层型结构

因此，该现象又从另一侧面证实了SrTiO3压敏电阻器试样具有表面层型结构。

So , conversely , the phenomenon rested SrTiO_3 varistor has the characteristic of the surface layer structure by otherwise .

结果表明，复合微球内部为插层型结构，即聚合物链段插入蒙脱土层间。

The result revealed that the polymer chains inserted into the montmorillonite interlayer and formed intercalated composite microspheres .

针对安装有MR减振驱动器的三层剪切型结构仿真分析了各种半主动控制算法和被动控制策略的控制效果。

Three lumped mass structures with MR dampers are simulated and studied by using various semi active control algorithms and two passive control strategies .

固态反应周期层片型结构分析

The analysis of periodic layer formation during solid state reactions

若此过程周期性的发生，便形成了周期层片型结构。

The process is periodic , which results in the formation of the periodic layer structure .

Ni3Si/Zn体系周期层片型结构的形成与反应时间关系密切。

The formation of periodic layered structure during Ni3Si / Zn diffusion couple is in close relations to the reaction time .

为表现公司中央集权化，核心层星型结构建立数据流的汇聚点作为关键站点。

To reflect this corporate centralization , the core layer hub-and-spoke configuration establishes the focal point of the data flow as a key site .

然而，到目前为止并没有一个全面的理论让学术界欣然接受，各种关于周期层片型结构形成的机理都存在一定的争议。

However , so far there is no comprehensive theory for academics to embrace , and the mechanism of this unusual phenomenon still remains controversial .

三聚氰胺热解产物再经脉冲放电和高速冲击加咏冲放电处理后，产物仍保持乱层石墨型结构，但有序性明显提高。

After the treatment of pulsed discharge and high-speed impact , the crystal structure of the CN powder is still turbostratic , however , its structure order degree increases significantly .

并以Mg/SiO2为例对周期层片型结构进行计算机模拟，计算机模拟结果与实验数据吻合良好。

In line with the kinetic descriptions of the model , the computer simulation with VB program was adopted here to model the periodic layered structure formed in Mg / SiO2 system at 973 K and the calculation results coincided well with the experimental data .

得出如下结论：（1）N6/MMT复合材料具有插层型纳米结构，三种混料顺序对N6/MMT复合材料的力学性能和热行为影响不大。

Based on experiment results , the conclusions were drawn as following : ( 1 ) The intercalated structure nylon 6 / montmorillonite ( N6 / MMT ) nanocomposites were prepared ; the blending sequences have few effects on the mechanical properties and thermal behavior of N6 / MMT nanocomposites .

XRD分析表明：PPC/OMMT复合材料形成了插层型纳米复合结构。

XRD analysis indicated that PPC / OMMT nanocomposites with intercalated structure were prepared .

入侵检测子系统采用2层分布式自治型结构，利用自治性检测节点来实现分布式检测，用SSL协议来保证子系统内部通信安全，实现了高效检测，有良好的抗攻击能力。

Intrusion detection subsystem is hign efficient and has well anti-attack ability , based on two-layer distributed structure .

研究任意层平板型导电结构脉冲涡流（PEC）差动探头输出信号的解析模型。

Analytical modeling for response of differential probes placed above arbitrary number of parallel nonferrous stratified conductive structures for pulsed eddy current ( PEC ) testing was studied .

混层型粘土的结构和性能

Structure and characteristics of mixed - layer clay

通过一个10层剪切型框架结构的数值分析表明，振型曲率的改变不能正确识别结构损伤位置；

Some useful results were obtained by a numerical simulation of a 10-story shear-type frame structure . Damage can not be located correctly through the changes in mode shape curvature .

然后对一底部两层型钢混凝土结构上部八层钢结构的大型组合结构的数值模型，进行模态分析及弹性时程分析，得到结构在线弹性阶段的响应曲线。

Thirdly , we perform a modal analysis and elastic time-history analysis for the numerical model with two layer steel reinforced concrete below and eight layer steel composite structures above .

基于滑移的层间剪切型隔震结构体系研究

Study on the Sliding Base-isolation Structure System in Shearing Type

根据原地爆破浸出工艺爆破筑堆的技术特点，构建了3层前馈型神经网络结构。

According to the tectonic features of ore stacking by blasting for in-situ leaching , the three-layer feedforward neural network was established .

提出了低层冷弯薄壁型钢结构房屋风荷载的设计方法与建议，提出了复杂体型低层建筑表面体型系数的建议简化计算方法是本文的第五个创新点。

The design method and suggestions on wind loading of low-rise cold-formed steel residential house are put forward , and the simplified method to calculate the shape coefficient of house is suggested in this dissertation . These results are the fifth innovative argument .

随后，利用模态参数敏感方程将多高层结构损伤识别转化为数学优化问题，运用遗传算法进行优化求解，分别识别了10层、20层剪切型结构和实验室三层框架结构的各种损伤。

Further , damage identification is transferred into an optimization problem through sensitivity equations and solved by genetic algorithms . Different damages on 10-storey , 20-storey shearing-type numerical models and a 3-storey test frame structure are identified .

另外，在注入层表面还有一层石墨型结构的碳膜存在。

On the surface of the implanted layer there was a layer of carbon film with a graphite - like structure .