谐振器

SOA光纤环形腔激光器和微环谐振器可用来实现光阈值门功能。

SOA fiber ring lasers and micro-ring resonator can be used for OTF .

石英谐振器力频特性的ANSYS分析及实验对比

ANSYS analysis and experiment comparison of the force-frequency characteristics of quartz resonator

本文描述了高Q值超导空腔谐振器的性能。

The properties of high Q superconducting cavity resonanlor is described .

PLC和触摸屏在石英晶体谐振器组装系统中的应用

The application of PLC and touch - panel in the crystal resonance assembly system

超导条状微带谐振器品质因数Q0的计算

Calculation of unloaded quality factor q_0 for superconducting stripline resonators

极高Q值高温超导微波谐振器的研制

HTSC Microwave Resonator with Extremely High Q - values

变容管调谐的X波段介质谐振器GaAsFET振荡器

Varactor Tuned Dielectric Resonator GaAs FET Oscillator In X & Band

介质谐振器在微带电路中无载Q值的测量

The Measurement of Unloaded Quality Factor of a Dielectric Resonator Coupled to a Microstrip Line

K波段单片硅MEMS谐振器

K Band Silicon Monolithic MEMS Resonator

利用SAW表面传播的性质可以制作包括延迟线、带通滤波器、卷积器、谐振器、振荡器和匹配滤波器。

To utilize property of SAWs propagating , it can be made including delay lines , passband filters , oscillators and pitch filters .

根据SAW谐振器谐振频率的计算公式，可以求出表面力负载与SAW谐振器的谐振频率之间的变化关系。

With the formula of resonant frequencies , the variation relationship between the exerted force and resonant frequency of SAW resonator is obtained .

分析非均匀填充圆柱介质谐振器的二阶精度FDTD公式

Second-order accurate FDTD equations for analysis of cylindrical dielectric resonators

TV用压电陶瓷滤波器的片式化最终研制出频率精度高、温度特性好的片式压电陶瓷谐振器。

The SMD Piezo-ceramic Filter for TV Sets The testing results indicate that these chipped devices have high frequency precision and good temperature property .

PZT压电陶瓷谐振器用银电极浆料

The Silver Paste Applied to PZT Piezoelectric Ceramic Resonator

本文实现了一种利用有源Q倍增谐振器稳定振荡器的自动频率控制系统。

An AEC system has been realized in which an active Q-multiplied resonator is used to stabilize the crystal oscillator .

介质谐振器反馈型GaAsFET振荡器

A GaAs FET Oscillator with a Dielectric Resonator Feedback

此法尤其适用与微带线相耦合的介质谐振器的Qu值的确定。

This method is especially suitable for the determination of Qu of the dielectric resonator coupled to a microstrip line .

AlN薄膜体声波谐振器的制备与性能分析

Fabrication and Performance Analysis of AlN Film Bulk Acoustic Resonator

测试结果证明，SC切晶体谐振器确实比AT切的具有更多的优点。

Measurement results have shown that the SC cut crystal has an advantage over AT cut .

低相位噪声声表面波压控振荡器的实现主要依赖于低损耗、高Q值的声表面波谐振器和低噪声振荡器电路。

Low phase noise VCSO depends on the realization of low loss , high Q value SAW resonator and low-noise oscillator circuit .

由两个SAW谐振器组成差动式测量结构，具有较高的灵敏度，并减少了温度对测量结果的影响，对迟滞效应带来的误差有一定的补偿作用。

A difference frequency measurement structure between two SAW one-port resonators has a high sensitivity and a little temperature impact . It also can compensate the hysteresis errors .

SOI新结构制备及SOI基悬浮式薄膜谐振器的研制

SOI Novel Structure Fabrication and Investigation of Suspended Type Thin Film Resonator Based on SOI

此外，也详细介绍了阶梯阻抗谐振器（SIR）的原理、基本结构、谐振条件和寄生通带设计方法。

In addition , also it in detail discusses the SIR principle , basic structure , the resonance conditions and spurious band design method .

该结构与普通的加载型腔体滤波器相比，谐振器长度可以极大缩短，腔体也能保持比较高的Q值。

Comparing with general load cavity filter , the length of this resonator is maximum shorted , and the cavity can be kept higher Q.

分析了SAW谐振器表面力负载对谐振器谐振频率和机械损耗产生的影响。

The variation of the resonant frequency and the mechanical loss of SAW resonators are analyzed while there is force directly applied on the surface of an SAW resonator substrate .

介绍了一种基于单端同步谐振器、采用电测试方法实现漏波COM参数的提取技术。

These COM model parameters are determined by using a new technique based on admittance measurements of a one port synchronous resonator .

利用W波段高Tc超导-介质谐振器测量YBa2Cu3O（7-x）薄片的毫米波表面阻抗

Millimeter wave surface impedance of yba_2cu_3o_ ( 7-x ) sheets measured by a high-t_c superconducting-dielectric resonator at W-band

为了研究表面力负载对SAW谐振器性能影响，进行了将质量块通过力传递机构分别产生沿垂直和平行于SAW传播方向分布的力加载在基片表面的实验。

Through a force transfer mechanism , mass blocks are applied on the substrate surface , and generate forces along the directions either perpendicular to or parallel to SAW propagation direction .

该振荡器主要是由一个FET放大器及一个独立的介质谐振器反馈电路结构组成。

The oscillator consists of a FET amplifier and a independent dielectric resonator feedback construction .

通过在地板上的矩形槽的边缘开槽和在馈线旁加载C形谐振器，该天线实现在中心频率3。

By inserting a slot at the edge of the rectangular slot on the ground plane and loading a C-shaped resonator near the microstrip line , dual band-notched characteristic at the central frequency at3 .