飞秒激光器

简要介绍了在飞秒激光器中提供自启动机制的半导体可饱和吸收镜（SESAM）的主要功能特点以及相关膜层结构的发展过程；

This paper introduced the main characterstics and relative development process of the thin films constructions of semiconductor saturable absorber mirror , which supported the self starting mechanism in the femtosecond lasers .

全固化飞秒激光器研究进展

The Survey of All Solidstate Femtosecond Lasers

实验研究了基于Yb，Na：CaF2激光晶体的飞秒激光器。

A Yb , Na : CaF2 femtosecond laser is experimentally investigated .

低泵浦功率自启动KLM锁模钛宝石飞秒激光器

Low Pump Power Self-Starting KLM Ti : Sapphire Femtosecond Laser

采用时间分辨四波混频方法，用钛宝石飞秒激光器测量了掺Al的纳米Si-SiO2复合薄膜的光学非线性特性。

The nonlinear optical properties of Al-doped nc-Si-SiO2 composite films have been investigated using the time-resolved four-wave mixing technique with a femtosecond laser .

分别借助掺钛蓝宝石飞秒激光器和YAG皮秒激光器对其性能进行了实验评价。

Also , experimental evaluation of its characteristics , including the time resolution and dynamic range , has been made by means of Ti : Sapphire femto-second laser and YAG pico-second laser , respectively .

补偿Yb：glass飞秒激光器色散的G-T干涉仪设计

Design of G-T Interferometer to Compensate Dispersion of LD-pumped Yb : glass Femtosecond Lasers

本文报道了由CPM飞秒激光器产生的45fs光脉冲，最优化激光器设计提供了稳定可靠的激光器运转，还报告了激光器的各种参数。

We report the generation of 45 fs light pulses from the CPM femtosecond laser . The optimized laser design provides the steady and reliable laser operation . Laser parameters are also reported .

基于传统的钛宝石飞秒激光器，提出了可产生稳定的1μm波段可调谐飞秒激光的新型注入式飞秒光参量放大（OPA）系统。

A novel injective femtosecond optical parametric amplifier ( OPA ) is developed , which can produce tunable femtosecond laser with central wavelength at 1 μ m , based on the traditional Ti : sapphine laser .

可用于钕玻璃激光系统的自锁模飞秒激光器

Kerr-Lens Mode-Locked Femtosecond Laser for Nd ∶ Glass Laser Amplifier System

多通长腔飞秒激光器的稳定性分析与计算

Stability Analysis and Calculation of the Femtosecond Laser with a Multiple-pass Cavity

双色交叉锁模钛宝石飞秒激光器

A bicolor cross mode locked Ti : sapphire femtosecond laser

用于量子通信的飞秒激光器的理论与实验研究

The Theory and Experiment Research of Femtosecond Pulse Laser in the Quantum Communication

钛宝石飞秒激光器的锁模机理探讨

Investigation of Ti : sapphire femtosecond laser mode-locking mechanism

三以高重复率飞秒激光器为光源，成功建立一套飞秒激光细胞显微操作实验样机。

The femtosecond laser microscopy manipulation system was realized .

双腔双波长交叉锁模钛宝石飞秒激光器的研究

Experiment on dual cavity dual wavelength cross mode locking ti ∶ sapphire femtosecond laser

飞秒激光器产生等离子体中电子剩余能量的研究

The Study of the Electronic Residual Energy in the Plasma Produced by the Femtosecond Lasers

飞秒激光器的相位薄膜

Phase Films for Femtosecond Lasers

集成超快光纤激光器被认为是显微技术中的第二代飞秒激光器。

The compact ultrafast fiber lasers are described as the second generation of femtosecond lasers for microscopy .

提出使用飞秒激光器的光学频率梳测量绝对距离的方法。

The method of measuring absolute distance with the optical frequency comb of a femtosecond laser was proposed .

全固化自锁模飞秒激光器实验研究

All-solid-state Self-mode-locking Femtosecond Lasers

用飞秒激光器测试了八种引发剂在三种溶剂中的双光子荧光光谱，发现五种化合物能发出强蓝紫光；

Two-photon fluorescence ( TPF ) spectra of eight compounds in three solvents were collected under femtosecond laser pulses .

飞秒激光器将极短且强的光脉冲传送到一片石英上以刻录数据。

To record data , a femtosecond laser delivers extremely short and intense light pulses onto a piece of quartz .

此系统主要包括：飞秒激光器系统、光学系统、信号采集系统和控制系统。

This experimental system includes a femtosecond laser system , an optical system , a signal collection system and a control system .

红宝石激光显微照射仪通过数值计算模拟了掺钛蓝宝石飞秒激光器谐振腔中光斑和脉冲宽度在自锁模过程中的演变。

The evolution of beam size and pulse duration in a cavity of Ti : sapphire femtosecond laser is presented by means of simulated calculation .

以薄膜光学的干涉理论和衍射光学的傅里叶模式理论为基础，给出了0·8μm飞秒激光器用多层介质膜脉宽压缩光栅的理论设计；

Based on optical interference theory and Fourier modal theory , a new multi-layer dielectric gratings is designed for use in femtosecond laser system at wavelength 0.8 μ m.

飞秒激光器系统是整个实验系统的光源，由飞秒光纤激光器、倍频器和温度控制器组成。

The femtosecond laser system , as the light source of the experimental system , consists of a femtosecond fiber laser , a frequency multiplier and a temperature controller .

利用具有极高脉冲光强的飞秒激光器和对光束进行强聚焦的显微镜装置可以制造具有亚微米精度的三维微器件以及进行三维高密度信息存储。

By use of the femtosecond laser with extreme high pulse intensity and the microscope with high numerical aperture , it is possible to fabricate the three dimensional microdevice and to process three dimensional optical data storage .

而飞秒激光器的广泛使用和飞秒光谱学的日臻完善使人们对新型材料中的超快动力学过程的探测成为可能。

With the wide utilization of the femtosecond laser system and the great achievement in the field of the ultrafast spectroscopy , ultrafast processes of the novel material can now be investigated in the picosecond and femtosecond domains .

在国内我们已经首先研制成功了全光纤飞秒激光器，但平均输出功率只有几十毫瓦，包层泵浦技术的成熟，无疑给其进一步放大功率提供了技术保障。

We have firstly developed the all fiber femto-second laser , but its average output power is only tens of milliwatt . With the development of cladding pumped technology , it is the efficient way to amplifying the output power .