铅锑合金

这一规律对指导发展粗铅锑合金结晶分离连续工艺与设备具有重要的意义。

The law obtained has great importance to develop the continuous process and equipment of crystallization to separate Pb-Sb alloy .

铅锑合金和铅钙合金电极过程的研究

Study of the Electrode Processes of Pb-Sb and Pb-Ca Alloys

铅锑合金的预处理及锑、硒的ICP-AES法测定

Pretreatment of Lead-Antimony Alloy and Determination of Antimony and Selenium Using ICP-AES

HCl-NaCl浸出铅锑合金氧化吹炼渣过程中锑的浸出动力学

Kinetics of Antimony Leaching from Oxidizing-Converting Slag of Pb - Sb Alloy by HCl-NaCl

用液-固多相反应的收缩未反应核模型研究了在HCl-NaCl浸出铅锑合金氧化吹炼渣过程中锑的浸出动力学。

The kinetics of antimony leaching from oxidizing-converting slag of Pb-Sb alloy by HCl-NaCl was approached using the shrinking unreacted core model for the reaction of liquid ? solid .

铈对铅锑合金电化学性能的影响

The effect of Ce on the performance of lead - antimony alloys

空间微重力环境下铅锑合金的研制

Processing of plumbum-stibum alloy under microgravity environment in space

因此稀土铅锑合金可以用作免维护铅酸蓄电池板栅合金材料。

Thus the alloys could be used as the grid material of maintenance-free lead-acid batteries .

本文通过理论分析，确定了结晶法分离铅锑合金的可行性。

In this article , the separation feasibility of Pb-Sb alloy through crystallization was discussed by theoretical analysis .

稀土铅锑合金的性能

Performances of Pb-Sb-RE alloys

在铅锑合金中添加银可降低合金阳极膜的生长速度。

The addition of silver to the Pb-Sb alloy may decrease the growth rate of the said anodic film .

高铅锑合金深加工及锑铅综合利用

Further processing of sb Pb alloy with high lead content and comprehensive utilization of sb and Pb in the alloy

结果表明：富铈稀土能细化铅锑合金晶粒，薄化晶界，减少危害性大的晶体裂痕，降低整体腐蚀速度和腐蚀的危害性；

The results show that the addition of Ce rich rare earths minish the crystal grain and thin the grain boundary ;

采用循环伏安法、腐蚀失重法、交流阻抗法研究了铈对铅锑合金板栅电化学性能的影响。

The effect of Ce on the performance of lead antimony alloy was studied by use of cyclic voltammetry , corrosion weightlessness and impedance spectrum .

交流阻抗测试的结果表明，铅锑合金经过熔体结构转变形成的钝化层稳定性增强，合金的耐腐蚀性能得到了提高。

The EIS results showed that since the stability of anode passivation layer was strengthened , the corrosion resistance of lead-antimony alloy was improved . 3 .

综述了近年来国内外铅酸蓄电池板栅材料的研究热点，主要集中在低锑的铅锑合金和铅钙合金两个系列。

The recent trends on grid materials of the lead-acid battery were introduced , mainly on the lead-antimony alloy with low antimony and the lead-calcium alloy without antimony .

在实验室条件下，熔盐电解分离铅锑合金可以获得含铅约0.07%的金属锑，不但技术可行，而已经济指标也是满意的。

It has been found that in laboratory scale metallic antimony containing 0.07 % Pb could be obtained by fused-salt electrolysis . The technical and conomic indexes are satisfactory .

本文介绍了铅锑合金分离的几种方法，指出了其存在的不足并提出了改进措施。

Several methods of separation of lead-antimony alloys have been introduced in this paper . Problems in these methods are pointed out and measures to solve them are discussed .

摘要：结晶法作为一种分离铅锑合金的新方法，具有工艺流程短、能耗低、金属损耗量小、清洁环保等特点。

Abstract : Crystallization separation is a new method to separate Pb-Sb alloy , which has such advantages as shorter process , low-energy consumption , less metal wastage and environmental friendly .

以广西某冶炼厂含3%～10%的高铅锑合金为原料，以综合利用该合金中的锑铅来开发多种产品为目的，进行了锑品深加工的试验研究。

Using Sb Pb alloy containing 3 % ￣ 10 % Pb produced by some smelters in Guangxi as raw materials , further processing on antimony products has been studied as to develop a series of products .

结果表明，铈的添加有助于改善铅锑合金腐蚀层结构，对合金的耐腐蚀、电化学稳定性产生好的影响。

The results show that the addition of Ce is helpful to modify the corrosion layer structure of lead antimony alloys . At the same time it has a good effect on the anti corrosion and electrochemical stability .

分别采用定向结晶分离和利用温度梯度的结晶分离两种方法分离铅锑合金，结果表明：（1）提升结晶对铅锑合金的分离效果明显高于下降结晶对铅锑合金的分离效果。

Both directional crystallization separation and temperature gradient crystallization separation were used to separate Pb-Sb alloy respectively . The results indicated that : ( 1 ) The separation efficiency of lifting crystallization was obviously better than that of falling crystallization .

采用铅锑镉合金板栅的利弊

Advantages and disadvantages of Pb-Sb-Cd grid alloy used for lead-acid batteries

火试金测定锡铅金锑合金中金含量

Determination of Gold Content in Tin-Lead-Gold-Antimony Alloy by Fire Assay Method

原子吸收法测定铅锑锡合金中的铜

Measuring copper from lead-antimony-tin alloy by atomic absorption method

铅锑锡合金铸件精密成形技术研究

Research on the Technology of Pb-Sb-Sn Alloy Exact Molding

本文主要研究了铸造铅锑锡合金的超声检测方法。

The method of ultrasonic testing for casting of PbSbSn alloy is mainly studied in this paper .

铅镉锑合金的研制

Preparation of Pb-Cd-Sb Alloy

对高锑合金、普通低锑合金、再生铅低锑合金进行了对比试验与讨论。

The high-antimony alloy , regular low-antimony alloy and secondary lead Low-antimony alloy have been compared in different experiments .

提出了一种以锌钙系磷化液为主体的铅-3%锑合金电化学磷化新工艺。

A kind of electrochemical phosphating method was employed to lead-3 % antimony alloy in the phosphating solution of calcium-zinc series .