摩擦强度

高温高压条件下辉长岩的摩擦强度及其速率依赖性

Frictional strength and rate dependence of GABBRO GOUGE under elevated temperature and pressure

水热作用条件下蛇纹石断层泥的摩擦强度和速度依赖性及其地震地质意义

Frictional strength and velocity dependence of serpentine gouges under hydrothermal conditions and their seismogeological implications

PI固化温度及摩擦强度对涂TOP/STN-LCD的影响

The Effect of PI Curing Temperature and Rubbing Intensity on STN-LCD Cell with TOP Coating Inside

研究了液晶盒的厚度、摩擦强度，以及在紫外光诱导相分离过程中的光照强度对PDLC膜的光学各向异性程度和电光特性的影响。

It is found that optically anisotropic properties of PDLC film are greatly depended on the cell thickness , rubbing strength and phase separation process .

摩擦强度对取向膜表面液晶取向度的影响

Rubbing Effect on Orientational Order of Liquid Crystals on the Alignment Layer Surface

展示了摩擦强度对聚酰亚胺薄膜表面形态的影响。原子力显微图像显示，机械摩擦会使聚酰亚胺薄膜表面上形成微沟槽。

The effect of the rubbing strength on the surface morphology of rubbed polyimide films is demonstrated .

分析了摩擦强度和相变时施加的电压对获得均匀排列的影响。

The effect of rubbing strength and applied voltage at phase transition on uniform alignment were analyzed .

非饱和土的抗剪强度有三个组成部份：真凝聚力、摩擦强度和吸附强度。

Shear strength of unsaturated soils is composed of three components : true cohesion , friction and suction strength .

实验结果显示，预倾角会随摩擦强度或垂直聚酰亚胺浓度的增加而升高。

Found that the pre-tilt angle is increased with the frictional strength or the increase of the concentration of vertical polyimide .

研究了它们在不同固化温度、固化时间及摩擦强度下的表面取向性能，获得了1.0～10.5°范围的预倾角。

The surface orientation properties were studied at different curing temperatures , curing times and rubbing strengths , from which the pretilt angles of 1.0 ~ 10.5 ° were obtained .

利用晶体旋转法测量不同摩擦强度及不同浓度垂直聚酰亚胺样品的分子的预倾角（液晶分子长轴与基板之间的夹角）。

Using the crystal rotation method to measure the pretilt angle of liquid crystal molecules ( the angle between the major axis of liquid crystal molecules and the substrate ) .

这个结果暗示对那些特别丰中子的裂变系统，轻带电粒子（质子和α粒子）的多重性对于研究热核裂变过程中的摩擦强度不是一个好的探针。

This means that for those neutron rich fissioning systems proton and α particle multiplicities will not be good probes for the study of nuclear friction in the fission of hot nuclei .

各向异性内摩擦材料强度准则的规范空间理论

Standard space theory of strength criterion for anisotropic internal friction materials

金属基复合材料界面摩擦剪切强度的测试

A measure of interfacial frictional shear strength of MMC

往复滑动频率和法向力对摩擦噪声强度影响的实验研究

Experimental Study of Effects of Reciprocating Frequency and Normal Force on Friction-induced Noise

铁的高周摩擦疲劳强度试验研究

Study on Hi-cycle Fretting Fatigue Strength of Iron

非金属颗粒表面镀铜及其对烧结摩擦材料强度的影响

Study on the strength of the sintering friction materials by nonmetallic particles electroless plating with copper

建立该离合器的摩擦及强度性能分析的数学模型。

Then the mathematical model to analyze friction and strength performance of this clutch is set up .

通过对比计算结果，得出了影响摩擦轮强度的因素。

The factors that affecting the strength of friction wheel were obtained by means of the result of contrast calculation .

结果表明：如果忽略制动过程中摩擦热流强度的变化，会给温度场模拟带来较大的偏差。

The results show that ignoring change of friction heat flow intensity will bring large deviation to temperature field simulation .

应用ANSYS分析软件对不同结构摩擦轮的强度作了详细分析，分析了摩擦轮应力及应变的变形云图。

By applying the ANSYS analytical software , this paper made a detailed analysis on the strength of various structured friction wheel . The deformation cloud diagram of stress and strain of friction wheel was analyzed .

结果表明，LF6（M）搅拌摩擦焊接头强度可以达到母材的强度，其背弯和正弯角度可达到180°；

The reasons of forming defect in FSW were analyzed . It is shown that the strength of the joint can reach that of the parent materials , the bending angle can reach 180 ° .

钢板接合面间隙对摩擦型高强度螺栓的影响

Effects of interface gap between steel sheets on high-strength friction bolts

论提高石棉制动摩擦片冲击强度的途径

Methods for the improvement of impact strength of brake lining material

摩擦型高强度螺栓连接件抗滑移系数试验研究

Experimental study on anti-sliding coefficient of friction type high-strength bolt connectors

土体内外摩擦及摩擦强度试验研究

Testing Study on internal and external friction and frictional strength of soils

摩擦型高强度螺栓长接头螺栓传力比研究

Study on the Force-delivering Ratio of High Strength Bolt Friction Grip Long Joint

摩擦型高强度螺栓在南京长江二桥中的应用

Application of the friction high strength bolts in the second Nanjing Yangtze River Bridge

铜/钢异种材料摩擦焊接头强度的超声波检测

Ultrasonic Testing of the Strength of the Friction Welded Joints in Copper-Steel Dissimilar Materials

杂波型鳞片的复杂程度与摩擦方式和强度有关；

The complexity of irregular wave type is related to the fraction mode and intensity .