高压缸

结构新颖的桶型高压缸设计开发

Unique Design for Barrel Type High Pressure Cylinder

运用故障分析理论成功地诊断了CO2压缩机高压缸出现的隔板松动机械故障。

Diaphragm loose mechanical trouble of CO 2 compressor high pressure cylinder is successfully diagnosed by using analysis theory .

CO2离心式压缩机高压缸转子变转速、变流量工况下轴向推力的计算与分析

Calculation and analyses of the axial thrust of the rotor in the high pressure cylinder of a CO2

600MW机组高压缸轴封漏汽定量分析

Quantitative Analysis of Steam Leakage through the Gland Seal of 600 MW Steam Turbine

600MW汽轮机高压缸尾部鼓风故障分析及对策

Analysis of blast fault at the tail of high pressure cylinder in 600 MW turbine and countermeasures

东汽600MW汽轮机高压缸暖缸程序的完善

Improvement of Heat Soak Program of HP Cylinders of 600 MW Turbine manufactured by the East Turbine Works

阐述了300MW汽轮机高压缸动叶顶部汽封的基本结构及改进形式，并对“蛇型”弹簧片的工作原理做了理论性的分析。

The basic structure on the top of blade , which in300MW turbine HP gland and the way to change betters are introduced .

200MW汽轮机高压缸中汽流激振对轴系稳定性的影响

Influence of Steam Excitation in 200 MW Steam Turbine 's HP Cylinder on Stability of Rotor line

某电厂一台300MW汽轮机存在高压缸排汽温度偏高现象。

Exhaust steam temperature being on the high side ' of high pressure cylinder existed on one 300 MW steam turbine of a certain power plant .

合成气压缩机（103-J）高压缸污油收集器漏油原因分析及对策

Oil Leak Causes Analysis and Disposal of Dirty Oil Collector for High Pressure Cylinder of Synthetic Gas Compressor 103-J

超临界K-320-23.5-4型汽轮机高压缸通流部分热力性能分析

Thermodynamic performance analysis of HP steam flow path of a k-320-23.5-4 type supercritical pressure turbine

主要探讨200MW汽轮机组法兰螺栓加热装置对高压缸胀差的影响。

This paper focuses on the influence of the flange and bolt heating equipment on differential expansion of HP casing in200MW steam turbine .

某电厂国产引进型300MW汽轮机组在运行中发现高压缸排汽温度偏高，影响机组的经济运行。

Temperature rising of HP turbine exhaust steam , which affected the economic performance of turbine unit , was found during operation of a 300 MW turbine unit manufactured with foreign patent .

通过对合成101-J空气压缩机高压缸隔板导叶修复的实践，总结了铸铁焊接在实际工作中的运用和指导作用。

By the example of repair the guide blade of high cylinder in air compressor , summarize the experiences of cast iorn welding .

结合托电600MW机组汽轮机的实际运行情况，介绍2台600MW日立公司生产汽轮机的结构特点，中压缸及高压缸启动注意事项，比较中压缸启动方式和高压缸启动方式的优缺点。

This paper introduces the structure characteristics of 600 MW steam turbine made in Hitachi Co. , and points out the notices of IP start and HP start , and compares the merits and demerits of the two start modes .

西柏坡发电厂300MW＃1机在额定参数下带不满负荷的主要原因是汽轮机高压缸内效率低、通流面积小、汽封系统泄漏严重。

Unit 1 in Xibaipo Power Plant could not operate in full load with rated parameter steam because of the low internal efficiency of the high pressure turbine , small flow path area , and serious leakage of steam gland system .

本文应用文献〔1〕中的方法对国产200MW汽轮机高压缸围带、隔板及轴端的迷宫汽封中的汽流激振系数进行了计算。

Abstract The Steam excitation coefficients at shroudings and diaphragms , and in labyrinth glands of shaft end of demestic-made 200 MW steam turbine 's HP cylinder are calculated by using the method in Reference [ 1 ] .

针对某台K-200-130-3型200MW汽轮机2号轴承故障问题进行了试验研究，结果表明引发故障的主要原因是高压缸喷嘴不对称进汽产生的横向剩余力。

The fault problem existing on No. 2 bearing of one K-200-130-3 type 200 MW steam turbine was tested and studied , the result showed that the main cause of fault was the transverse residual force resulting from the unsymmetrical steam admission of high pressure cylinder nozzles .

二氧化碳压缩机高压缸轴端密封的改造

Improvement of the shaft seal for HP cylinder of co_2 compressor

汽轮机组高压缸进汽端结合面漏汽处理

Steam Leakage Treatment on Inlet Adjoining Plant of Turbine HP Cylinder

亚临界机组汽轮机高压缸结垢原因分析

Reason analysis of high pressure cylinder encrust in subcritical unit turbine

核电站汽轮机高压缸入口压力控制模式改进研究

Study of Turbine HP Inlet Pressure Control for Nuclear Power Plant

汽轮机高压缸内部漏汽的试验分析与处理

Test Analysis and Treatment of Inner Steam Leak in Turbine HP Cylinder

氧压机高压缸缸内燃烧分析

Combustion Analysis in the High Pressure Cylinder of Oxygen Compressor

核电汽轮机高压缸的通流部分大部分处于湿蒸汽区。

High-pressure cylinder of nuclear steam turbine works in wet steam area .

合成空气压缩机高压缸隔板导叶的修复

Repair of Guide of High Pressure Cylinder in Air Compressor

汽轮机高压缸蒸汽激励故障分析与诊断

Diagnosis of Steam Oscillation Fault of the Steam Turbine Generator

高压缸螺栓孔裂纹处理方法

Handling of Crack in Bolt - hole of HP Cylinder

空气压缩机高压缸振动原因分析

Reasons for the shaft vibration of high pressure cylinder of air compressor

水刀高强度的复合高压缸设计

Design of superhigh pressure combine cylinder for water jet machining