夹心板
- 网络sandwich panel;Sandwich;plywood
-
简要介绍了聚氨酯胶粘剂在彩钢板/聚苯乙烯夹心板生产中的应用、采用双组分无溶剂发泡型聚氨酯胶粘剂生产夹心板的工艺。
The application and process of using two component foaming type polyurethane adhesive with solventless in color steel / polystyrene sandwich panel were briefly introduced .
-
本文作者通过一工程实例,介绍了蒸压加气砼小型砌块、彩钢夹心板在直接加层工程中的应用及采取的施工技术措施。
This article describes the use and construction technology for small block of steam pressed aerated concrete and sandwich panel used in direct storey increasing project .
-
介绍了意大利ALP风管系统,该系统由铝箔聚氨酯夹心板制成的复合风管、特种系统附件、管道连接件及固定件组成。
Presents an introduction to Italian ALP air duct system .
-
制备了一系列三明治式聚氨酯(PU)泡沫夹心板,研究了聚氨酯泡沫的组成和结构与频率响应特性之间的关系。
A series of classical sandwich composite panels composed of polyurethane ( PU ) foam core and epoxy laminate or paper panel skin were prepared .
-
彩色夹心板在噪声治理中的应用
The application of colored sandwich steel plate in noise control
-
铝合金夹心板结构极限承载能力有限元分析
Finite element analysis on ultimate strength of an aluminum alloy sandwich panel
-
泡沫铝夹心板芯层泡沫结构的研究
Study on the foaming structure of sandwich layer of aluminum foam sandwich
-
轧制复合-粉末冶金发泡工艺制备泡沫铝夹心板
Preparing Aluminum Foam Sandwich by the Roll-bonding-powder Metallurgy Foaming Technique
-
泡沫铝夹心板轧制预制坯的粉末冶金发泡工艺
Powder Metallurgy-Foaming Process of Rolled Precursor for Aluminum Foam Sandwich
-
钢丝网架水泥夹心板隔墙施工技术规程
Technical specification for construction of partition with steel mesh cement sandwich panel
-
大挠度复合夹心板弯曲问题的半解析有限元法
Semi-Analysis Finite Element Method for the Composite Material Sandwich Plates with Large Deflections
-
聚氨酯泡沫夹心板的结构与频率响应特性
The relationship between structure of polyurethane foam sandwich panels and the frequency response
-
房屋加层中钢丝网架夹心板的应用及设计
Application and design for steel wire mesh reinforced panel in overbuilding story constructions
-
基于振动特性的点阵桁架夹心板损伤检测数值模拟
Numerical Simulation on Damage Identification Using Vibration Signals for Lattice Truss Sandwich Plate
-
轧制复合法制备泡沫铝夹心板发泡预制坯
Preparation of Aluminum Foam Sandwich Perform by Roll-bonding Process
-
浅述新型环保绿色空调风管&酚醛铝箔复合夹心板风管
On Newly Environmental Green Air-conditioning Pipe-Integrated Hydroxybenzene , Aldehyde with Aluminum foil board Pipe
-
研究了基于振动特性的点阵桁架夹心板损伤识别。
A numerical study for vibration based lattice truss structural damage identification was presented .
-
洁净负压实验室彩钢夹心板围护结构安装技术
Erection technology for colored steel sandwich panel enclosure structure of purified negative pressure laboratory
-
泡沫铝芯夹心板的制备及泡沫孔的研究
Preparation of Aluminum Foam Sandwich and Foam Cell
-
间歇法夹心板聚氨酯泡沫芯气泡成因分析
The Genetic Analysis of the Cavities on Polyurethane Foam Core of Discontinuous Sandwich Panel
-
此外,也可以提供上等木质覆层的夹心板。
Also available with a prime-quality wood cladding .
-
泡沫铝夹心板的制备及其界面结合机理的研究
Research on preparation of aluminum foam sandwich and steel plate / foam core interfacial microstructure
-
变厚度智能硬夹心板振动分析
Vibration analysis of smart changed hard-sandwich plate
-
观察夹心板修复体恢复牙齿形态功能与维护牙龈健康的效果。
Objective : To investigate effect of sandwich restoration on repairing tooth deface and preserving the gingival .
-
上前牙唇夹心板修复体美学效果的临床观察
The clinical observation on the aesthetics effect of sandwich restoration on labial surface of upper front teeth
-
钢丝网架聚苯乙烯夹心板是一种性能优良的轻质墙体材料,具有诸多优点。
The plate made of wire gauze with polystyrene is a good lightweight wallboard material with many merits .
-
内有蜂窝夹心板,外包铝质覆层,乃是坚固性与质地轻盈之完美结合,又使冷热合为一体。
A honeycomb sandwich panel inside and an aluminum cladding outside for the ideal combination of solidity and lightness , coldness and heat .
-
现存的泡沫铝夹心板的制备方法很多,但均为先制备芯材再进行连接的方法。
There are lots of manufacture methods , but all these methods are to prepare core material first and then join them to skins .
-
主体框架采用钢结构形式,梁柱节点采用半刚性端板连接,节能复合墙板采用预制钢丝网架混凝土夹心板。
The main structure adopts steel frame , beam-column connection adopts semi-rigid end-plate form . Composite panel adopts prefabricated concrete sandwich panel with steel truss .
-
研究结果表明:蜂窝孔迳增大,夹心板灵敏度增加,频宽变窄;
The results show that the sensitivity of the sandwich panels increases and the frequency width minifies with increasing the cell size of the honeycomb .