下,分别对样机进行了性能试验,结果表明:样机运行稳定、性能良好;

    Under standard mode , Groundwater-source refrigeration operating mode and Groundwater-source heat operating mode , carrying on performance test to the sample unit respectively , the result shows : The sample unit operates stably , performance are good ;

  10. 比较了ARI标准空调工况与中国名意空调工况的差异,从制冷循环和传热的角度分析了工况差异对蒸气压缩式水冷冷水机组满负荷效率的影响。

    Compares the difference between the stipulations in the ARI standard and the actual air conditioning performance under the special conditions in China .

  11. 针对这种小型的海水淡化热泵装置,以3.6kg/h的淡水产出率为设计参数,确定了该装置的标准运行工况,即冷凝温度、蒸发温度、海水的补充流量等。

    With the product water rate of 3.6kg/h as the design parameter , the device 's standard operation conditions were determined , i. e. , condensation temperature , evaporation temperation , sea water make-up flow etc.

  12. 在标准负载工况下,压差设定为1.7MPa时,系统工作比较理想。

    Further elaborated , a pressure difference of 1.7 MPa is critical to the standard loading condition .

  13. 而采用排气再循环+三效催化转换器方案以后,发动机的排放不但均达到了EUⅡ标准,有些工况甚至接近了EUⅢ标准。

    When EGR and the three way catalytic converter are combined to work , the emissions of engine reached not only the EU ⅱ standard , but also quite closing to the EU ⅲ standard in some conditions .

  14. 沥青混凝土搅拌设备标准理论试验工况的研究

    Study on Asphalt Concrete Plant Standard Theory Test Operating Mode

  15. 空调工况下非共沸制冷剂蒸发时的换热特性建立了制冷剂的冷凝换热模型,根据标准的空调工况确定了制冷剂的冷凝物性参数。

    Heat Exchanging Characters of Non-Azeotropic Refrigerants Evaporating with Air-Conditioning Operation Firstly , a model of refrigerants condensation was built , and refrigerants properties parameters were decided for the air-conditioning operation .

  16. 本文就工业用润滑油的分类、标准、使用工况条件及国内产品的研制、生产和应用情况做以全面的介绍,以期引导合理地使用润滑油。

    And the classification , standard and service conditions of industrial oil and the development , production and application of domestic products were overall presented so as to guide users to use reasonably lubricating oil .