倾斜角

qīng xié jiǎo
  • angle of roll;bank angle;inclination;tilt
倾斜角倾斜角
倾斜角[qīng xié jiǎo]
  1. 借鉴模拟或试飞获得飞机绕飞行速度滚转且截获90°倾斜角所需时间TRC90的技术,设计数字仿真用的飞机扭转敏捷性机动动作及其相应的舵面操纵规律。

    By using foreign simulation and flight test technique for the time to roll and capture a 90 ° bank angle change , the fighter transitional agility maneuver and aileron control law for numerical calculation are designed .

  2. 在弓头倾斜检测系统中,采用Radon变换求取倾斜角,方法简单易行。

    The bow head inclination detection system uses Radon transformation in calculation gradient that is a simple method .

  3. 文中对其做了较为详细的分析研究,得出了水平机械煤仓V型底板倾斜角合理的取值范围是45~55°。

    The paper makes a detailed analysis and study , and puts out that the reasonable value range of the bevel angle of V form soleplate of the level mechanical coal storage is 45 °~ 55 ° .

  4. 观察功能锻炼与腰椎稳定性的关系,并分析原因。结果:(1)两组的腰椎曲度、前凸指数、骶骨倾斜角有明显统计学差异(P0.05)。

    Observation of functional exercise and the relationship between lumbar spine stability , and analyze causes . Result : ( 1 ) two groups of lumbar curvature , lordosis index , sacral inclination angle was statistically significant difference ( P0.05 ) .

  5. 建立了组合系统的数学模型,应用组合卡尔曼滤波技术,按18颗导航星的布置方案,应用GPS仿真器,在考虑飞机沿3°倾斜角下滑线进行着陆飞行时,对组合系统进行了计算机仿真。

    An integrating scheme has been presented , and the dynamic model is established with the application of Kalman filter technique . The simulation for the integrated system performance has been carried out , using a GPS simulator , considering a glide-slope inclination of 3 ?

  6. 嵌入式倾斜仪采用ARM7作为系统核心,配合高性能的加速度传感器,通过实时测量加速度实现倾斜角的监测。

    The embedded clinometer , which uses ARM7 as the operation core to cooperate with a high performance acceleration sensor , achieves measuring the angle by real-time monitoring the acceleration .

  7. X线片示BHLER角、Gissane角、距骨倾斜角、跟骨宽度及丘部高度基本恢复正常。

    Plain radiography showed that B hler angle , Gissane angle , talus inclining angle , width of calcaneus and height of calcaneal thalamus were restored to nearly normal .

  8. 使用惯量椭圆的方法进行求得倾斜角,与Hough变换的方法相比,抗干扰能力较强,更加适用于车牌图像的倾斜校正处理。

    Use the method of inertia ellipse to obtain the tilt angle . Compared with the Hough transform method , it has a stronger anti-interference ability , and it is more suitable for the image plate tilt correction .

  9. 结果:颈椎侧块的斜径线为(10.57±1.41)mm、其倾斜角为5.14°±0.82°,后表面中心点距椎动脉距离为(13.99±1.63)mm;

    Results : The obligue diameter and its obligue angle of lateral mass of cervical vertebrae was 10.57 ± 1.41 mm and 5.14 ± 0.82 degrees . The distance from the center point of the back surface of lateral mass to vertebral artery was 13.99 ± 1.63 mm .

  10. 以MOLA系统为例,采用LM非线性拟合算法,得到了不同目标倾斜角及阈值情况下,最优化高斯拟合波形与实际接收信号波形的误差。

    The difference between optimum fitting-waveforms and practical waveforms of MOLA return signal , with different target slope angle and threshold value , were obtained by using LM nonlinear algorithm .

  11. 结果表明:当上倾斜角为3.3°、小麦流层厚度为50mm时可获得理想的剂量分布和合理的剂量均匀度系数。

    The result indicated that vibration channel set in 3.3 ° upward and flow thickness as 50 mm led to a reasonable dose distribution and uniformity ratio .

  12. 应用应力圆将Rankine理论计算主动土压力的方法延伸至坡面具有倾斜角的粘性填土,得出主动土压力强度沿墙背呈非线性分布的规律。

    The method by circle of stress is used for calculating the active earth pressure extended to cohesive soil with a slope angle on Rankine 's theory . The distribution of earth pressure strength acted on wall is nonlinear .

  13. 论文的第四章策略研究属于第三部分,主要是探讨在武汉地区BIPV设计中,PV板角度(倾斜角、方位角)的最佳取值范围;PV阵列最适宜间距。

    Chapter IV Strategic Research papers belonging to the third part is mainly to explore the design of BIPV in the Wuhan area , PV panel angle ( tilt angle , azimuth angle ) is the best range ; PV array of the most appropriate spacing .

  14. 介绍了BESⅢ漂移室单元结构的设计和丝层安排,讨论了如何设置斜丝倾斜角,并通过对漂移时间与距离关系的模拟优化了漂移室丝层半径。

    Design of cell structure and layer arrangement of the BES ⅲ drift chamber are presented . The consideration of stereo angles is also discussed . In addition , the optimization of layer radius is performed based on the relation of time to distance .

  15. 对160例正常人及60例脊髓型颈椎病患者颈椎侧位X线片的颈椎椎体上下终板倾斜角及颈前柱高度进行了测量,旨在为AC-AFF的设计提供更为合理的数据。

    Part one : Iconographic measurement . For the sake of providing the rational data for designing the AC-AFF , 160 cases of normal persons and 60 cases of cervical spondylotic myelopathy ( CSM ) were included in this part .

  16. 当圆角半径、槽面倾斜角和粗糙度分别为1μm、1°和40nm时,相应产生的损耗为1.7dB、0.7dB和1dB。

    The numerical simulation results show that when the round corner radius , the deviation angle and the roughness are 1 μ m , 1 ° and 40 nm , the corresponding loss is 1.7 dB , 0.7 dB and 1 dB respectively .

  17. 建立了7075铝合金扭转复合微动的运行工况微动图(RCFM),发现随倾斜角的增大,7075铝合金的混合区和滑移区向小角位移幅值方向移动。

    Running condition fretting map ( RCFM ) of 7075 aluminum alloy was established , where the mixed fretting regime and the slip regime of 7075 aluminum alloy shift to the direction of lower angular displacement with the increase of tilt angle . 3 .

  18. 关节窝前、后斜面倾斜角;

    Angles of anterior slope and posterior slope of glenoid fossa ;

  19. 倾斜角从90°到30°。

    The inclination angles varied from 90 ° to 30 ° .

  20. 推导出倾斜角和方位角的数学模型。

    Mathematical model of inclined angle and inclined azimuth is deduced .

  21. 倾斜角(转炉),倾斜位置把转炉向一侧倾转后。

    Tilting position The converter is tipped on to its side .

  22. 这椅背向后倾斜更加舒适.倾斜角(转炉),倾斜位置

    The seat back is raked for extra comfort . tilting position

  23. 分析了模具过渡段倾斜角对成形的影响。

    The effect of the transitional angle of the die was analyzed .

  24. 磁流体倾斜角传感器的实验研究

    The Study and Experiment of the Magnetic Fluid Inclined Sensor

  25. 碳粒传声器倾斜角特性

    Positional response of carbon microphone directional frequency characteristic of microphone

  26. 倾斜角传感器的测量电路分析与软件设计

    Circuit Analysis and Software Design of an Obliquity Sensor Measurement

  27. 配光镜折射单元倾斜角的测量和拟合函数

    Measuring and Fitting Function of Inclination Angle of Refracting Component of Matched Mirror

  28. 对主控制器的输出加了限位,从而由对倾斜角的给定值调整来实现对位置的调节。

    In the method , the output of the main controller is limited .

  29. 具有大倾斜角的纤维桥联分析

    Analysis for Bridging of Fibers with Large Inclination Angle

  30. 倾斜角(转炉),倾斜位置锦屏一级发电机组转子支架斜元件分析

    Analysis of Rotor Bracket Slanting Element in Jinping First Stage Hydraulic Turbine Generator