节流

jié liú
  • throttle;choke;reduce expenditure;orificing;decrease expenditure;economize on expense;throttle down, throttle back
节流节流
节流 [jié liú]
  • (1) [throttle]∶节制流入或流出,尤指用节流阀调节

  • (2) [reduce expenditure;decrease expenditure;economize on expense]∶在财政上节省支出

  • 开源节流

节流[jié liú]
  1. 为了达到节流的目标,我们已经展开了精简政府部门架构的工作。

    In order to reduce expenditure , we have already begun streamlining departmental structures .

  2. 节流阀的数字化改造及PLC主控单元控制

    Digital rebuilding of choke valve and control with main control unit of PLC

  3. 先导式比例方向节流阀数字PID调节

    Digitizing Adjusting for the Electro-hydraulic Proportional Direction Throttle Valve

  4. 在这个虚拟实验台架上,异地的实验者可以通过Internet/Intranet远程访问,完成液压系统节流调速实验,基本上达到了远程教学的要求。

    In this virtual experiment , the remote operators can do their experiment through the Internet / Intranet .

  5. 本文展示了如何通过节流和分派功能扩展ESB。

    This article showed you can extend ESBs with throttling and dispatching functions .

  6. 根据以上针对WebSphereESB节流器和分派器的需求,有四种解决方案设计可供考虑

    Given the above requirements for a WebSphere ESB throttler and dispatcher , four solution designs were considered

  7. 着重分析了解耦设计、PID参数鲁棒整定、发热量校正、凝结水节流这些工程技术上的实用方法。

    Some engineering applied methods , such as : decoupling design 、 PID parameters robust tune 、 heat value emendation and water of condensation throttle are analyzed .

  8. 开发CO2膨胀机代替节流阀是提高CO2跨临界循环系统性能系数的一个有效途径。

    As the replacement of throttling valve , CO_2 expander is a significant way to improve the coefficient of performance of the CO_2 transcritical cycle .

  9. 利用计算机VB和Fortran语言编程技术,开发了适用于热泵空调器的短管节流件设计和校核计算可视化软件。

    A visual software applied to choose the short tube restrictor of heat pump air conditioners has been developed with VB and Fortran computer languages .

  10. 另一个例子是,使用IntelSpeedStep或相似技术的系统会对CPU电源进行节流。

    Another example includes systems that use Intel SpeedStep or similar technology to throttle CPU power dynamically .

  11. 作为协议,MQTT没有节流功能。

    As a protocol , MQTT has no throttling features .

  12. 通过计算和试验,确定了填充PTFE材料密封填料环的径向和轴向间隙,并分别采用尼龙、锡青铜和铸铁3种材料设计制造出了阻流环和节流环。

    Abstract The Packing seal rings filled PTFE ( teflon ) are designed , the suitable radial and axial clearances are determined through calculation and test .

  13. 当压缩机和膨胀机的效率一定时,CO2节流阀循环的最佳高压压力比膨胀机循环的高。

    When the compressor and the expander efficiencies are given , the optimal heat rejection pressure in the CO_2 throttle valve cycle is greater than that of in the expander cycle .

  14. 节流阀把高压侧压力节流到蒸发压力,同时控制高压侧压力并使其随气体冷却器出口温度的变化而变化,CO2制冷系统调节特性与传统制冷系统不同。

    By throttles , the high pressure is dropped down to evaporator pressure , and changed with the refrigerant temperature at the gas cooler , the regulation characteristics of the system are different from traditional system .

  15. 用P-Q图分析差压式变量叶片泵和节流阀的调速回路

    Analyzing the Speed Control Loop Made of the Pressure - Compensated Vane Pump and the Adjustable Restrictor Value with the Drawing P-Q

  16. 利用美国Lord公司生产的MR-132D磁流变液体,设计了一种小孔节流型阻尼器。

    This paper , with the use of MR-132D Magneto-rheological fluid which produced by Lord corporation of USA , designed a kind of orifice throttle damper .

  17. 为减小CO2跨临界循环系统节流部分的膨胀功损失,提高系统性能,可在小型制冷系统中采用喷射器代替节流阀,部分回收工质从高压到低压过程的膨胀功。

    An ejector should be adopted in some low cooling-capacity refrigerating systems instead of a throttle valve to recover some high-pressure potential power and reduce the irreversible energy loss of throttle process for improving the energy efficiency ratio ( EER ) of the CO_2 system .

  18. 结果表明,节流槽结构特征对阀内压力分布、气穴与噪声特性有直接的影响,U形槽内部压力超调量明显高于V形槽,可以显著抑制气穴的析出与生长。

    The results show that the structural characteristics of throttling grooves have direct influences on pressure distribution , cavitation and noise inside the valve . Pressure overshoot inside U-notch is much higher than V-notch , and can restraint the inception and development of cavitation .

  19. 本文建立了计算先导式溢流阀的先导锥阀口、主阀锥阀口和固定节流器的流量系数随雷诺数变化的函数模型,应用TKSolver软件对先导式溢流阀静态特性进行计算机仿真。

    It establishes the models of discharge coefficient varying with Reynolds number of both variable and fixed orifices and steady - state characteristics of the pilot - relief valve are simulated by using TK Solver .

  20. 节流在将更新发布到Pachube方面变现尤为明显,基本网站成员每分钟只允许更新三次。

    Throttling is particularly apparent in the area of publishing updates to Pachube & basic site membership allows only three updates per minute .

  21. 结合帕萨特B5轿车空调系统,采用电子膨胀阀代替热力膨胀阀作为节流机构,开发研制了基于单片机的轿车空调全自动控制器。

    Based on the air condition system of PASSAT B5 , the SCM-based full automatic controller of car air condition systems are developed with the electronic expansion valve substituted for the thermostatic expansion valve .

  22. 开发了进气电加热、进气道喷油、排气管节流EGR及爆震等监控和试验数据采集系统,实现了单缸进气温度、供油量、排气再循环(EGR)的控制和检测,阐明了其结构与工作原理。

    The monitoring and data acquisition systems of the electronic inlet air heating , low pressure injection for the intake pipes , throttle control EGR for the exhaust pipes and knocking inspecting , were developed and used well in the engine testing .

  23. QCS003型液压实验台主要包括:由液压泵、溢流阀、节流阀等液压元件组成的液压泵性能实验液压系统;

    QCS003 type liquor pressure laboratory bench include mainly : liquor pressure hydraulic pump performance experiment liquor pressure system of pump ;

  24. 某型号节流圈,其结构特点是壁薄,壁厚仅2.5mm,轴向尺寸小,精度高,刚性差;

    Structural feature of throttle ring are thin wall part ( wall thickness 2.5 mm ), short axial dimension , high dimension precision and poor rigidity .

  25. 对微型VPSA制氧反吹流程进行了实验研究,探讨了反吹气量、节流阻力、产品气量对产品气纯度的影响规律。

    The miniature VPSA purge-to-product process was studied by experiments and the effects of operating parameters , such as purge-to-product , resistance of throttle , product flow rate on the product ( purity ) were investigated .

  26. 宝马Valvetronic引擎在进气入口点有一个传统的节流板,但只有发动机不运行和启动后的短暂时间内是关闭的。

    BMW Valvetronic engines have a conventional throttle plate at the intake 's entry point , but it closes only when the engine is not running and for a brief period after start-up .

  27. 文中提出的空气阻尼比图表(PDRD)不但适用于模式结构空气阻尼表述和设计,而且方便选择体积比和节流小孔开度,对于该类模式结构的空气阻尼设计和研究具有普遍意义。

    The proposed pneumatic damping ratio diagram ( PDRD ) was not only a desirable tool to represent and design air damping of structure unit , but helpful to determine volume ratio and orifice opening , thus it was of general significance for air damping design and investigation .

  28. 从压力损失看节流装置的改造选型

    Transformation and Type Selection of Throttling Devices According to Pressure Loss

  29. 节流机构流量特性试验台的研制

    Development of Test Bench on Flow Characteristic of the Throttle Mechanism

  30. 提出了双锥节流装置和梭形节流装置数值模拟的正交实验分组仿真方法。

    A means of grouping orthogonal experiment is presented for simulation .