增压发动机

  • 网络turbocharged engine;Turbo;Supercharged Engine;wastegate
增压发动机增压发动机
  1. 低压缩比高增压发动机最高有效压缩比最有用的压缩率

    High supercharged engine of low compression ratio highest useful compression ratio

  2. 机电联合控制LPG-柴油双燃料增压发动机的研究

    Study on LPG-Diesel Dual-Fuel Supercharged Engine with Machinery-Electron Control

  3. 其8.0升W字型矩形涡轮增压发动机和7速直接换挡变速器令人叹为观止。

    It is powered by a 8.0 L W16 quad-turbocharged engine and has a 7-speed DSG sequential gear box .

  4. 每分钟转速达18000转的V8发动机不见了,取而代之的是排量更小的V6涡轮增压发动机。

    Gone are the V8 engines that growled at 18000 revs per minute . They 've been replaced by smaller , turbocharged V6s .

  5. ISAD系统在增压发动机上的应用研究

    Research on ISAD System in Turbocharged Diesel Engine

  6. 瑞典汽车制造商科尼塞克的CCX于2006年日内瓦车展上面世,这辆双门跑车有着V字型8缸4.7升双级涡轮增压发动机和六挡手动变速,这些都是Cima特意为科尼塞克设计的。

    The CCX from the Swedish manufacturer was revealed in 2006 , at the Geneva Motor Show . This 2-door roadster has a 4.7 L twin-supercharged V8 engine and a six speed manual gearbox made specially for Koenigsegg by Cima .

  7. 菲亚特500L的引擎盖下的确有一台非常具有运动性能的小发动机:1.4升16气门4缸中冷式涡轮增压发动机,转速达到2500转/分钟时可以输出184磅英尺的强劲扭力。

    The 500L does have a pretty sporting little engine under the hood : an intercooled turbo , 1.4-liter , 16-valve four producing a goodly 184 foot-pounds of torque at 2,500 rpm .

  8. 符合或超过了性能要求的涡轮增压发动机。

    Meets or exceeds the performance requirement of turbo charged engine .

  9. 天然气增压发动机工作过程模拟分析研究

    Study and Simulation on Working Process of Supercharged CNG Engine

  10. 车用涡轮增压发动机进气谐振效应实验研究

    Studies of efficacy of induction resonant system for turbocharged vehicle diesel engine

  11. 增压发动机排气放气阀系统的计算机模拟

    Computer Simulation for Turbocharged Engines with Exhaust Waste Gate System

  12. 燃气轮机压缩机燃气涡轮压缩机低压缩比高增压发动机

    Gas turbine compressor high supercharged engine of low compression ratio

  13. 汽车多点增压发动机电控燃油喷射控制系统

    Vehicle Multipoint Turbocharged Engine Electronic Fuel Injection Controls System

  14. 我这辆浅白色测试车搭载增压发动机,厂商建议零售价为26950美元。

    My supercharged light white test car carried an MSRP of $ 26,950 .

  15. 涡轮增压发动机理想循环热效率的一种分析方法

    Calculation of Ideal Cycle Efficiency of Turbocharged Engine

  16. 涡轮增压发动机排温控制装置

    Control device of exhaust temperature for turbocharged engines

  17. 低压缩比高增压发动机

    High supercharged engine of low compression ratio

  18. 按照与自然进气发动机相同的方式拆下涡轮增压发动机的进气分配器。

    Remove intake-air distributor for turbo engines in the same way as for naturally aspirated engines .

  19. 旁通补燃系统改善柴油机外特性的仿真研究超高增压发动机补燃系统的研究

    Improvement Simulation of the Full-Load Characteristics of a Diesel Engine with the By-Pass and Auxiliary Combustion System

  20. 同时,还计算了涡轮增压发动机和自然吸气发动机的扭转振动,并讨论了两者之间的差别。

    The torsional vibrations for both turbocharged and naturally-aspirated engines are also calculated with their differences discussed .

  21. 近年来,增压发动机的变工况性能问题日益得到重视。

    The importance of a preliminary calculation of the performance of a turbo-charged engine can not be neglected .

  22. 本文以MATLAB/Simulink软件为开发平台,建立增压发动机动态排放预测模型。

    By using MATLAB / Simulink , this thesis built a dynamic emission prediction model of the turbocharged engine .

  23. 本文阐述计算机控制多点增压发动机燃油喷射系统的硬件、软件设计。

    This paper describes the hardware and software design for computer-controlled fuel injection system of the multipoint turbocharged engine .

  24. 实验结果对采用机械传动式压气机增压发动机的设计和制造亦有参考价值。

    The results are also valuable to the design and manufacturing of engines supercharged by a mechanical driven air compressor .

  25. 对涡轮增压发动机提供超卓保护,使发动机清洁顺畅,并延长发动机使用寿命。

    Provide the super eminent protection to the turbine supercharge engine , and makes the engine clean and smooth , lengthen engine service life ;

  26. 对新开发的中冷增压发动机曲轴进行了单拐弯曲疲劳试验和综合技术的研究,提出了安全性评估结果。

    The report is a bend fatigue test result for a new crank shaft research , based on which the safety of the crank shaft using has been fully evaluated .

  27. 为了提高和改进发动机的动力性、经济性和排放性,涡轮增压发动机已成为现代发动机的一个基本机型。

    In order to enhance and improve the power of the engine , economy of the engine and emissions of the engine , the turbocharged engine has become a basic model of the modern engine .

  28. 虽然,增压发动机改善了自然吸气发动机的综合性能,但是,普通涡轮增压发动机存在低速扭矩不足、加速响应滞后、低油耗运行区窄等缺陷,尤其是普通涡轮增压汽油机会出现爆震现象。

    The common turbocharged engine has some defects , for instance torque insufficiency at low speed , rev-up response lag and the narrow operating area of low oil consumption . In especial , the common turbocharged gasoline exists engine knock phenomenon .

  29. 基于电控调压器的稀燃增压CNG发动机开发

    Development of Turbocharged Lean-Burn CNG Engine Based on EPR

  30. 稀燃增压CNG发动机起动及怠速控制试验研究

    Control and Experiment of the Start and Idle of Lean-burn Natural Gas Engine