KPA

  • abbr.千帕;主要处理区域(Key Process Areas)
KPAKPA
  1. The flash point test result is automatically corrected to standard pressure ( 101.3 kPa ) .

    闪点测试结果会自动更正为标准压力(101.3千帕)。

  2. One KPA of level 4 are quantitative measurement and another is marketing control .

    可管理级的关键过程域分别是定量过程管理和营销控制;

  3. Investigation on operation temperature range of the rotary kiln in kPa process

    窑法磷酸旋窑操作温度范围的试验研究

  4. The maximum pressure on vehicle body is 169.573 3 kPa .

    在火炮发射过程中车身最大压力值为169.5733kPa。

  5. Investigation on AIDS KPA and Health Education of Different Populations in Yunnan

    云南不同人群艾滋病KPA调查及健康教育探讨

  6. The ambient gas pressure was set up to 10 kPa .

    使用的气体是Ar气,压强为10kPa。

  7. Requirement Management KPA ( key process area ) guides the management of requirement phase .

    需求管理KPA是CMM2级中的一个关键过程域,用来指导软件开发需求阶段的管理工作。

  8. Total pressure loss through water jacket is 40 kPa .

    水套总压力的计算结果为40kPa。

  9. This paper studied gas tungsten arc welding under 1-700 kPa air pressures .

    研究了1-700kPa空气作用下的钨极氩弧焊接。

  10. High hydrostatic pressure ( 23.9 kPa , HPC ) group ;

    高静水压组;

  11. Sheath gas pressure ( high purity liquid nitrogen ) was 35 kPa .

    鞘气(高纯液氮)压力35KPa。

  12. Investigation on kiln gas production in a rotary kiln for the kPa process

    窑法磷酸生产的旋窑制气试验研究

  13. The number of plates were 36 under the operating pressure 15 kPa .

    操作压力为15kPa时,理论塔板数为36块。

  14. At the optimal pressure about 2.7 kPa , the output power has a maximum .

    存在最佳氖压值2.7kPa,使激光输出功率最大。

  15. The pressure at the column head was 140 kPa .

    柱温为25℃。柱头压力为140kPa;

  16. The analysis results indicated that temperature uncertainty of PVT measurement system was less than ± 1.3 kPa .

    通过对系统的误差分析表明,实验系统的温度测量不确定度小于±6mK,压力测量不确定度小于±1.3kPa。

  17. Conclusion : Muscle hardness at 10 kPa reflects static tension of muscles .

    结论:预加负荷是10kPa时的肌肉硬度,反映了肌肉组织的静态张力;

  18. EEG Changes in Rats under 700 kPa Air and Nitrogen-oxygen Mixture Pressure

    700kPa空气和氮氧混合气条件下大鼠脑电图的变化

  19. The balloon pressure was 50 kPa and kept for 20 minutes .

    球囊压力50kPa,保留20min后撤除。

  20. The driving stress is basically below 100 kPa .

    冰帽驱动应力基本小于100kPa。

  21. The pressure of nasal continuous positive airway was 0.588-1.176 kPa for 6-8 hours every day .

    鼻持续气道正压通气压力0.588~1.176kPa,每日6~8h。

  22. The controlling accuracy of brake cylinder pressure reaches brake command target value ± 20 kPa .

    车辆制动缸压力的控制精度达到制动命令要求值的±20kPa。

  23. The ester is distilled under reduced pressure ≤ 5 0 KPa .

    减压蒸馏:蒸馏压力≤50kPa。

  24. Maximum total pressure uncertainty of HFC-125 data is estimated to be within 1.2 kPa .

    实验数据的最大不确定度小于1.2kPa。

  25. Inflation pressure of inflatable tours is at least 16.8 kPa .

    薄膜材料的充气圆环内部充气压力至少要达到16.8kPa。

  26. Now that we can verify the kPa unit .

    既然我们确认是朝鲜人民军分队。

  27. The pressure in vacuum layer should be controlled under 2 kPa to achieve desirable insulating effects .

    真空层压力应控制在2kPa以下,以获得满意的保温效果。

  28. RESULTS In the acute wound , blood flow increased when the negative pressure was at the level of 8 kPa .

    结果新鲜创面:8kPa负压时创面血流量即明显升高;

  29. Implementation Solution of SQA of CMM Level 2 KPA

    CMM二级KPA软件质量保证的一个实施方案

  30. The software requirement management ( SRM ) is the first key process area ( KPA ) in the CMM .

    需求管理是CMM中的首个关键过程域。