旋切

肺动脉栓塞的腔内旋切消融术介入治疗

Interventional treatment of intracavity rotary-cut dissolution for pulmonary artery embolism

目的探讨在CT引导下经皮旋切关节周围骨样骨瘤的治疗方法。

Objective To evaluate the methods of CT-guided percutaneous removal of osteoid osteoma .

应用数学理论证明了装刀高度h无论为何值，单板旋切机的旋切轨迹都属于渐开线。

By mathematical theory this paper demonstrate that the locus of rotary-cutting are all involutes no matter how high the knife is .

MAF旋切气浮技术在炼油厂污水处理中的应用

Application of MAF Air Flotation Technology in Refinery Wastewater Treatment

以胶合板厂的杨木及桦木旋切后的废单板条作为PSL的原料。

Experimental materials of PSL come from fishtail veneer strips at plywood plant of Aspen and Birch .

经皮Decompressor髓核旋切腰椎间盘减压术

Percutaneous disc decompression with decompressor

根据木材旋切刀的服役条件及其使用性能要求及该钢的热处理特点，经优化的热处理工艺为：1020℃加热淬火+（500～520）℃×2h回火2次。

In accordance with the service conditions , the property requirements of wood chip cutter and the heat treatment characters of the new steel , the strengthen toughening heat treating process was optimized .

每个肿块的切除时间平均为25（15～60）min，平均旋切次数20（8～32）次，皮肤切口0.2～0.3cm。

The incisions were 0.2 ~ 0.3 cm in length , each mass was completely resected in average 20 times attempt and the mean operative time was 25 minutes .

薄板旋切芯、锯屑、木丝、刨花等以及厚度等于或者小于6mm的木质材料除外。

The revolved cut cores from wood sheets , scobs , wood-wools , wood shavings , and the wood materials which are6mm thick or less shall also be excluded .

目的评价以透光旋切系统（TriVexTM）治疗下肢大隐静脉曲张，即透照下动力静脉切除术（TIPP）的疗效。

Objective To assess the effect of transilluminating rotating resecting system in treatment of varicose great saphenous vein ( transilluminated powered phlebectomy , TIPP ) .

将冠状动脉内超声检查（ICUS检查）应用于冠状动脉斑块旋切术（DCA）中，32例冠心病患者手术均获成功。

Intracoronary ultrasound ( ICUS ) was successfully applied in 32 patients who accepted directional coronary atherectomy ( DCA ) . After the procedure , the mean internal diameter of coronary artery increased from 1.06 ?

目的：验证超声引导监控乳腺微创立体旋切系统（Mammotome）治疗乳腺纤维腺瘤技术的可行性。

OBJECTIVE : To certify the technology feasibility of microtrauma surgery system ( Mammotome ) in the treatment of breast fibroadenoma guided and monitored by ultrasound .

定向动脉粥样斑块旋切术可简化介入治疗并降低冠状动脉左前降支和左回旋支动脉口狭窄的复发率：FLEXI-CUT研究的亚组分析

Directional atherectomy facilitates the interventional procedure and leads to a low rate of recurrent stenosis in left anterior descending and left circumflex artery ostium stenoses : Subgroup analysis of the FLEXI-CUT study

方法自2000年1月起，对361例乳腺病灶进行乳腺X线立体定位活检，其中弹射式空芯针活检（ST-CNB）73例、真空辅助旋切活检（ST-VAB）74例以及手术活检214例。

Methods A total of 361 cases of stereotactic breast biopsies were carried out since 2000 , including 73 cases of true cut core needle biopsies ( ST-CNB ), 74 cases of vacuum assisted biopsies ( ST - VAB ) and 214 cases of excisional biopsies .

摆动进给竹材旋切的试验研究

An experimental study on the swing feed peeling of bamboo veneer

旋切过程中单板厚度变化的理论研究

Theoretical Research on Variation of Veneer Thickness in Rotary - cutting

旋切机角度控制机构的最优化设计

The optimal design of the angle controlling mechanism of veneer lathe

旋切六点定心理论及数学模拟研究

Research on the Peeling Six Points Centering Theory and Mathematics Simulation

聚酯切片色相浅析旋切机装置角的研究

Analysis of hue of PET chip Research on Veneer-peeling Pitch Angle

无卡轴旋切机单板旋切厚度的研究

A Study on the Veneer Peeling Thickness of Log-core Veneer Lathe

一种细长螺杆转子的旋切加工工艺

A New Workmanship for Swirl Peeling of Long and Thin Rotors

无卡轴旋切机刀床变速进给理论的分析与应用

Knife-carriage Variable-speed Feeding Mechanism of Log-core Veneer Lathe and Its Application

恒线速旋切机旋切技术参数的计算测井绞车恒线速数字控制装置研制

Development of a digital-control device of constant linear speed for logging drawworks

新型无卡轴木材旋切机的研制

Development of New Non - nipped Axis Wood Veneer Lathe

旋切轨迹与单板厚度均匀性的理论研究

Theoretical research on rotary-cutting locus and evenness of veneer thickness

竹材旋切单板的制备与应用前景

Preparation of Rotary - cut Bamboo Veneer and Its Application

恒线速旋切机基本理论问题的研究

Study on the basic theory of the constant peripheral speed rotary lathe

原木旋切最优定心理论的研究

Research on the Theory of the Optimum Log Centering in Peeling Process

定向冠状动脉粥样斑块旋切术切取的不稳定斑块中白介素-10的表达增加

Increased expression of interleukin-10 in unstable plaque obtained by directional coronary atherectomy

透光直视旋切术对静脉团的处理十分理想，治疗彻底，但需注意操作方法。

TIPP is ideal for the treatment of vein clusters .