填充系数

微透镜与红外256×256PtSiCCD的集成结果表明，微透镜填充系数提高了2.3倍，成像质量明显改善。

The integration technique is applied to 256 × 256 PtSi CCD , and has made its fill factor increased by 2.3 times and the imaging quality improved obviously .

然后详细介绍了高填充系数技术和直接成像传感器技术，及其对CMOS图像传感器性能的改善，并对这两种技术的应用做了介绍；

How to improve the performance of CMOS APS by high fill factor technology and direct image sensor technology is set forth in detail , and the applications of these two technologies are described .

考察了偏压、源物加热电压对膜的沉积速率及膜中Fe的填充系数的影响。

The influence of negative substrate bias , heating voltage of precursor on the deposition rate of films and on filling factor of Fe were discussed .

当转子转速为160r／min，冷却水温度为40℃，填充系数为0.65时，最佳的上顶栓压力为0.5～0.6MPa。

The optimum ram piston pressure was 0.5 ~ 0.6 MPa when the conditions were : rotor speed 160 r / min , cooling water temperature 40 ℃ and filling factor 0.65 .

阐述了工程上比较关注的重要参数（输送能力Q、螺旋直径D、螺杆转速n、填充系数Ψ、电机功率P）的计算方法和实际确定、核算的过程。

Regarding to it 's crucial parameters concerned in the engineering : transport capacity , screw diameter , screw rotation speed , fill efficiency and electric power , the article supplies detail methods of calculation , design and check procedure .

填充系数对碎石基层混合料性质研究

Effects of Stuff Coefficient on Properties of Crushed Stone Mixed Materials

填充系数对聚氨酯泡沫塑料力学性能的影响

Influences of Filling Coefficient on Mechanical Properties of Polyurethane Foam

填充系数对同步转子密炼机混炼性能的影响

The effect of filling coefficient on the mixing properties of synchronous rotor mixer

发现体积填充系数和质量填充系数对力学性能有截然不同的作用行为，体积填充系数约为3时，冲击强度和弯曲强度有最大值；

It is found that volume and mass filling coefficients affect differently mechanical properties of materials .

转速小于60r/min时，秸秆长度越大填充系数越小。

When speed is less than60r / min , straw length the greater the smaller the fill factor .

另外，介质筒的介电常数，填充系数等都对色散曲线有影响。

In addition , the dielectric parameter and the filled coefficient also have influence on the dispersion curve .

像元尺寸和填充系数分别为60×50（μm~2）和35%。

The pixel size is 60 × 50 (μ m ~ 2 ) with fill factor of 35 % .

介绍一种经直肠的射频线圈，通过减小线圈到前列腺的距离.增加线圈的填充系数以及提高线圈的品质因子的办法提高成像的信噪比。

In order to increase the SNR of the prostate image , we have designed a RF endorectal coil .

主要论述了密炼机最佳填充系数的概念及如何选择问题，重点分析了填充系数对混炼过程的影响。

In this paper , the selection of optimal filled coefficient of internal mixer and its effect on mixing process are discussed .

转速大于120r/min时，秸秆长度对深施填充系数的影响较小。

The120r / min when the speed is greater than straw length on the impact of deep application of fill factor is smaller .

从定义出发，导出了确定填充系数的实用表达式，以及填充系数与熔合比等常用参数的关系式。

From this definition , the useful calculating formulas of the filler coefficient and usual welding parameters , such as penetration ratio have been derived .

测试了在同一余气系数α、不同填充系数β下的爆震波压力，并对其变化进行了分析。

Under same excess coefficient α, and various filling coefficients β, the detonation pressures are measured , and the factors influencing detonation pressures are analyzed .

其他工艺参数相同条件下，在焊料填充系数为0.85，当振幅为700μm时界面存在的氧化皮相对较少；

When the filling coefficient of the solder is 0.85 , the oxide film remained in interface is least when vibration amplitude is 700 μ m ;

通过理论计算与试验结果的对比，建议冠状铆钉干涉配合的填充系数可取为0.474。

Based on the comparison between theoretical calculation and test results , this paper suggests that the filling coefficient of coronary rivet should be at 0.474 .

提出了填充系数理论，制订了土体渗透破坏形式的填充系数判别式和管涌临界破坏坡降计算图。

The filling coefficient theory was put forward , a criterion for the filling coefficient of soil stratum failure and a critical hydraulic gradient chart were formulated .

研究表明，掺加二灰后级配碎石混合料的性能显著提高，特别是二灰的填充系数为0。

The results show that the performances of graded gravel mixture are improved significantly after being treated with cement and lime , especially when fill factor is0 .

研究界定了动态平衡与失衡的界限，通过试验测出了不同工艺参数条件下焊料动态平衡保持最大时间，研究了动态平衡保持最大时间随温度、焊料填充系数、振幅、频率的变化规律。

This paper discussed the regularity of the maximum time of dynamic equilibrium maintain following with the temperature , filling coefficient of the solder , vibration amplitude and frequency .

为了进一步降低非晶合金配电变压器的成本，提高性能，对非晶合金材料提出了提高工作磁通密度、增加填充系数、适当降低脆性、减少磁致伸缩系数等要求。

In order to further reduce the cost and improve the performance , to increase flux density and fill factor , and properly reduce the brittleness and magnetostriction coefficient are required .

采用模塑成型和嵌入成型两种方法，通过改变体积填充系数、质量填充系数和芯体尺寸，制备了梯度密度聚氨酯泡沫塑料。

Gradient-density PUF was produced in two ways : mould shaping and embed shaping , through changing volume filling coefficient , mass filling coefficient , and the size of foam core .

介质填充系数越小，同一频率下，相速减小，其慢波效应更为明显。

In the case of the same frequency , the filled coefficient of the dielectric line is smaller , the phase velocity is smaller , and the slow-wave effect is more remarkable .

六棱VCMT同步转子在新型六棱同步转子的基础上，可适当提高填充系数，并降低了对上顶栓压力的要求，从而降低了混炼成本。

The new six-wing rotors are on the basis of six-wing rotors , can increase filled coefficient , lower the force of ram thrust and reduce the cost of mixing . 3 .

分析实验结果发现，在同一余气系数下，爆震室长度一定时，随着填充系数的减小，爆震波压力降低，使脉冲爆震发动机模型性能下降。

The experimental results have shown that for a given length of PDE model detonation wave pressures decrease and the performance of PDE model become worse with falling of filling coefficients ratio under the same excess coefficient .

本文针对提高填充系数这一问题，首先研制方形自聚焦透镜，并提出了两种研制方案：其一，先对圆柱形玻璃棒进行离子交换，再加工成方柱棒；

This article 's aims to enhance space factor , first develops the square self-focusing lens , and proposes two kinds of methods : First , carries on the ionic exchange then makes the cylindrical glass rod to the square glass ;

随着LED芯片发光效率和散热技术的快速提升，显示屏分辨率越来越高，目前填充因子系数已达到10%。

With the rapid promotion of the LED chip light-emitting efficiency and heat dissipation technology , the fill factor coefficient of the LED display has been up to10 % .

疲劳寿命计算中钉孔填充作用系数的取值研究

A Study on the Filling Factor in a Rivet Hole in the Calculation of Fatigue Life