加热室

镍管加热室在烧碱生产中的应用

The application of nickel heating chamber for caustic soda production

加热室是多晶硅铸锭炉的关键部件之一。

Heating chamber is pivotal part of the polycrystalline silicon ingot production furnace .

用此模型，对某厂的CAPL加热室仿真计算结果与现场实测数据吻合较好。

The results calculated are compared with those measured in the plant and show that the model is simple and practical .

本文介绍了等效简化CAPL加热室带钢的加热过程，并据此建立了物理模型和数学模型。

This paper introduces the equivalent and simplified heating process of the strip in the heating chamber of CAPL and establishes physical and mathematical models . On the basis of the models .

氯碱厂一效加热室失效分析及改造

Reforming and Fabricating One Effective Heater of Chlorine Alkali Plant

加热室胀口泄漏产生原因和解决办法

The Causes for Leakage in the Heater of Evaporator and the Solutions

加热室炉温控制数学模型的研究

Research on the Mathematical Model of Furnace Temperature Control for the Heating Chamber

腐蚀抑制剂在蒸发加热室中的工业试验

Industrial experiments of corrosion resisters in evaporation heating chambers

箱式双加热室电阻炉与应用

Box Furnaces With Double Heating Chambers and its Applications

从传热学角度探讨加热室加热蒸汽压力变化与对策

Discussion on the Change of Steam Pressure in Heater

本文应用传热学的理论知识，分析了真空蒸发制盐的加热室的传热机理。

This paper analyzed the mechanism of heat transferring with applications of the calorifics .

对中州铝厂氧化铝分厂800m2强制循环蒸发器加热室换管大修施工过程中的一些技术问题及处理方法作了介绍

It was presented of the technical problems and treatment methods in the overhaul of

浅析Ⅲ效加热室结垢的原因及处理

Analysis on the Courses and Treatments of Scaling in the Third Effect Heating Chamber

三顺Ⅰ效蒸发器加热室故障原因剖析

Analysis on the reasons for the faults of the first-effect heating chamber of three-effect downstream evaporator

加热室炉温对带钢热瓢曲影响的研究

Study on Influence of the Furnace Temperature in the Heating Chamber on the Hot Waved Surface of Strip

本文分析了蒸发罐蒸发室、二次汽道以及加热室等部位腐蚀破坏的机理，并提出了防护措施。

This article analysis the corrosion mechanism an evaporating room , carburetor and heater and poses the protection .

着重介绍了多晶硅铸锭炉加热室的结构设计。

This paper mainly introduce the structure design about the heating chamber of the polycrystalline silicon ingot production furnace .

联系运行实际遇到的问题探讨了引起加热室不正常的蒸汽压力变化的成因，并且提出了相应对策。

It also discussed the causes of deviant change of steam pressure in heater and advanced the countermeasures for it .

加热室采用圆形炉膛结构，增加了气氛流动的合理性，提高了炉膛有效加热区内的温度均匀性。

The heating chamber is circular , thus rationalizing atmosphere flow and increasing temperature uniformity in effective zone of the furnace chamber .

其主要改进包括将加热室从原来的上升管内沸腾段的下方移到了循环管的中下部较好地利用了空间，降低设备高度；

Firstly , the heating chamber is employed to circulating pipe from the ascending pipe to make fuller use of the space and to reduce the height of the equipment ;

在此基础上又通过建立带温前馈控制数模和综合炉温计算数模，进行了加热室加热过程的计算仿真。

Calculation and simulation of the heating process for the heating chamber is carried out by means of established mathematical models of the strip temperature feedforward control and the synthetic furnace temperature calculation .

卤水净化也称为卤水的预处理，目的是将原卤中的Ca2+、Mg2+在进入加热室前分离出来，以免其在加热管中结垢而影响传热。

Brine purification is also called brine pretreatment which aims to separate Ca2 + ? Mg2 + from raw brine before they enter heating chamber , for fear that scaling in heating tubes will affect heat transfer .

同时，通过热释放实验（TDS）以及存放实验证明，氦原子在铝膜中的存在比较稳定，低于500℃的条件下加热或者室温长时间存放不会造成氦原子的大量释放。

The thermal desorption experiments ( TDS ) and aging experiments showed that the helium in aluminum are stable , heating under 500 ℃ or leaving it in room temperature by 120 days did not lead to helium desorption .

水冷式加热雾化室的特性及其应用

Character and application of the cooling by water and heating spray chamber

提出了一种新型的可控小型蒸汽产生系统。利用低谷电能加热蓄热室的蓄热体，需要时利用蓄热体的热能加热水来产生蒸汽。为了提高换热效率采用直接接触换热。

A new controllable diminutive steam raising system is developed which uses heat storage to absorb the off-peak electric energy and to heat water into vapor when needed .

介绍了环式焙烧炉天然气供气监控系统、燃烧架的结构与功能及加热炉室温度控制过程。

The natural gas supply control system , structure and function of burning frame as well as temperature control procedure of furnace of the annular baking furnace are introduced .

在切断氧化剂供给，节流关闭发动机后，可以通过再次加热催化室重新实现发动机的启动，在节流时间较短的情况下也可以直接打开氧化剂阀门，利用催化室余热多次启动发动机。

The motor can be restarted either through re-heating the catalytic bed after shut off and cooling down or re-opening the oxidizer valve after throttling for a short time .

分析范围达5个故量级，即10~（-9）～10~（-5），采用水冷式加热雾室去溶，能防止雾化器堵塞；

The analytical ranges reach up to 10 ~ ( - 9 ) - 10 ~ ( - 5 ), Applying water cooling method to heat the spray chamber to remove solvent the nebulizer can avoid blocking . The delection limits are minimum ;

研究了圆筒型管式加热炉辐射室的传热计算。辐射采用Monte-Carlo法，对流采用射流模型，计算结果与实验结果基本符合。

The heat transfer calculation of the radiant section in circular type tube furnace was studied Using the Monte-Carlo method for the radiation heat transfer and the efflux mathematical model for the calculation of the convection heat transfer , the calculated results were basically agreement with these obtained from experiments .

加热炉燃烧室形状改进实践

Practice of modifying shape of combustion chamber in heating furnace