反应结构

多维反应结构模式的建立是基于对烃类在酸性催化剂上反应化学认识而进行的知识创新，但多维反应结构不同于烃类在酸性催化剂上反应化学。

The multi-dimension reaction structure mode was established on the basis of hydrocarbon reaction chemistry over acid catalyst , but the former was different from the latter .

面对催化裂化工艺所遇到的挑战，提出了催化裂化过程反应化学的多维反应结构模式。

Faced the stringent challenge of FCC process , the multi-dimensional reaction structure was pro-posed for FCC process reaction chemistry .

在不添加任何结构稳定剂的条件下，首次用固态反应结构导向法成功地合成了具有层状结构和MSU结构的介孔纳米二氧化锆。

Without introduction of any stabilizer , the mesoporous nanocrystalline zirconia with lamellar and MSU structure was obtained via solid state reaction coupled with surfactant templating method .

反应结构敏感性的分形分析

Fractal Analysis on the Structure Sensitivity of Gas-Solid Catalytic Reaction

晋冀蒙三省交界的怀安-大同一带基性麻粒岩有保存完好的变质反应结构。

Huaian Datong region on the bounder of Hebei Shanxi Inner Mongolia is one of the most important area where the Archean granulite complex is relatively completed exposed .

研究模型的动态响应尤其是非线性响应时，首先考虑的是模型能否反应结构动态响应的特征，而不是仅仅从几何相似的角度对结构进行模拟。

Before the dynamic responses is studied , the model not only simulate structure based on geometrically similarity , but also is considered if it can embody the characteristics of structure dynamic response .

分析结果表明线弹性阶段，在各种截面刚度假定下，反应结构整体特性的动力特性以及地震响应位移等差别不大。

The results show that dynamic characteristics of structures using different sectional assumptions are nearly the same and the aberrations between the responses of these structures are minor and negligible in the stage of elastic deformation .

通过考虑弹塑性的影响，反应结构真实的材料特性，结果表明非线性屈曲荷载的大小既受材料非线性的控制，也受几何非线性的影响。

In this theory the material plasticity is introduced to consider the true structure behavior . The numerical results show that the loading capacity of stiffened cylindric warehouse is mainly affected by the geometric nonlinearity and material nonlinearity .

时域法可对结构进行线性或非线性分析，可更直接地反应结构的特性，获得更多的关于疲劳问题的信息，但是时域法计算公式极为繁杂，计算量大，有时并不适用于工程实际；

Method of time area can put up linear and non-linear analysis , reflect structure characteristic more directly , gain more information about fatigue , but calculating formula of time area is very complex and it is not fit for practical engineering ;

基于模糊神经网络的Agent反应器结构及实现

Architecture and Realization of Agent Reactive Module Based on Fuzzy Neural Networks

气升式反应器结构参数优化设计CFD仿真研究

CFD simulations for structural parameter design of airlift bioreactors

本文通过实验和CFD优化微藻培养反应器结构，以提高生产效率。

The reactor structure of energy microalgae is studied through experiment and CFD to improve production efficiency .

优化设计CVI反应器结构的流体可视化研究

Optimum Design of CVI Reactor Aided by Visualization Research

提出的混合Agent体系结构包括反应式结构和慎思结构，反应式结构提高Agent的反应性，慎思结构增强Agent的智能性；

This paper presents a hybrid agent architecture , which includes reactive architecture and deliberative architecture , the former enhances the reactivity of agents , and the latter improves the intelligence of agents .

NiFe2O4直接分解二氧化碳成碳循环反应过程结构演变研究

Study on the structure change of nife_2o_4 during the cycle reaction of decomposition of co_2 to C

高选择性透过二氧化硫气体分离膜的研究（Ⅲ）&乙烯基亚砜与聚乙烯醇的Michael加成反应及其结构表征

Studies on High Permselective Gas Separation Membrane of Sulfur Dioxide (ⅲ)── Michael Addition Reaction of Vinyl Sulfoxide with Poly ( vinyl alcohol ) and Structure Characterization

结果表明，Ti箔厚度对接头的组织及性能都有重要的影响。Ti箔的厚度对接头组织的影响主要体现在钎缝组织和界面反应层结构。

The results showed that the thickness of Ti foil has an important influence on the microstructures , properties of joints , and status of interfacial reaction layer .

由于反应器结构上存在死角和短路，其F（t），E（t）并非理想状态。

Due to the blind angle and short circuit on the reactor structure its F ( t ), E ( t ) are not concerned as ideal as they are finally .

仿真计算结果表明，电大尺寸FSS能够很好的反应出结构的频率选择特性，且与软件仿真所得无限大FSS的计算结果基本吻合。

The results shows the structure have good performance in frequency selectivity and basically consistent with the software simulation results .

手性磺内酰胺诱导的不对称Diels-Alder反应及其结构与手性诱导的关系

Asymmetric Diels-Alder Reaction Induced by Chiral Sultams and the Relationship Between Structure of Sultam and Chiral Induction

采用XRD，SEM-EDS、N2吸附-脱附等手段考察了催化剂反应前后结构特征及表面性能。

Techniques of X-ray powder diffraction , Scanning electron microscope and N2 adsorption-desorption were used to characterize the structure and surface properties of the catalyst .

通过模拟试验，研究了模拟烟气参数、反应器结构及放电特性等因素对SO2电迁移和脱硫效率的影响。

The simulated experiment were conducted to research the main factors affecting the electric transfer of SO 2 and the desulfurization efficiency such as simulated gas parameters , structure of the reactor and the characteristics of corona discharge , etc. .

本文首先利用ANSYS软件对一个七层异形柱框架住宅进行时程分析，研究异形柱框架结构整体在地震作用下模态、动力响应和位移反应以及结构的破坏形式。

The article uses a time-history analysis on a 7-floor specially shaped column frame structure by the software of ANSYS , and mainly studies the modal form , seismic action , displacement action and the failure mode of the frame as a whole under seismic loads .

对于用PVDF压电薄膜监测结构的冲击载荷也进行了初步的研究，实验结果表明采用PVDF压电薄膜可以实时监测结构所受的冲击载荷，并能及时反应出结构所受到的冲击损伤。

A preliminary study of PVDF piezoelectric film for monitoring the impact loading of the structures has also been conducted . The result indicates that the impact loading anda damage of the structures can be real-timely detected by using PVDF piezoelectric film .

介绍THIOPAQ生物脱硫机理，生物反应器结构特点，工艺参数及应用实例。

The paper presents THIOPAQ bio-desulfurization mechanism , bio-reactor structure feature , process parameter and application example .

本文根据气流模型研究了反应室结构与光激发汽相淀积（PVD）SiO2薄膜均匀性的关系，并且讨论了工艺参数对PVDSiO2薄膜均匀性的影响。

Based on gas flow models , the correlation of reactor structure with the uniformity of photochemical vapor deposited ( PVD ) SiO2 films has been investigated and effect of process parameters on the uniformity of the film is discussed in this paper .

透射式GaAs光电阴极制作的关键是AlGaAs/GaAs四层结构外延层的MOCVD生长，影响AlGaAs/GaAs外延层结晶质量的主要因素是反应室结构、气体纯度以及衬底质量。

The key making process of transparent GaAs photocathode is the growth of A1GaAs / GaAs epitaxial layers by MOCVD . The major factors of affecting growth quality of AlGaAs / GaAs epitaxial layer are reactor structure of MOCVD equipment , purity of gas and quality of GaAs substrate .

湍流浸没射流反应区结构的数值计算

Numerical Computation of Reaction Zone Structure of a Turbulent Submerged Jet

低弹性模量钛铌锆锡合金铸件表面反应层结构的研究

A surface reacted layer study of Ti-Nb-Zr-Sn alloy after dental casting

液固环流反应器结构特性对固体流动的影响

Effects of Structure Characteristics of Liquid-Solid Loop Reactor on Solid Flow Behavior