形变织构

采用ODF法研究和分析了润滑剂对高纯铝冷轧形变织构的影响，揭示了两种润滑条件下形变织构的演变规律。

The influence of the cold rolling lubricants on the deformation texture in high purity Al was investigated in detail by ODF 's.

半固态镁合金组织在高固相率挤压成形过程中会产生形变织构，织构条纹随着成形温度的升高而逐渐舒缓以至消失。

During the semi-solid forming process , the deformation texture in microstructure of Mg alloy at high solid content was found and the higher the temperature , the less the texture .

微量稀土Ce、形变织构与2090合金板材屈服强度异向性

Minor rare earth element cerium , texture and anisotropy of yielding strength in 2090

在时效早期，Ce通过细化和弥散化δ′相来减弱共面滑移对各向异性的贡献；而在整个时效过程中，Ce均使T1相对各向异性的贡献与形变织构对各向异性的贡献相反。

In early stage of aging , cerium lessens influence of coplanar slip on anisotropy by making ' phase particles smaller and more disperse , while it makes contribution of T1 phase to anisotropy contrary to that of textures .

润滑剂对高纯铝形变织构的影响

Influence of lubricants on deformation textures in high purity Al

工进和顶锻速度对摩擦焊接面形变织构的影响

Effects of Deformation Weaving of Friction Welding Interface to Feed and Upsetting Rate

单向轧制70/30黄铜的形变织构及形成模型

Deformation textures and their formation model of 70 / 30 brass rolled in single direction

轧制几何和温度因素对无取向硅钢轧制形变织构及组织的影响

Effect of Roll Gap Geometry and Rolling Temperatures on the Evolution of Deformation Textures and Microstructure in Rolled Non-oriented Silicon Steel

再结晶立方织构的形成和发展受冷轧形变织构及显微组织结构不均匀性的影响。

The formation and development of the recrystallized cubic texture were affected by the inhomogeneity of the deformation structure and microstructure during cold rolling .

本文以未经常化热处理的无取向硅钢为实验材料，研究轧制几何因素以及温度变化对形变织构及组织演变规律的影响。

Effect of roll gap geometry and rolling temperatures on the evolution of through-thicknesstextures and microstructure were studied about a non-oriented silicon steel without normalizing .

结果表明：变形单晶铜线材中的形变织构主要为<100>丝织构，也有少量<110>丝织构；

The results showed that most deforming texture in single crystal copper wires is of < 100 > texture type , and a few of them is of < 110 > texture type .

结果表明：3104铝合金，形变织构由C{112}<111>，B{110}<112>，S{123}<634>织构组分组成；

The results show that the deformation textures are composed of C { 112 } < 111 > , B { 110 } < 112 > and S { 123 } < 634 > components .

针对异种高强材料摩擦焊接成形与控制问题，系统研究了工进速度和顶锻速度对摩擦焊接面的作用行为，发现了摩擦焊接面形变织构的变化及其影响接头性能的规律。

On the basis of analysis dissimilar metal friction weldability , The action behavior of friction welding interface is studied , it is found that the deformation weaving of friction that the deformation weaving of friction welding interface is changed and the influence regulation friction weld joint of properties .

FCC金属滑移形变冷轧织构模拟

Texture Simulation of Slip Deformation in FCC Metal of Cold Rolling

TiAl基合金高温形变与退火织构

High temperature deformation and annealing textures of TiAl base Intermetallics

实验结果表明，PET的初始取向接近随机分布状态，轧制形变后的织构包括{100}<001>组分和不完全纤维织构（<001>//轧制方向），并且形变量愈大，织构愈强；

Experimental result indicates that the rolling texture consists of a { 100 } < 001 > component and an incomplete fiber ( < 001 > / / rolling direction ) .

在短裂纹扩展阶段，裂纹尖端塑性区尺寸仅为单个晶粒大小时，表面残余压应力及形变引起的织构可抑制裂纹扩展。

At the short crack propagation stage , the plastic zone size was at the grain size level , the residual stress and texture could suppress the crack propagation .

Al-Li合金形变热处理的织构组织研究

Study of textures in deformed and heat treated Al-Li alloy sheets tissue chip

取向硅钢形变和再结晶织构转变机制

A mechanism of the deformed and recrystallized texture changes in the grain oriented silicon steel sheets

测定了形变和再结晶织构及冷加工变形度对其影响，确定了织构类型与制耳的几何关系。

The cold work texture and annealing texture , and the effects of degree of cold work to the texture are studied together with the geometric relationship between the type of preferred orientation and the ears .

理论的分析定性地说明了实验结果。可以认为：取向硅钢形变和再结晶织构转变主要是受贮能差和位向差共同控制的择优长大过程。

The qualitative coincidence between the theoretical analysis and the experimental results indicated that the mechanism of the deformed and recrystallized texture changes in the grain oriented silicon steel sheets was mainly a preferred growth process , controlled in common by the stored energy difference and the orientation difference .

结果表明，在利用形变强化相变实现铁素体的超细化过程中会出现铁素体的相交织构和形变织构，在大应变条件下还会出现动态再结晶织构。

Results show that transformation texture , deformation texture and / or dynamic recrystallization texture can occur in this process .