轿厢

  • 网络Car;cabin;Cab
轿厢轿厢
  1. 并结合电梯总体参数及轿厢结构的CAD系统,得到具体应用。

    The cooperative design of elevator based on the Internet is also set up , and is applied in parameter design and car structure design of elevator .

  2. 运用数值计算方法,采用matlab仿真,得出电梯轿厢振动位移、速度、加速度的仿真曲线。

    Using numerical methods , adopt matlab programming , and obtain the elevator car vibration displacement , velocity and acceleration of the dynamic response simulation curve .

  3. 液压电梯轿厢速度的PDF控制

    PDF Control of Hydraulic Elevator Speed

  4. 我公司提供的主要电梯部件有:控制柜、主机、LED吊顶、对讲机、操作面板及特殊(豪华型)的轿厢的设计和制造。

    The main elevator parts which we can provide are below : Controller , Gearless machine , LED ceiling , interphone COP ; and the designing and manufacturing for some special ( luxury type ) cabin .

  5. 在现有的电梯轿厢平层精度控制中,大都采用PID控制方式,难以满足高速电梯的使用性能要求。

    PID control means is usually used in the current leveling precision control of the elevator car . It is difficult to meet the requirements for usage performance of elevator at high speed lifting .

  6. 应在离轿厢地面以上约600mm处实施声音测量。

    Sound measurement shall be taken at approximately600mm above the car floor .

  7. 介绍了RS-485串行通信总线的特点及其在电梯控制中的应用,阐述了电梯轿厢、厅门信号传输与控制的工作原理,给出了系统的硬件实现和软件设计思路。

    This paper introduces the characteristic of RS-485 and its application in elevator control system ■ describes operating principle of serial communication system of elevator ■ and gives the frame of hardware linkage and software programming of system .

  8. 针对传统机械设计方法设计周期长、产品形式单一的问题,本文以电梯轿厢结构设计系统为例提出了基于模块化和参数化设计的机械产品CAD方法。

    There exist problems of longer design cycle and lower efficiency with common mechanical product design method . In response to it , this paper presents and illustrates a CAD method based on modular and parameterized design , with the aid of elevator car design .

  9. ⑵利用MATLAB软件分别对曳引电梯的12自由度垂直振动模型和水平方向8自由度振动模型进行仿真,分别得到高速电梯轿厢垂直振动的最大峰峰值与水平振动的动力学模型曲线。

    ⑵ Through MATLAB software on traction elevators were 12 degrees of freedom vibration model and the horizontal direction perpendicular to 8 degrees of freedom vibration model simulation , respectively , high-speed elevator car by the maximum peak to peak vertical vibration and horizontal vibration of the dynamic model curve .

  10. 介绍维纳数字滤波技术的基本原理,并以一种轿厢速度反馈闭环控制的VVVF液压电梯为实例,针对轿厢速度反馈信号的特点,完成FIR维纳数字滤波器的设计、仿真及实验比较。

    This paper introduces Wiener Digital filtering Method and its application in cabin speed feedback colsed-loop System of VVVF controlled hydraulic elevators . based on the feedback signal of the cabin speed , simulation and experiment of the FIR Wiener Digital Filter are achieved .

  11. 轿厢负载采用精密压力传感器;

    The sedan theater box load uses the precise pressure transmitter ;

  12. 电梯轿厢重量的改变对曳引能力的影响

    Influence on Traction by Adjusting the Weight of Elevator 's Car

  13. 如果电梯轿厢接近楼层地面,电梯门会打开。

    If you are near the landing the door will open .

  14. 轿厢指令登记应点亮相应的指示灯。

    Registration of car call shall cause corresponding light to illuminate .

  15. 依轿厢所需上下方向转动盘车手轮。

    Turn winding crank for required direction of movement of car .

  16. 采用轿厢速度反馈控制的液压电梯系统

    The Speed Feedback Control Systems of Hydraulic Elevator Using Single Chip Microcomputer

  17. 包括必要的轿厢导轨钢筋加固和支撑。

    Include steel reinforcement and backing for car guide rails where necessary .

  18. 提供可上锁、平镶辅助轿厢站操作按钮。

    Provide a lockable , flush-mounted auxiliary car station 's operating buttons .

  19. 服务的最后一个升降平台至轿厢顶板的测量值。

    Measured from last landing served to , top of machine slab .

  20. 基于CAN总线的电梯轿厢控制器设计

    Design of an elevator car controller based on CAN Bus

  21. 电梯导轨对轿厢振动的影响

    Influences of Elevator Guide Rail on the Cabin Vibration

  22. 电梯楼层及轿厢CAN总线通讯设计

    CAN bus communication design for elevator floor and cage

  23. 倒拉式变频液压电梯系统的轿厢振动分析

    Cabin vibration of VVVF hydraulic elevator system with pull-cylinder

  24. 轿厢外壳应具有应急出口,应急出口符合当地规范要求。

    Car enclosure shall have emergency exits that conform with local code requirements .

  25. 维纳数字滤波技术在轿厢速度反馈闭环控制的液压电梯中的应用

    Application of Wiener Filtering Method in cabin speed feedback closed-loop controlled hydraulic elevators

  26. 此条件下,轿厢上安装的响亮的警报蜂鸣器应发出警报。

    Under these conditions , loud warning buzzer located on car shall sound .

  27. 液压电梯轿厢架的有限元计算

    Finite Element Analysis on A Hydraulic Elevator Car Frame

  28. 电梯轿厢噪声控制研究

    Research on the Noise Control of an Elevator Cabin

  29. 停点或钢丝绳打滑,不丢失轿厢位置。

    No loss of car position during longer power failure or rope slipping .

  30. 轿厢操作面板内提供对讲机站。

    Provide an intercom station within car operating panel .