被测要素

  • 网络toleranced feature
被测要素被测要素
  1. 最大实体要求应用于被测要素评定方法研究

    Study on the Evaluation of Maximum Material Requirement Based on Measured Feature

  2. 揭示了剪移对被测要素以及相关量的影响;

    This paper is revealed the influences of shear on the measured features and the relative quantities .

  3. 操作软件进行图像处理,提取钻尖图像中被测要素的角点坐标,进而计算出被测钻尖的几何参数。

    Operating software for image processing and Collecting the coordinates of image Corner points , then can calculate the geometric parameters of drill point .

  4. 对被测要素、基准要素在应用最小实体要求时,尺寸公差与形位公差相互补偿问题进行计算分析。

    We calculate and analyze the mutual compensation between size tolerance and form & position tolerance while applying the minimun material requirement to the tested essential factors and standard key elements .

  5. 当被测要素为轴线、中心线或对称平面时,指引线的箭头和基准符号应与该要素的尺寸线对齐。

    If the element being tested with tolerance requirements is an axis , centre line or symmetrical plane , the arrow and datum symbol should be aligned to the dimension line of that element .

  6. 当具有公差要求的被测要素为线或平面时,将指引线箭头和基准符号指在线或平面上,且必须与尺寸线错开。

    If the element being tested with a tolerance requirement is a contour line or surface , point the arrow and datum symbol to the contour line or surface , and keep it away from the dimension line .

  7. 并在采集图像上完成被测几何要素的初始定位,再确定几何量边缘点且按不同最优化指标对其拟合,得到检测量的几何描述。

    After the measured geometrical elements were localized initially in gathering image , the edge points of geometrical quantity were confirmed and curve was fitted according to the different optimization indexes to get the geometrical description of detection quantity .

  8. 采用合适的装置将被测工件的光学图像转换成数字信号,进一步对其分析以得出有关被测要素的数值,可以明显地提高检测效率和检测适应性。

    Convert optical image of measured workpiece into digital signal using proper device , then obtain numeric value related to measured workpiece under further analysis , the test efficiency and adaptability can be improved obviously .