悬挂点

  • 网络suspension point;Hanging point;dangles
悬挂点悬挂点
  1. 用全站仪测量空中悬挂点三维坐标方法的尝试

    Experiment for Locating Three-dimensional Coordinate of Hanging Point in Air with All-station Instrument

  2. 重心大概是在这里,低于悬挂点的地方。

    Center of mass is way here below the suspension point .

  3. 汽车排气系统振动模态分析及悬挂点优化

    Vibration modal analysis and hanger location optimization of automobile exhaust system

  4. 经过模态分析,初步确定悬挂点布置方案。

    The original hanger location is set by the modal analysis .

  5. 多绳提升箕斗悬挂点钢丝绳张力变化规律分析

    Analysis of Rope Tension at Skip Suspension of Friction Winder

  6. 将平均驱动自由度位移用于汽车排气管悬挂点的优化布置。

    Average driving DOF displacement is applied to optimize vehicle exhaust pipe hanger locations .

  7. 重心在悬挂点下面。

    Center of mass below the suspension point .

  8. 汽车排气系统悬挂点优化

    Optimization of Vehicle Exhaust System Hanger Location

  9. 所以物体的重心,经常处于悬挂点之下。

    So the center of mass will always find itself below the point of suspension .

  10. 线天线大吊索悬挂点几何位置的一种近似解

    A New Method to Determine Approximate Geometric Positions of Suspension Points on Rope Sling of Wire Antenna

  11. 物体的重心自动调节,它走到了,悬挂点下面,处于完全稳定状态。

    So the center of mass rearranges itself so that it goes under the point of suspension and is completely stable .

  12. 根据舵面悬挂点与摇臂操纵形式的不同,提出了四种连接方式的局部模型。

    Based on different forms of hinge points and rocker-arms , four local models of control surface linkage forms were proposed .

  13. 而重心-,你们可以看到-,在悬挂点下方。

    But the center of mass you see it when I balance it on my finger is way below the suspension point .

  14. 通过测取座椅和座椅悬挂点的自动率谱和传递函数,分析了该机座椅的动态特性。

    Through measuring self-power spectrum and transfer function of the seat and place to hang the seat , dynamic characteristic of the tractor seat is analysed .

  15. 但是基本概念是,物体的重心将一直,处于稳定的结构线上,在悬挂点下面。

    But the basic idea is , then , that the center of mass will always in stable configuration line itself up below the point of suspension .

  16. 随着我国特高压输电线路的大规模建设,输电线的直径、单位长度重量都有所增大,悬挂点高度也有所增加,使得输电线路更容易产生微风振动。

    With the large-scale construction of high-voltage transmission lines in China , the wind vibration is prone to occur due to the increasing of the line diameter , the gravity per length and the suspended height .

  17. 在二维平面内应用悬垂线方程式计算边吊索上各悬挂点的坐标,应用力矩公式修正以上计算结果,确定各振子线的长度。

    Firstly , the coordinates of suspension points on the side rope sling can be obtained in two-dimensional plane by the suspended-cable equations , and their ordinates are corrected by the moment equations , then the lengths of antenna wire segments are determined .

  18. 文章针对上述3种情况,以大跨越档低悬挂点为坐标原点,推导出架空线索悬垂函数和弧垂函数。

    In view of the previous three cases the paper has derived the suspense sagging function of overhead wire ropes and sag function for the overhead wire ropes , taking the lower suspension point of the large crossing span as the origin of coordinate .

  19. 首先应用悬垂线方程式求出各悬挂点的坐标,然后根据吊索自重沿其轴线全长均匀分布的假定,应用力矩公式修正各点纵坐标。

    Firstly , the coordinates of suspension points can be obtained by the suspended-cable equations , and then their ordinates are verified by the moment equations on the basis of the assumption that the dead weight of rope sling is evenly distributed along its whole axis .

  20. 全悬挂多点啮合柔性支承传动系统频率响应分析

    Frequency response analyses for a Fully-Mounted multiple-point meshing mechanism with flexible supports

  21. 全悬挂多点啮合柔性传动动态响应的数字仿真

    Digital Simulation of the Dynamic Response in a Flexible Drive with Fully-mounted Multi-point Meshing

  22. 用自由悬挂、单点激振多点拾振法进行模态试验,CADA-X软件辨识模态参数,结果验证了结构隐含的薄弱环节。

    Modal test is carried out by means of free hanging , single vibration excitation and multiple-vibration picking up . The model parameters are identified by CADA-X software . The test results verify the weak links included in the structure .

  23. 绥中36&1单点悬挂铸钢吊点修复中的焊接技术和质量控制

    Welding Technique and Quality Control of Steel Casting Lifting Point on the Yoke Repairing for SZ 36-1 Field

  24. 用自由悬挂和单点激振多点拾振的模态试验方法,获得了该结构的模态参数。

    Based on modal experiment with free hanging , single input / multi-output methods , the modal parameters of HWT are identified .

  25. 本文对12根螺栓球节点网架杆件试件,12个悬挂吊车吊点试件及两榀螺栓球节点桁架试件进行了静力及疲劳试验。

    In this paper , the static and fatigue tests of 12 bar specimens used in space grid and 2 truss specimens , all with bolt sphere joints , as well as 12 specimens of suspenders connecting crane rails to space grid joints have been reported .