成阻

chénɡ zǔ
  • closure
成阻成阻
  1. 由于解剖照片中的每个体素颜色值已经确定,因而主要研究如何从每个体素的R、G、B三原色组映射成特定阻光度值,即阻光度转换函数。

    Since the color value for each voxel can be predetermined in the anatomical photographic database , we focused on the designing of mapping from an RGB tuple to an opacity value usually called opacity transfer function .

  2. 此外,ZnO晶须具有压敏特性,在低电压(9V)下成高阻状态,测量值为无穷大;

    They have high resistance properties under low voltage ( 9V ), and the measured value is infinite .

  3. 络合物薄膜在8V电压作用下,可以从高阻态转变成低阻态,跃迁时间为15ns。

    The resistivity of the complex film can be changed from high to low at 8 V and the transition time is only 15 ns .

  4. 提出把LC振荡器等效成负阻振荡器的新观点,并以电容三点式振荡器为例,利用物理概念导出了该振荡器的振荡条件和振荡频率的准确公式,并将结果与相关讨论进行比较。

    This paper put forward a new view that LC oscillator is equal to negative resistance Oscillator in effect . In addition , the paper concluded accurate formulas of OSC condition and OSC frequency about LC oscillator by using physics notions and taking Three-point Capacitance Oscillator as an example .

  5. 由这种材料制成的薄膜,在室温6V电压作用下可以从高阻态转变成低阻态,其跃迁时间小于20ns,并具有极佳的热稳定性。

    The complex Cu SCN shows good electrical bistable states and thermal stability . At room temperature , the resistivity of the thin film can be transferred from high to low under 6 V and the transition time is less than 20 ns .

  6. 本文以汽车动力总成液阻悬置的橡胶主簧为研究对象,探讨了橡胶隔振器弹性特性的有限元分析方法。

    Taking the rubber spring of a hydraulic engine mount for car powertrain as an example , the method for Finite Element Analysis ( FEA ) of rubber isolators is studied in this paper .

  7. 采用MBE方法生长了8nm基区的InGaP/GaAs双异质结材料,研制成具有负阻特性的异质结晶体管。

    A thin base ( 8nm ) InGaP / GaAs dual heterojunction material is grown by MBE and a heterojunction bipolar transistor ( HBT ) with negative differential resistance ( NDR ) is fabricated .

  8. 仿生非光滑用于旋成体减阻的试验研究

    Experimental Study on Drag Reduction for Bodies of Revolution Using Bionic Non-Smoothness

  9. 本文对被动式液阻型橡胶悬置及动力总成-液阻悬置系统的设计分析方法和研究成果进行了较系统的述评和总结。

    In this paper , the design and analysis methods for the passive hydraulically damped mount and the powertrain mounting system are reviewed .

  10. 将CCD(电荷耦合器件)单元等效成一个变阻RC积分电路,使图像中的光照效应分解为对光电势的影响和对光敏电阻的影响。

    The CCD cell is equalized as a variable resistance RC integral circuit , the lighting effect on the image is decomposed into pair impact of photoelectric potential and photosensitive resistance .

  11. 水下旋成体加热减阻的测力实验研究

    Experimental studies on the drag reduction of heated underwater bodies of revolution

  12. 仿生非光滑旋成体表面减阻特性数值模拟

    Numerical simulation on drag reduction characteristic around bodies of revolution with bionic non-smooth surface

  13. 斜切尾钝头旋成体的减阻及其机理的初步研究

    A primary investigation of drag reduction and mechanism for a blunt body of revolution with slanted base

  14. 与泥浆护壁和干作业成孔工艺相比,螺旋钻孔压灌混凝土成桩的侧阻和端阻都有相应的提高,桩的承载性能较好,复合地基的变形较小。

    Compared with the mud on wall and dry work form hole technology , the side obstruction and end obstruction of screw drill press concrete stake have all been accordingly improved , the weight bearing is better , and the transmutation of the complex foundation is less .