模量

拉伸弹性模量E对抽拔力的影响

The Effect of Modulus of Elasticity in Tension on Pulling Force

用CCD图像传感器测量杨氏弹性模量的研究

Measurement of Yang 's Elastic Modulus with Charge - Coupled Device

建议了一个可用岩石初始状态CT数和弹性模量的单轴损伤本构方程，并用算例进行了验证；

A axial damage constitutive equation is proposed and testified .

用Marx法精确测量内耗和弹性模量时的计算公式

Formulae for measuring internal friction and modulus by Marx method

PET及PA的模量&应变曲线都是明显的双峰曲线。

The modulus-strain curves of PET and PA have two peaks .

工业用及服用PET纤维的模量-应变曲线及其分析

Modulus-Strain Curves of Industrial and Apparel PET Filaments

CCD测量杨氏模量的研究

A study for measuring young modulus with CCD

静态变形模量E（v2）标准的应用与展望

Application and Prospects for Static Deformation Modulus E_ ( v2 ) Standard

经验应力松弛模量与Maxwell模量的转换计算方法

A Computational Method for Experimental Stress Relaxation Modulus Transited to Maxwell Modulus

共混硫化胶的压缩弹性模量随SBR用量的增加而降低，当SBR用量为5份后，-40℃时的压缩弹性模量约为纯CR硫化胶的一半；

The compression elastic modulus of CR / SBR blends decreased with the content of SBR increased ;

变形模量E（v2）与K（30）平板载荷试验的对比分析

Comparison Analyses of the Strain Modulus E_ ( v2 ) and K_ ( 30 ) Plate Loading Test Methods

MDF的硬化是应变增加的结果，它以降低弹性模量为代价；

The MDF was hardened at the expense of elastic modulus decrease .

岩石弹性模量与毕奥特（Biot）系数在压裂设计中的应用

Applications of elastic modulus and Biot coefficient of rock in fracturing design

探讨了氯丁橡胶（CR）/丁苯橡胶（SBR）共混胶料的硫化特性，共混硫化胶的力学性能、压缩弹性模量和动态力学性能。

The curing behavior , mechanical properties , compression elastic modulus and dynamic mechanical properties of CR / SBR blends were investigated .

同时将割线模量计算沉降的方法应用到高填方自身作用下的最终沉降计算中，通过与应用e～p曲线计算的结果进行比较，其误差在允许范围之内。

The secant modulus is used to calculate final settlement of high-stacked soil , compared with the result of e ~ p curve , the error is in the limit of tolerance .

大理岩动态拉伸强度及弹性模量的SHPB实验研究

Experimental Study for Dynamic Tensile Strength and Elastic Modulus of Marble using SHPB

挠曲模量–1%正割（根据ASTMD790A）

Flexural Modulus - 1 % Secant ( Based on ASTM D 790A )

PBO纤维复丝性能因测试标准不同其拉伸强度和拉伸模量相差较大。

Because different complex bundle testing standards are used , tensile strength and modulus differ greatly .

结果表明：木粉含量、偶联剂和双螺杆挤出机的螺杆转速都对复合材料的存储模量（E′）和损耗角正切值（tanδ）有一定影响。

The results show that the mechanical properties of composites are affected by wood flour loading , coupling agent and rotation speed of the double screws of extruder .

低负载条件下强度失效概率和Weibull模量均是固体催化剂强度可靠性的特征指标。

The failure probability in the low loading range and Weibull modulus are both the characteristic indices for the mechanical reliability of solid catalysts .

Oedometer试验指标的剪刀型错误及用弦线模量的改正

Scissors Model Error of Oedometer Index and Its Correction by Chord Modulus

指出：室温下Al／SiC复合材料的阻尼主要是由增强颗粒与基体材料间弹性模量的不同造成的。

From the results , it was concluded that the damping of the composite Al / SiC was mainly generated from the differences of elastic module between the enhanced particles and matrix under room temperature .

在ANSYS中对其进行二次开发，通过利用ANSYS中的参数化设计语言APDL编写了关于漫湾电站的建模和计算程序，并且ANSYS中得以很好的运行，最终得到38个时刻的弹性模量值。

The second exploitation is made on ANSYS and the procedure of building model and calculation is complied using ANSYS Parameter Design Language-APDL . The procedure has finished thirty-eight times calculation .

由时温等效原理按Arrhenius移位因子得到基准温度下的拉伸模量主曲线。

A master curve of tensile modulus is obtained through the equivalence principle of time and temperature , using the Arrhenius shift factor .

用直接补偿法可以测定纤维皮芯双折射率的分布.最后对这种皮芯双折射差异对纤维热定型之后PET工业用丝的模量、干热收缩及强度和耐疲劳性能的影响进行了讨论。

Thus there is a difference of the birefringence between sheath and core which can be measured by direct compensation method , the effects of which on the property of PET industrial filament after heat treatment are discussed .

结论：比较PMMA骨水泥的张应力和负载循环试验，CAP骨水泥的弹性模量是PMMA的5倍，并且具有较高的疲劳强度。

Conclusions : Comparing the two bone cements , the CAP has a higher modulus which is as about5time as the PMMA , and the CPA has a superior fatigue strength as well .

应用MATLAB、PSI-PLOT等数据处理软件，研究不同应变、不同应变率下生猪软骨组织无约束压缩应力&应变、稳态弹性模量之间的关系。

Utilizing MATLAB and PSI-PLOT data processing software , the relationship between stress-strain and equilibrium modulus under different strain and strain-rate are investigated .

超细SiC片晶由于其高强度、高弹性模量和导热系数已成为替代价值昂贵、制备技术复杂SiC晶须的理想的增韧材料。

The ultrafine SiC platelets , as an ideal toughening material , has been substituted for SiC fiber which is expensive and hardly prepared , because of its high strength , high modulus of elasticity and thermal conductivity .

饱和砂剪切模量和阻尼比在GZ-1型共振柱仪上的测定

Determination of Shear Modulus and Damping Ratio for Saturated Sand by GZ-1 Resonant-Column Apparatus

首先，建立空间分析模型，运用ansys对模型进行模态分析和谐响应分析，求得各点的振幅，进而求出动态弹性模量。

Firstly , set up the space analysis model , carry on mode and harmonious analysis to the model with ansys , try to get the amplitudes of each point , and then calculated the dynamic modulus of elasticity .