层流式

粉针T800/H2/C3型层流式隧道消毒灭菌验证

Test and Verification of Sterilization by Model T800 / H2 / C3 Laminar Flow Tunnel for Powder Injection

目的确认T800/H2/C3型层流式隧道消毒灭菌的性能，供生产使用。

Objective To confirm the sterilization property of model T800 / H2 / C3 laminar flow tunnel for production .

目的调试T800/H2/C3型层流式隧道机械设备，确认其机械性能。

Objective To adjust the mechanical instrument of Model T800 / H2 / C3 laminar flow tunnel so as to determine its function .

以上各项性能参数均符合《T800/H2/C3型层流式隧道验证方案》要求。

All the above parameters conformed to the requirements of the test and verification scheme tor model T800 / H2 / C3 laminar flow tunnel .

结论确定T800/H2/C3型层流式隧道验证合格，可以发证使用。

Conclusion Model T800 / H2 / C3 laminar flow tunnel passes the test and verification so it can get the approval to be used .

方法在层流式隧道满载运行时，测定其热渗透及消毒灭菌、除热原效力。

Methods Measure the efficiency of removing pyrogen by heat permeation through sterilization with model T800 / H2 / C3 laminar flow tunnel while it was fully loaded .

进隧道口的抗生素玻璃瓶初始微生物、清洁度及其灭菌效果等检查均符合《T800/H2/C3型层流式隧道验证方案》规定。

The air cleanness degree reached 100.Initial microorganisms , cleanness degree and sterilization effects by antibiotic glass bottle at the entrance of the tunnel met the demands of the Test and Verification Scheme of Model T800 / H2 / C3 Laminar Flow Tunnel .

层流时管式反应器中变粘度问题研究

Studies on Variable - viscosity Problem of a Tubular in Laminar

介绍层流区桨式、锚式、双螺带式搅拌桨功率的计算；

Introduces the power calculation of paddle type , anchor type and double screw type agitating paddler in laminar flow area ;

在GAMBIT中建立模拟动静压阶梯腔轴承内部三维流动的数学模型及边界条件，并利用FLUENT软件，选用层流模型，分离式求解器对轴承的压力分布和温度分布进行求解。

The model and boundary conditions of hybrid bearings was established to simulating hybrid bearings ' internal three-dimensional flow in the GAMBIT software . And in FLUENT software , laminar model and separate solver was chosen , pressure distribution and temperature distribution were computed .