耐溶剂性

  • 网络Solvent resistance;MEK
耐溶剂性耐溶剂性
  1. 采用该交联体系,可显著提高涂膜的耐水性、耐溶剂性、光泽度及硬度,DAAM的用量以占总单体质量的6.5%为好。

    Adoption of this crosslinking mode could markedly improve water resistance , solvent resistance , glossiness and hardness of the film . 6.5w % DAAM out of total monomer mass was preferred .

  2. 改性聚氨酯乳液的热稳定性、耐水性和耐溶剂性明显提高。

    The thermal stability , water resistance and solvent resistance have been greatly improved .

  3. 将PECT共聚酯与PC形成合金可以提高PC的耐溶剂性和耐环境应力开裂性。

    Blending with PCTG may enhance PC ductility and its resistance to solvent stress cracking .

  4. 另外,实验也考查了PVA含量、交联剂尿素的用量对涂膜耐溶剂性、剥离强度以及结构的影响。

    The influences of PVA content and cross linking agent on solvent ( resistance ), peeling strength and structure were also studied .

  5. 可望得到加工性能良好、耐溶剂性较好的改性PES。

    It was expected that the modified PES with high solvent resistance and good processability could be prepared .

  6. 聚乙烯(PE)由于具有优异的力学强度、耐溶剂性、化学稳定性、热稳定性及价廉易得等特点,已成为目前应用非常广泛的聚合物膜材料之一。

    High density polyethylene ( HDPE ) is one of the widely used membrane materials due to its good mechanical strength , thermal and chemical stability , and radiation resistance .

  7. 结果表明,具有核壳结构的PUA乳液耐溶剂性、热性能和机械性能比水性PU有明显的提高。

    The results show that solvent resistance , thermal and mechanical properties of emulsion-cast film are apparently improved , compared with aqueous polyurethane .

  8. 当纳米SiO2质量分数为0.03时,NR/LDPE弹性体的力学性能最好,并且具有较好的耐溶剂性、耐热变形性能和热塑性能。

    When the mass ratio of nano-silica was 0.03 , NR / LDPE TPV had the best mechanical properties , the resistance to thermal distortion , resistance to solvent and the thermoplastic was fairly good .

  9. 所合成的颜料的应用性能测试表明,DPP类高性能颜料在耐溶剂性、耐热稳定性等方面性能较好。

    The application performance shows that compared with traditional azo pigments , DPP are good at the performances like solvent resistance and thermal stability .

  10. SEBS/PP共混物具有较高的使用温度和良好的耐溶剂性,共混后韧性得到了提高,同时加入PP后能提高SEBS的加工性能。

    SEBS / PP blends the use of high temperature and good solvent resistance , blends toughness improved , at the same time , after joining PP can improve the processing properties of SEBS .

  11. 与相似分子量的线性丙烯酸酯齐聚物相比,DAO粘度低,用作紫外光固化树脂,其固化速度快,且固化产物硬度好,耐溶剂性好。

    Compared with traditional linear acrylate oligomers with similar molecule weight , DAO had lower viscosity and higher curing speed when used as UV curable resin , as well as the cured products had high hardness and good solvent resistance .

  12. OIS经成型和干燥后即可方便地形成耐溶剂性的有机无机杂化高分子材料,如透明薄膜和高弹纤维。

    The OIS , after molding and drying , gives easily transparent , solvent resistant membrane and high elastic fiber , those are actually the organic inorganic hybrid polymers .

  13. 用乳液聚合的方法,制备了丙烯酸酯改性的水性聚氨酯共聚乳液(PUA乳液),并对PUA的耐溶剂性、热性能和机械性能进行了初步的研究。

    Copolymer emulsion of aqueous polyurethane modified by acrylic with core-shell structure has been prepared by emulsion copolymerization , and solvent resistance , thermal and mechanical properties of PUA have been studied .

  14. DPP系列颜料为高性能有机颜料的重要组成部分,具有着色力高、耐溶剂性强、耐热稳定性优异等诸多优点。

    DPP pigments are one of the most important parts for high performance pigments , with many advantages such as high color strength , strong solvent resistance and excellent thermal stability .

  15. 二元聚酰胺的加入可加速TPV中塑料相的结晶速率、减小其晶粒尺寸、增大结晶度,从而显著提高TPV的100%定伸应力及耐溶剂性。

    Could increase crystallization rate and crystalline degree of the plastics phase in TPV and reduce its crystal size . Therefore not only the solvent resistance but also the stress at 100 % of TPV with polyamide 66 / 6 copolymer was improved .

  16. 优良的耐溶剂性、耐磨性,中等的柔韧性。

    Good solvent and abrasion resistance , medium flexibility .

  17. 耐溶剂性:使用时溶剂类型及接触时间。

    Solvent resistance : the use of solvents and type of contact time .

  18. 聚合物基无机颜料色母粒有着比有机颜料色母粒更好的热稳定性、光稳定性及良好的耐溶剂性。

    Polymer / inorganic pigments color master batch has better thermostability 、 photostability and solvent resistance .

  19. 大多数水性聚氨酯涂膜耐水性、耐溶剂性等较差,限制了其应用范围。

    However , most of the aqueous polyurethane membrane is bad water and solvent resistance , which limits its application .

  20. 对乳液膜性能的研究结果表明,采用这种方法改性后的丙烯酸酯乳液的耐水性、耐溶剂性、断裂强度、断裂伸长率均得到提高。

    The film properties of hybrid emulsions such as water resistence , solvent resistence , tensile strength and elongation properties are discussed .

  21. 本文介绍了几种赋予非织造布防水性、耐溶剂性和阻燃性的聚合物乳液。

    The paper introduced a variety of polymer emulsions which can provide aqueous and solvent resistance and flame retardant properties for nonwovens .

  22. 在氟涂料中拼合一定量含羟基丙烯酸树脂,可有效提高涂层的耐溶剂性和耐沸水附着力,以扩大常温交联型氟涂料的应用范围。

    Fluoro Coatings incorporated with acrylic resin containing hydroxyl can effectively improve its properties of solvent and boiling water resistance so as to further its application .

  23. 通过改性可以提高水性聚氨酯的耐水性、耐溶剂性和物理机械性能,拓宽水性聚氨酯的应用领域。

    The objective of modifications is to improve water and chemical resistance and physical and mechanical properties oi aqueous polyurethane , and widen the areas of application .

  24. 通过红外光谱、扫描电镜、差示扫描量热仪对微胶囊的化学组成、形貌和蓄热性能进行了表征,测试了其耐热和耐溶剂性。

    Chemical composition , surface morphology and thermal energy storage of the MEPCM were studied by FTIR spectrum , scanning electron micrograph and differential scanning calorimeter analysis .

  25. 与小分子染料相比,高分子染料具有高强度、耐溶剂性和可加工性等优越性,在很多领域获得了广泛应用。

    Macromolecular colorants have advantage in high strength , resistance to solvents and processability compared with monomolecular colorants , thus can be widely used in many fields .

  26. 从结构设计等方面阐述了水性聚氨酯改性技术与材料物理性能、力学性能、耐水性、耐溶剂性及耐化学品性等性能之间的规律性特征。

    The relations of modification technology with physical properties , mechanical properties , water resistance , solvent and chemical resistance of waterborne polyurethane in terms of the structural design .

  27. 本文介绍在超声波的作用下制得的硅铝氧烷溶胶、在自制的彩色水泥中加入硅铝氧烷溶胶并对彩色水泥的耐候性、耐溶剂性、耐热老化性进行测试,效果良好。

    Aluminosiloxanesol is added in colored cement made by ourselves , the weather fastness , solvent resistance and aging resistance of colored cement are tried , the result is satisfying .

  28. 性能测试表明环氧改性水性聚氨酯涂料具有涂膜硬度高、耐水性好和耐溶剂性好等优点。

    The properties testing showed that the waterborne polyurethane modified by epoxy resin has high hardness , good water resistance , resistance to petrol , and excellent adhesive to based material .

  29. 但目前国内水性聚氨酯存在的主要问题是:耐水性和耐溶剂性等较差,严格限制了它的使用范围。

    Presently , the main problems existing in WPU in our country are the relatively poor water resistance , solvent resistance , etc. These problems have restricted the use of WPU .

  30. 聚合物/层状硅酸盐纳米复合材料与传统填充聚合物相比不仅改善了聚合物基体的机械性能、气体阻隔性、耐溶剂性,还具有潜在的阻燃特性。

    Polymer layered-silicate nanocomposites not only enhance the mechanical properties , gas barrier properties and solvent resistance of the matrix but also improve the flame retardant properties compared to conventional filled polymers .