扭矩

介绍了如何用51单片机及高层开发工具VISUALBASIC设计汽车中轴综合扭矩测试系统。

How to design a synthetical torsion testing system for automobile shaft by using singlechip and Visual Basic is introduced in this paper .

股骨BMD值与股骨最大扭矩值呈直线相关（r＝0.7415，P＜0.01）。

The BMD was linearly related to the torsion moment arm with the coefficient of 0 7415 ( P < 0 01 ) .

基于SOC和无线传输的扭矩仪的研制

Design of Torque Measure Instrument Based on SOC and Wireless Transmission

VC与Matlab混合编程方法在轧机扭矩监测中的应用

Application of Combined Programming with Visual C + + and Matlab in the Monitoring Torque of Rolling Mill

电位计式EPS扭矩传感器的设计与研究

Research on Potentiometer Type Torque Sensor for EPS

SPWM电源供电下低速大扭矩永磁同步电动机设计研究

Study on Low Speed and High Torque PMSM Design with SPWM Power Supply

基于ADμC812单片机的弹力扭矩测试仪

Elasticity Torque Instrument Based on AD μ C812 SCM

扭矩转化器（T/C）内部叶片流道流场的二维PIV实验研究

Measurement of the Internal Flow Field in a Torque-Converter by Two-dimensional PIV

分析了FRP对扭转轴试件的力学性能改善，扭矩的提高以及扭转变形的限制作用。

FRP is analyzed in improving the mechanical properties , increasing the torque and limiting the torsion deformation .

文内利用波高、长关系的系数K来调正扭矩计算值，得到较满意的结果。

In this paper coefficient K of wave height (?) length relationship is used to modify the calculation value of torsion and the result is satisfactory .

总结了钻时、扭矩、dc指数及Sigma指数在地层分层及岩性变化时引起的变化特征。

The author summed up the varying characteristics of RPM , Torque , dc exponent and Sigma during stratification and lithology changing .

在CCC中，采用了电流双幅值斩波技术，有效地降低了低速区扭矩的脉动。

Dual width of electric current cut technology in CCC was adopted .

研究结果表明，超细空心微珠加入到硬质PVC管材中，可以明显改善PVC硬管的加工流动性能，显著缩短塑化时间，降低最大扭矩。

Results show that the processability of cenospheres / PVC U pipe system is improved obviously , plasticizing time is shortened and the maximum torsinal moment is decreased .

应用CFD软件对涡轮钻具组的内流场进行了分析研究，重点讨论了模拟压降和扭矩。

The internal flow field of multi-turbine is studied by CFD software , and the simulated pressure drops and torques are discussed in this paper .

而Bi、Sn的扭矩与转速关系在低温区和较高的转速条件下明显偏离线性，表现出一定的非牛顿特性。

But those of Bi , Sn melts deviate from the linear relation obviously at low temperature and high rotate speed , showing Non-Newtonian characteristic .

通过在传统环锭纺细纱机上加装纺纱附件，研制出一种生产低扭矩纱（扭妥TM纱）的新型纺纱方法。

Put a attachment on conventional ring spinning frame , a lower torsion moment yarn ( Nu-Torque TM yarn ) was produced by this new spinning method .

DTY生产中残余扭矩的控制

Control of Residual Torque in DTY Production

本文探讨矩形和T形截面素混凝土梁受纯扭时，混凝土立方强度f（cu）和开裂扭矩Tcr之间关系。

This paper deals with the relationship between the cube strength of concrete fcu and the cracking torque Tcr for . rectangular and T-beams of plain concrete subjected to pure torsion .

HBM扭矩传感器在电机测试中的应用

Application of HBM Torque Sensor at Motor Test

在扭矩-扭角曲线上（见图3），可以看出DHS的抗扭刚度达55.39N。

From the torque curve ( figur 3 ), we can see the anti-torque rigid degree of DHS is 55.39N . angle .

TM-1型轧钢机主传动轴扭矩监测仪

TM-1 Type Torque Monitor for the Main Driving Shaft of Rolling Mill

国内外科研人员针对各种纱线的残余扭矩做过大量的研究工作，但未发现有关Tencel纱线残余扭矩及扭转定形方面的报道。

Many researchers in and abroad have studied the yarns ' residual torque , but seldom reports have been found on Tencel yarns .

通过热失重率、TGA、平衡扭矩和力学性能的测试，确定了氧化镁的最佳用量范围。

The optimum content of MgO was determined by thermal weight-loss rate , TGA , balance torque measurements and mechanical properties of POM , which showed the improved thermal stability of POM .

测量了发动机的转速、扭矩、点火提前角、燃料消耗量及排气温度、CO与HC排放等参数。

The speed , torque , power , specific oil consumption , spark timing , exhaust gas temperature and CO and HC emission concentrations of this engine were measured respectively at idle , constant speed and full load running condition .

通过取消整车加速过程的快油膜，用ISG电机为发动机提供补偿扭矩的方法，改善了加速过程的排放和动力性。

By canceling the fast fuel film and using ISG motor compensate the torque instead , emission and tractive performance are improved in accelerating condition .

主要内容如下：1.利用空心柱体式粘度仪中空心柱体所受扭矩与粘度成一定函数关系，研制了一种弹性空心柱体结构的光纤Bragg光栅空心柱体式粘度仪。

The main contents are as follows : 1.The use of hollow cylinder-type viscometer and the Suffered in the hollow cylinder torque and viscosity as a certain function . Developed a flexible hollow cylindrical structure of fiber Bragg grating hollow cylinder-type viscometer .

以腰椎扭矩大小和扭转强度来看，Isola椎弓根螺钉系统的抗扭能力方面是相当好的。

From the results of lumbar spine torque stiffness , Isola pedicle screw system has a very good torsional capacity .

用算符分解算法（AOM）研究了扭矩波动和时变啮合刚度对拍击门槛转速的影响。

A-operator method ( AOM ) is used to study the influence of the torque fluctuation and time-varying meshing stiffness on rattling threshold speed of the gear system .

应力衰减曲线采用突加一个10S-1的切变率，测量随后120s时间内的扭矩变化。

Torque-decay curve was measured within 120s by a sudden adding shear rate of 10s-1 . Viscoelasticity was measured with frequency scanning method .

本文通过便携式数显扭矩扳手，介绍SPI在便携式设备中的应用，主要解决便携式设备的体积以及功耗问题。使读者对于SPI通信接口有更深入的认识。

In this paper , we introduced the application of SPI ( Serial Peripheral Interface ) In portable device using the Digital Electronic Torque Wrench , In order to solve the volume and power problems of the portable device .