压力罐

论文详细描述了用压力罐进行浮标压载重量标定的方法，并通过一台浮标的压载实验给出浮标配重计算方法。

Also , a method of ballasting using high pressure tank is described in detail , and calculation of ballasting weight is explained by giving an example .

介绍了微机变频给水设备的几种结构型式和施工安装方法，并与传统压力罐供水设备进行比较，证明新设备具有应用推广价值。

This paper introduces several structure forms and construction installation method of computer transduce water works , compares it with the traditional pressure pot water works and proves the new works that has application and development value .

全自动软化水设备是采用美国阿图祖（AUTOTROL）公司全自动多通种控制阀及斯特洛（STRUCTURAL）公司树脂压力罐组成的自动软化水装置。

Automatic water softener adopts auto multi-channel control valve from AUTOTROL of US and auto water softener made up of resin pressure vessel of STRUCTURAL .

通过室温与高温拉伸试验及断口形貌的SEM分析，探讨了不同熔体处理对压力罐用铝材（简称铝原块）力学性能的影响规律。

The effect of melt treatment techniques on the mechanical properties of the aluminum sheet ( or called aluminum piece ) used for pressure cans is studied with aids of tensile testing at room or high temperatures and SEM analyses of the morphologies of tensile fracture .

试样在聚四氟乙烯压力罐内加HCl-H2O2于150℃浸出，用吸光度法测定汽车催化剂中贵金属元素（Pt、Pd、Rh）的含量。

The specimen was dissolved with HCl and H 2O 2 at 150 ℃ in a PTFE jar , the traces of precious metals ( Pt , Pd , Rh ) in automobile catalysts were determined by spectrophotometric method .

采用SEM、EDAX和TEM及选区电子衍射（SAED）等考察和分析探讨了经不同熔体处理的高成形性压力罐用铝材的铸态微观组织结构特征。

As-cast microstructure feature of Al sheet used for pressure can manufacture with high forming properties prepared by different melt-treatment technology was investigated and analyzed with the aids of SEM , EDAX , TEM and selected area electron diffraction ( SAED ), etc.

在35g松香，7.2mL丙烯酸加成反应体系中，微波辐照下常压反应90min，或在密闭压力罐中反应5min，反应基本完成。

The results show microwave irradiation can effectively accelerate the reaction , which completed within 90 min for open system or 5 min for the sealed system in the addition reaction system of 35 g rosin with 7.2 mL acrylic acid .

罐装牛肉时，压力罐的使用很重要。

The use of a pressure canner is vital when canning meat .

选择水压力罐和气稳压罐为实验对象。

A water vessel and a air vessel have been chosen as specimen .

抗水锤压力罐是一种有效的控制长距离输水管道停泵水锤的设施。

Air vessel is a quite effective device to prevent water hammer in long-distance water-supply pipelines .

压力罐消解原子荧光光谱法测定进口食品中的总汞

The Determination of Total Mercury in Imported Food Using High Pressure Digestion and Atomic Fluorescence Spectrometry

储罐空高计量基准点自动绝热压力罐式量热计

Ullage reference-point automated adiabatic bomb calorimeter

自动绝热压力罐式量热计温室的热源来自：热传导、辐射。

Automated adiabatic bomb calorimeter The heat sources of the greenhouse are heat exehange and thermal radiation .

本文的研究内容为抗水锤压力罐的优化设计和运行调试提供了参考依据，具有一定的理论及应用意义。

This research work is the theoretical reference to design and debug air vessel parameters in practical engineering .

退溶剂部分国内也已开始应用压力罐处理含硫气体。

In the solvent removal section , domestic refineries have also started using pressure tanks to treat sour gas .

结果表明，变形温度对压力罐用铝材的流变应力和软化率影响显著，随变形温度升高，流变应力明显降低，流变曲线表现出明显的稳态流变特征；

The experimental results show that both flow stress and the softening fraction Fs are influenced by deformation temperature remarkably .

水电站油压装置中油泵及压力罐的容量选择及配置

Study on the Selection and Scheme of Oil Pump and Oil-pressured Accumulators in Oil Pressure Supply System for Hydropower Station

压力罐部分采用新型研制的排气阀装置，清除了目前国内普通加压机容易出现的故障，特别减少了排气电磁阀的损坏；

By introducing newly developed exhaust valve device as pressure tank part to eliminate troubles , that present domestic normal pressurizer easily occur , especially .

在实际工程中，设计人员一般依据经验公式或相关图表选择压力罐的参数，而且通常要进行反复地试算。

It is a trial and error process that designers usually depend on empirical formulas and some graphs to choose air vessel parameters in practical engineering .

以水压力罐为实验对象，从不同的探头间距以及不同的压力容器罐体两个方面实验验证了基于反射纵波压力测量模型的正确性。

The experimental results validate the correctness of measurement model based on the reflected longitudinal wave from two aspects of different probe spacing and different pressure vessels .

本文采用反王水压力消解罐消解，原子吸收分光光度计测定了土壤标准物质和待测样品中Cu、Pb、Cr、Cd等元素的含量，并进行了加标回收试验。

In this study , concentrations of Cu , Pb , Cr , and Cd in soils and standard soil materials have been determined by AAS after the soils were digested using reverse aqua regia method in high-pressure pot .

齿啮式快开压力容器罐口法兰的精密切割

Accurate Cutting for Gear-matched Type Quick-open Flange on Pressure Vessel Opening

压力容器罐安全可靠性分析方法的比较

Comparison of a Few Methods of Safty Reliability Analysis for the Pressure Volume Pot

压力过滤罐滤料再生改造

Regeneration of Filter Material for Pressure Filter Tank

压力空气罐对火电厂补给水系统瞬态负压的防护研究

Protection Study Avoiding Transient Negative Pressure by Air Vessel of Thermal Power Station Pumping System

所设计的计算机程序能相当精确地计算固有频率、主振型和动力历程反应。例如：液面波高、各时刻的液动压力和罐壳位移。

A computer program has been developed to calculate natural frequencies principal modes of vibrations and dynamic response history with satisfactory accuracy .

在其它条件相同时，泵入10%稠油的方式的启动压力比罐中预热稠油的大很多，泵入方式约为罐入的3倍左右。

The restart pressure which pump heavy oil into pipe is much more higher than the way put heavy oil in tank and about three times at other same conditions . 2 .

时间和压力因素对拔罐罐斑颜色影响的初步观察

Effect of time and pressure factors on the cupping mark color

参考设计手册，对不同蒸汽出口压力下的闪蒸罐参数进行了计算，设计了整套系统的控制方案。

The parameters of flash can are calculated in different outlet pressure of steam , and operation method is designed for the system .