均匀化处理

合金合宜的均匀化处理工艺为450℃保温24h。

The suitable homogenization treatment of the alloy is 450 ℃ / 24h .

研究合金铸锭均匀化处理过程中Al3（Sc，Zr）粒子的最佳析出工艺为：300~350℃，6~8h。

The best precipitation processing of Al_3 ( Sc , Zr ) particles for the studied alloy is homogenization at 300 ~ 350 ℃ for 6 ~ 8 h.

利用扫描电镜、X射线衍射仪、能谱仪等分析设备对一种新型高强度、高耐磨铸造高铝青铜在不同温度与时间均匀化处理后的显微组织和力学性能进行了研究分析。

Microstructure and mechanical properties of a new high strength and wear-resistant as-cast aluminum bronze with different homogenizing annealing are investigated by means of SEM , XRD and X-ray spectrometer .

Ti-Al-Nb-B-W合金经过均匀化处理后，随着钨含量的增加，β（B2）相析出的量更多。

And with increasing content of tungsten , the volume fraction of precipitated β( B2 ) phase increases .

与铸态合金的变形抗力相比，均匀化处理可以显著减低Mg-Mn系合金在热加工过程中的变形抗力。

The homogenization treatment could reduce the resistance to deformation of Mg-Mn alloys during hot working .

均匀化处理过程中Waspaloy合金铸锭中元素分配规律的研究

Investigation on Elements Distribution in Waspaloy Alloy Ingot during Homogenization

铸态合金均匀化处理过程中有类似于传统铝合金固溶时效过程中的析出特性，析出相主要为Al3（Sc，Zr），还有少量Al6Mn相粒子。

This kind of as-cast alloy has the similar precipitation characteristics , just like that during aging of traditional aluminum alloy , the precipitates mainly are Al_3 ( Sc , Zr ) and minor Al_6Mn .

低膨胀高温合金GH907和GH909的铸态组织及其均匀化处理

The cast-phases and homogenization treatments of the low-expansion superalloy GH 907 and GH 909

确定采用LiCl+LiF的盐类作为合金熔炼时的覆盖剂，可以获得良好的保护效果。（2）对Mg-Li合金的均匀化处理工艺进行了研究。

Using LiCl + LiF salts as covering agent when melting the alloy could obtain good protective effect . ( 2 ) The homogenization treatment of Mg-Li alloy was studied .

对IN706合金的均匀化处理工艺进行了探索，同时研究了均匀化处理对材料热加工性能的影响。

The homogenizing treatments and it ′ s effect on hot workability of IN706 alloy was studied in this paper .

Mg-8.4Li合金铸锭经573K×24h均匀化处理和473K温轧得到1.5mm厚板材，总加工率为92.5%。

Mm-thick Mg-8.4wt % Li alloy sheet was obtained through warm-rolling at 473 ? K with a total reduction of 92.5 % after melting , casting , ingot homogenization annealing at 573 ? K for 24 ?

非均匀化处理稀土铝合金的组织结构

Structure of Rare Earth Aluminium Alloy Treated by Non - homogenization

均匀化处理对3003合金深冲性能的影响

The Effect of Homogenization Treatment on Deep-drawing Property of 3003 Alloy

将铸态、均匀化处理态及热处理态合金的扫描电镜背散射电子像进行比较研究。

The back scattered electron images microstructures at different states were compared .

3004铝合金铸锭均匀化处理工艺研究

Research on homogenizing treatment process for 3004 aluminum alloy ingot

均匀化处理对3004铝合金显微组织的影响

Influence of homogenization on microstructure of 3004 aluminum alloy

均匀化处理对铝-锌-镁-钪铸态合金硬度和电导率的影响

Effect of homogenization treatment on the hardness and electro-conductivity of as-cast Al-Zn-Mg-Sc alloy

铸锭均匀化处理对铝型材表面的影响

The influence of the ingot homogenization on the surface quality of 6063 Al alloys

镍基耐蚀合金扩散均匀化处理及组织性能演变

Diffusional homogenization treatment of Ni-Cr-Mo-Cu corrosion resistance alloy and evolutions of its microstructure and properties

合金锭经1200℃长时间的均匀化处理，可消除合金锭中碳化物的偏析，从而可防止薄板表面花纹的产生。

The homogenization treatment at 1200 ℃ can reduce the segregation of primary carbides in the ingots .

因此，电场及非电场的联合处理方法是一个有效的均匀化处理制度。

Therefore , the combined homogenization treatment with and without an electric field is an effective method of homogenization treatment .

在一定温度下对各组份进行均匀化处理并制备出助焊剂，依据标准对所制备的焊剂进行性能测试。

Homogenizing each group at certain temperature to make flux and test the properties of the flux according to the standard .

采用较大的热变形和均匀化处理，可避免一次η相的不利影响。

The adoption of treatment under hot deformation and homogenization may be the remedy for unfavourable influence of η - phase .

水吸收可以有效脱除高沸点的乙二醇，通过对乙醛的吸收、解吸作用使废气的总烃浓度得到均匀化处理；

Water absorption could effectively remove high boiling point ethylene glycol , and equilibrate total hydrocarbons concentration by absorption and stripping of acetic aldehyde .

研究了均匀化处理、固溶时效、冷变形时效等对铬青铜显微组织和性能的影响。

The microstructure and properties of chromium bronze after homogenizing treatment , solid solution and aging treatment , cool deformation and aging was studied .

通过对不同冷速凝固后的组织和均匀化处理后的组织分析，探讨了网状组织的形成。

The formation of net structure in the alloy ZA27 has been investigated by means of analyzing microstructure with different cooling rate of solidification and homogenizing treatment .

研究了热处理工艺（包括均匀化处理、淬火方式和人工时效等）对6063铝合金组织和力学性能的影响。

The effect of heat treatment ( including homogenizing treatment , quenching method and artificial aging ) on the structure and mechanical property of 6063 aluminum alloy was studied .

通过给内压引起的圆筒应力分类和评定，对圆筒在内压作用下的各向应力沿应力处理线进行均匀化处理。

By means of classification and evaluation of the stress on the cylinder under internal pressure , the stresses on the thick wall cylindrical shell in all directions are linearized .

本文分别从铝型材的化学元素成分控制、熔体质量、铸造的工艺参数、铸锭的均匀化处理等方面探讨了提高6063铝合金挤压铸锭质量的技术途径。

From the aspects of chemical compositions controlling , melt quality , process parameters of casting and homogenizing treatment of ingot , the technical way to improve the quality of 6063 aluminum alloy extruded ingot is discussed in the paper .

在540℃之前的均匀化处理，铸轧板坯晶粒几乎没变化，经580℃均匀化处理后，晶粒明显长大，是均匀化前的几十倍。

The change of grain size in the casting-rolling sheet is absent with homogeneously annealing temperature lower than 540 ℃ while the grain remarkably grows with homogeneous annealing at 580 ℃, which is ten times more than that of ones before homogeneous annealing treatment .