隧道窑

  • 网络tunnel Kiln;Hoganas
隧道窑隧道窑
  1. 隧道窑BP神经网络工况辨识的正交试验法研究

    Cross experimental design used in BP neutral net identification of tunnel kiln

  2. 煤矸石烧结砖隧道窑出车PLC自动控制系统设计

    Design of PLC automatic control system for waste coal sintered brick tunnel kiln cars

  3. PLC在隧道窑、干燥室运行系统中的应用

    Bubble Chamber Application of PLC in the Technological Systems of Tunnel Kiln and Dryers

  4. 基于VISUALFOXPRO的隧道窑结构设计软件的开发

    Development of the Tunnel Kiln Structrue Design System Based on Visual FoxPro

  5. 陶瓷隧道窑热平衡计算VB程序

    A VB Language Program for the Calculation of the Thermal Balance on Ceramic Tunnel Kiln

  6. 双层推板式PTC隧道窑及其控制过程

    A Two - Story Pushing Board Tunnel Kiln and Its Controlling Process

  7. 对隧道窑用后的一种再结合镁铬砖做了扫描电镜、能谱分析、X射线衍射和化学分析。

    A rebonded magnesia - chrome brick used in the crown of tunnel kiln has been studied by means of SEM , EDAX , XRD and chemical analySis .

  8. 我国改进型DRI隧道窑的设计研究

    The design aspect of the improved tunnel furnace for making DRI in China

  9. 利用CFD软件模拟了隧道窑急冷带内喷嘴喷射速度的改变对窑内气体流动的影响,分析了窑内气体的速度和温度分布情况。

    Effect of jet velocity exchange on gas flow in cooling section of tunnel kilns was numerically simulated with CFD software , and the velocity and temperature distribution were analyzed .

  10. 80m全自动天然气隧道窑监控系统的设计

    Design on Monitor System of 80-meter-long Full Auto Control Natural Gas Fueled Tunnel Kiln

  11. 其中,隧道窑法燃耗最高,COF连续炉法的燃耗最低。

    Tunnel kiln process has maximum coal comsumption and COF process has minimum value .

  12. 利用OM、SEM、EDAX和XRD检测方法研究了一种在隧道窑烧成带使用10年的再结合镁铬砖显微结构均化现象。

    Microstructural homogeneity of a rebonded magnesia-chrome brick used in tunnel kiln in a period of 10 years were studied by means of OM , SEM , EDAX and XRD .

  13. 36m小断面高温隧道窑

    36m small section high temperature tunnel kiln

  14. 编制了陶瓷隧道窑热平衡计算VB程序,主要包括预热带及烧成带、冷却带和全窑热平衡计算。

    A VB language program for the calculation of the thermal balance on ceramic tunnel kiln was offered in this paper , the thermal balance calculation mainly including preheates-belt and fired-belt and cooling-belt and total kiln .

  15. 由于隧道窑工况复杂,难以用精确的数学模型来描述。本文以现场数据为基础,采用BP神经网络对窑温模型进行辨识。

    Because the tunnel kiln is a complicated object which is hard to establish an exact mathematic model , so this paper identifies the dynamic model of the tunnel kiln temperature object through BP neural network based on the data from field .

  16. 本文以BP神经网络辨识的窑温模型为被控对象,根据隧道窑温度控制的要求,设计一种基于模糊神经网络的温度控制器。

    In this paper , we take the tunnel kiln temperature model identified by neural network as an object to be controlled . According to the requirement of the temperature control , we design a kind of new controller based on fuzzy neural network .

  17. 用16m工业电热隧道窑,对裂解汽油一段加氢LY-8601催化剂用载体进行了焙烧实验。

    The roasting test of carrier for LY-8601 catalyst in pyrolysis gasoline hydrogenation was studied in a 16 m tunnel kiln .

  18. Mn-Zn铁氧体烧结推板窑是一种在氮气气氛保护下烧结铁氧体的连续式推板隧道窑(以下简称连续式氮窑)。

    Pushing kiln for sintering Mn-Zn ferrite magnet is a kind of continuously pushing tunnel kiln ( noted Continuous Nitrogen Kiln below ), in which ferrite magnet is sintered under Nitrogen protection .

  19. 重点分析了Hoganas法中隧道窑-固体炭还原法生产直接还原铁的特点;

    Emphasis is put on analysing the characteristic of the tunnel furnace-solid carbon reduction to make DRI among Hoganas processes .

  20. 根据目前国内工业隧道窑的特点,设计了WCY隧道窑进车周期误差记录仪。

    《 WCY feeding cycle error recorder for the tunnel furnace 》 is designed according to the features of domestic industrial tunnel furnace s.

  21. 采用火箱车燃重油法对111m粘土隧道窑进行烘窑,解决了硅质内衬的裂纹和掉角、掉片问题,而且减少了热量损失,操作简便,容易控制温度

    To apply the fire box carriage with firing fuel oil to dry the 111m clay channel oven has solved the problems of crack , losing angle and sheet of siliceous lining in channel oven and it can decrease heat loss , do operating convenience and controlling temperature convenience

  22. 目前隧道窑在烧成中,热损失严重。

    The thermal abandoning of tunnel kiln agglomeration is very critical .

  23. 微机在油烧隧道窑还原焰烧成控制中的应用

    Application of microcomputer Control to Oil Fired Tunnel Kiln with Reduction

  24. 双孔隧道窑自动送进控制系统

    The Automatic Feeding System of the Double - Hole Tunnel Furnace

  25. 模糊辨识法对隧道窑工况识别的研究

    Study on the tunnel kiln operating model by fuzzy identification method

  26. 隧道窑车轴承用高温润滑脂

    High temperature lubricating grease applied to kiln vehicle bearing in tunnel

  27. 新型宽体节能隧道窑的开发

    Development of the Energy - saving Broad - body Tunnel Kiln

  28. 隧道窑预热带温差的改善

    An Improvement on Temperature Difference of Preheating Zone of Tunnel Kiln

  29. 介绍一种新型的宽断面节能隧道窑

    Introduction to a new wide section energy - saving tunnel kiln

  30. 关于隧道窑冷却带结构的改进

    Reform about the structure of the cooling zone in tunnel kiln