电路板焊接

在完成PCB设计和电路板焊接后，对电路板进行了硬件调试，验证了各个模块的功能运行正常。

After completing the PCB design and circuit board soldering , it has a hardware debugging on the circuit board in order to verify that the normal function of each module .

印刷电路板焊接缺陷分析

The Analysis of Welding Flaw on Printed Circuit Board

包括芯片选型，部分原理图设计，电路板焊接并进行硬件测试。（4）系统软件程序设计。

Including selection of hardware chips , part circuit schematic design , jointing circuit board and hardware test . ( 4 ) The system software program design .

为有效检测电路板焊接质量与器件质量，实现高精度的故障定位，提出了基于边界扫描技术与功能测试技术的解决方案。

In order to test the soldering quality and device quality , and to define faults position high accurately , this paper put forward a solution to solve the problems based on boundary scan and functional test technology .

本文主要介绍了印制电路板组装件焊接后非ODS清洗剂清洗质量表征参数的测量方法。

The measurement method of the characteristic parameters of the cleaning quality about welded printed circuit board assembly cleaned by non-ODS cleaner is introduced in this paper .

国际标准为电路板选定了焊接针连接器。

The international standard specifies a soldered pin connector for circuit boards .

印制电路板的波峰焊接

Wavecrest soldering of printed circuit board

单面电路板通孔再流焊接技术

Pin-through-hole Reflow Soldering Technology for Single-sided Board

文中介绍了具体的软硬件设计，进行了电路板和元器件的焊接、程序的调试。

In this paper , the specific hardware and software design , a circuit board and components of the welding , the debugging process .

同时，它也是众多优化问题的简化形式，如基因组制图、行星探索、电路板钻孔、电路板焊接、交通调度、作业调度等。

It is the simplify form of many optimization problems such as genome mapping , planetary exploration , the drilling of circuit boards , circuit board welding , traffic scheduling , job scheduling and so on .

基于仿真结果使用Protel软件设计出射频前端电路的版图，电路制版完成后对电路板进行焊接并完成电路调试，确保电路能够达到设计的目标要求。

After the simulation , we design the RF front-end circuit layout by using Protel software . When circuit board is completed , debug the circuit and analyze the results to find out the reasons for deviations and make improvements .