干燥条件

  • 网络drying;drying condition
干燥条件干燥条件
  1. 喷雾干燥条件对PVC专用树脂质量的影响

    Influence of spray drying condition on quality of special resin

  2. 干燥条件对合成超微粉体Y2O3粒径的影响

    The Effect of Various Drying Conditions on Ultra Fine Y_2O_ 3 Particle Size

  3. 应用Matlab软件进行多项式曲线拟合,表明二次多项式能够有效地表达各干燥条件下的银耳干燥动力学曲线。

    Quadratic polynomial could express drying kinetics curves of every drying condition by using Matlab software for polynomial curves fitting .

  4. 本实验研究了微波干燥条件对马铃薯颗粒全粉水分含量、白度、VC含量的影响。

    The microwave drying conditions which Influence moisture content , whiteness and VC content of the potato granulespowder were studied .

  5. 讨论了远红外专用料以及干燥条件、组件、过滤器等纺丝工艺参数对POY可纺性的影响,确定了远红外细旦丙纶高速纺丝最佳工艺参数。

    The optimal technological parameters for far-infrared fine denier PP POY were determined .

  6. 正极板干燥条件对VRLA电池性能的影响及其机理分析

    The influence and the mechanism analysis of drying conditions of positive plates on VRLA battery performance

  7. 合适的干燥条件使PVDF的结晶度高,晶胞参数a大、b小,电池性能好。

    The proper drying condition made the crystallinity of PVDF higher , the unit cell parameter a larger and b smaller , the lithium ion battery performance better .

  8. 在同样干燥条件下,8mm切片抗坏血酸保持得最好;

    Under the same drying condition , 8mm slice could get the best AA keeping .

  9. 塑料管系统-玻璃增强热固性塑料(GRP)管-干燥条件下测定蠕变因素

    Plastics piping systems-glass-reinforced thermosetting plastics ( grp ) pipes-determination of the creep factor under dry conditions

  10. 实验结果表明:还原剂、溶剂、P/V、干燥条件及焙烧温度都对VPO催化剂的物理性质有影响。

    The results showed : reductive agent , solvent P / V ratio , condition of drying and temperature of calcination had influence over the physical properties of VPO catalysts .

  11. 研究了以聚偏氟乙烯(PVDF)作为正负极粘结剂制造锂离子电池,极片干燥条件对聚偏氟乙烯(PVDF)的影响大。

    The influence of electrode drying condition on crystallization of PVDF has been studied in the lithium ion battery where PVDF acted as the binder of electrode .

  12. 本实验中所获得的TiO2气凝胶表面积在常压干燥条件下还可达到500m2/g以上,其较大的比表面积应归功于溶剂热处理过程中凝胶网络强度的增大。

    The higher surface area of TiO2 aerogels dried at atmosphere were over 500 m2 / g , which might due to the strengthed network of the gel during the solvothermal process .

  13. 在喷雾干燥条件:进风温度180~190℃,出风温度80~90℃,进料速度30ml/min下所得产品包埋率为92.06%。

    Efficiency of encapsulation was 92.06 % under the condition of spray-drying : inlet temperature 180 ~ 190 C , outlet temperature 80 ~ 90 C , feeding rate 1.81/hr .

  14. 利用各种测试方法的不同特点来研究各种不同干燥条件下CSH凝胶的孔形态。

    The author emphasizes that a lot of measuring methods that have different characteristics should be used to study pore morphology of CSH gel in different drying conditions .

  15. 用嫁接设备纺制涤纶FDY,讨论了切片干燥条件,纺丝温度,熔体压力,冷却成形条件等对FDY质量的影响。

    PET-FDY was prepared by using combination equipment . The effect of chips drying condition , spinning temperature , melt pressure and cooling condition on the quality of FDY was discussed .

  16. 结果表明:当AFRP-水泥砂浆试件在25°C水中浸泡1~5d,其抗弯断裂荷载随时间的增加基本不变,但显著低于室温干燥条件下的抗弯断裂荷载;

    When the specimen was immersed in 25 ° C water for 1 ~ 5 d , the bending failure load did not change with the time , but it is obviously lower than that under the dry and room temperature condition .

  17. 研究了干燥条件、纺丝温度、侧吹风的调节及后加工设备维护等对DTY染色均匀性的影响。

    The factors which influence the dyeing evenness of polyester filaments including drying technology , spinning temperature , controling of the lateral blow and servicing of the after-treatment machines are studied .

  18. 本研究从发酵肉中分离鉴定了可作为发酵剂的乳酸菌小片球菌M7,并对其发酵条件(包括5L罐放大试验)、冷冻干燥条件、浓缩培养、菌株安全性等方面进行了研究。

    Lactic acid bacteria Pediococcus parvus M7 was isolated and identified from the fermented meat , and the optimal conditions for fermentation , freeze - drying and concentrated culture were studied .

  19. 最佳干燥条件是60℃下干燥15h左右,使话梅糕的水分含量控制在21.5%之间。

    The optimum drying condition was 60 ℃ for about 15 hours , so that the moisture content of the pudding could be controlled around 21.5 % .

  20. 对花生分离蛋白成膜特性的研究表明:花生分离蛋白经适当的碱处理和热处理可以改善其成膜特性,成膜溶液的浓度和干燥条件宜控制为6%和65℃、1.5h。

    The results showed that Alkali and heating treatment on PPI could promote the film forming , PPI concentration and drying condition should be 6 % and 65 ℃ / 1.5h respectively .

  21. 不同干燥条件对苦瓜中酚类物质含量及其抗氧化能力的影响:分别采用热风干燥和真空干燥在70℃条件下对苦瓜进行干燥处理5h,10h,15h,20h,25h。

    Different drying methods and heating time on the content of phenolic compounds in bitter melon and antioxidant activity : The bitter melon was treated with hot air drying and vacuum drying at 70 ℃ for 5-25 hours .

  22. 采用水溶性铜防腐剂(ACQ)和铜唑类防腐剂(CuAz)加压浸注处理臭冷杉木材,研究了药液处理浓度和后期干燥条件对木材抗弯弹性模量和抗弯强度的影响。

    Two kinds of waterborne preservatives , Ammoniacal Copper Quaternary ( ACQ ) and Copper Triazole ( CuAz ), were used to treat Siberian White Fir ( Abies nephrolepis ) logs by pressure impregnation .

  23. 在试验中,该机在一定干燥条件下,可将煤中水分从20%降至0.5%,蒸发速率达到22kg/(m~2·h),为其工业应用奠定了可靠的理论与实验基础。

    During the test , under the certain condition , the prototype can reduces the coal moisture from 20 % to 0 . 5 % , the evaporate rate up to 22kg / ( m2 . h ), laying a solid and reliable foundation for its industrialization .

  24. 鱼面适宜的干燥条件为:前期干燥温度80℃、相对湿度60%、干燥时间30min,随后转入降温降湿干燥阶段,干燥时间约40min,产品最终含水量10.7%。

    The optimum drying conditions were temperature 80 ℃, relative humidity 60 % , drying time 30 minutes , followed by the low temperature and low humidity drying for 40 minutes . The final moisture content of product is 10.7 % .

  25. 通过改进干燥条件提高重质纯碱的白度

    Improving the Whiteness of Dense Soda Ash by Changing Drying Condition

  26. 黄芩袋泡剂最佳干燥条件的选择

    The Best Drying Condition on Scutellaria Baicalensis Georgi Soak Tea Agent

  27. 干燥条件对啤酒麦芽品质影响的研究

    The Study on the Effect of Malt Quality on Drying Conditions

  28. 超高分子量聚丙烯酰胺水解干燥条件的研究

    Studies on Hydrolysis and Drying Conditions of Ultrahigh Molecular Weight Polyacrylamide

  29. 干燥条件对小径桦木干缩性能的影响

    Effect of Drying Condition on Shrinkage of Small Diameter Birch Logs

  30. 单面干燥条件下混凝土的收缩变形分布特征

    Shrinkage distribution of concrete with one surface exposed to dry condition